The Capparis spinosa L. is a species has a great interest in the field of traditional medicine for its pharmacological properties with many bioactive compounds. Our study is aiming at the recovery of this species through a phytochemical analysis and an evaluation of antibacterial and antioxidant activities of leaves of Capparis spinosa L. collected from natural habitats within the region of Al-Jadriya, Baghdad, Iraq. Phytochemical investigation demonstrated the presence of flavonoids, phenols, alkaloids, tannins, and glycosides in the methanolic extract of leaves. The quantitative analysis of total phenolic contents is being performed by Folin-Ciocalteau method and expressed in terms of gallic acid equivalents. C. spinosa exhibited progressive phenolic content in methanolic extract which was 21.62, 24.81 and 29.54 mg/g in concentration 8, 10 and 12 mg/ml, respectively. The antioxidant activity is determined by the DPPH test, showed that the radical scavenging capacity (EC50) of methanolic extract was found to be (7.1 mg/ml), while the (EC50) of vitamin C and BHT was (1 and 1.4 mg/ml) respectively. The antibacterial activity evaluated against pathogenic strains such as Staphylococcus aureus, Klebsiella pneumoniae, Escherichia coli and Pseudomonas aeruginosa revealed the effectiveness of methanolic extract against the most tested isolates at 100 mg/ml while P. aeruginosa exhibited resistance against extract. Minimal inhibitory concentrations (MICs) results revealed the activity of methanolic extract against S. aureus at 75 mg/ml, while the MIC of P. aeruginosa reached to 250 mg/ml. On the basis of the above findings, it can be concluded that C. spinosa possesses obvious antioxidant and antimicrobial potential can be used as a natural medicinal agent.
Mixed ligands reaction of [2-[(3-hydroxyphenyl)diazinyl]-1,2-benzothiazol-3(2H)-one-1,1-dioxide] (H2L, primary ligand) and bipyridyl (secondary ligand) with salts of Cr(III), Mn(II), Fe(III), Co(II) and Ni(II) was performed. A series of air-stable complexes with distinctive octahedral moieties was created by equal molar ratio (1:1:1). The formation of these compounds was verified using detecting analysis techniques incorporating mass spectra, which validated the achieved geometries. Fourier transform infrared (FTIR) analysis demonstrated how the ligands (H2L and bipyridyl) are chelated as tridentate (ONO) and bidentate (NN) groups, respectively and the coordination with the metal ions. Thermal decomposition studies using pyrolysis (
... Show MoreA novel technique for nanoparticles with a chemical method and impact for resistance bacteria methicillin-resistant Staphylococcus aureus (MRSA), UV-visible analysis confirmed the by Fourier transform infrared spectroscopy (FT-IR) and Energy dispersive X-Ray (EDX), Scanning electron microscope (SEM) and X-ray diffraction pattern estimation antimicrobial excellent antibacterial activity against MRSA (with zone of inhibition of 11 ± 02 mm , 9 ± 01 mm,8 ± 03 mm and 7.5 ± 02 mm and 6.5 ± 02 mm) at different concentrations (0.5 ,0.25, 0.125, 0.0625, 0.03125) mg/ml while good activity was 16 ± 03 mm at 17 ± 02 mm zone at 0.25, 0.125 mg/mL, respectively. The increase in microorganism resistance to antibiotics a couple of have caused
... Show MoreEnvironmentally friendly copper oxide nanoparticles (CuO NPs) were prepared with a green synthesis route via Anchusa strigosa L. Flowers extract. These nanoparticles were further characterized by FTIR, XRD and SEM techniques. Removing of Gongo red from water was applied successfully by using synthesized CuO NPs which used as an adsorbent material. It was validated that the CuO NPs eliminate Congo red by means of adsorption, and the best efficiency of adsorption was gained at pH (3). The maximum adsorption capacity of CuO NPs for Congo red was observed at (35) mg/g. The equilibrium information for adsorption have been outfitted to the Langmuir, Freundlich, Temkin and Halsey adsorption isot
... Show MoreIn this study, functional and numerical response tests, which are important components in the selection of biological control agent, were carried out. In functional response trials, the amount of food consumed, attack rate (a) and handling time (Th) were calculated for each developmental period, depending on the number of preys given after 24 hours. The obtained results were evaluated with the Holling. In numerical response experiments, the development of the predator insect was examined depending on the number of preys given in certain numbers (5, 10, 20, 40 and 80) and the data were recorded. This phase of the trials continued until the individuals died. At this stage of the trials, the reproductive response of the p
... Show More