Preferred Language
Articles
/
ChYIGocBVTCNdQwC4zf2
Geological Model for Jeribe/Euphrates Formation, Tertiary Reservoir in Qaiyarah Oil Field, North of Iraq

Visualization of subsurface geology is mainly considered as the framework of the required structure to provide distribution of petrophysical properties. The geological model helps to understand the behavior of the fluid flow in the porous media that is affected by heterogeneity of the reservoir and helps in calculating the initial oil in place as well as selecting accurate new well location. In this study, a geological model is built for Qaiyarah field, tertiary reservoir, relying on well data from 48 wells, including the location of wells, formation tops and contour map. The structural model is constructed for the tertiary reservoir, which is an asymmetrical anticline consisting of two domes separated by a saddle. It is found that the three formations in the tertiary reservoir is composed of limestone and dolomitic limestone with very thin shale rims introduced only in the Dhiban Formation, which have the minimum thickness compared to the main other two formations those considered the main reservoir units. Upscaling from the software has been used to distribute and correlate between the logs and core data, which came very acceptable results to be used for distribution to the entire field. Both log analysis and core data have showed that the reservoir is clean formation, no volume of shale has considered in the STIIOP calculations with average water saturation calculated to be 31.5% and average porosity of approximately 22% with temperature gradient of 1.2 °F/100 ft. This comes up with Stock Tank Initial Oil in Place calculated to be 6.519*109.

Crossref
View Publication Preview PDF
Quick Preview PDF
Publication Date
Sun Dec 02 2012
Journal Name
Iraqi Journal Of Chemical And Petroleum Engineering
Estimation of the Rock Mechanical Properties Using Conventional Log Data in North Rumaila Field

Hydrocarbon production might cause changes in dynamic reservoir properties. Thus the consideration of the mechanical stability of a formation under different conditions of drilling or production is a very important issue, and basic mechanical properties of the formation should be determined. There is considerable evidence, gathered from laboratory measurements in the field of Rock Mechanics, showing a good correlation between intrinsic rock strength and the dynamic elastic constant determined from sonic-velocity and density measurements. The values of the mechanical properties determined from log data, such as the dynamic elastic constants derived from the measurement of the elastic wave velocities in the material, should be more accurate t

... Show More
Publication Date
Sun Dec 30 2012
Journal Name
Iraqi Journal Of Chemical And Petroleum Engineering
Estimation of the Rock Mechanical Properties Using Conventional Log Data in North Rumaila Field

Hydrocarbon production might cause changes in dynamic reservoir properties. Thus the consideration of the mechanical stability of a formation under different conditions of drilling or production is a very important issue, and basic mechanical properties of the formation should be determined.
There is considerable evidence, gathered from laboratory measurements in the field of Rock Mechanics, showing a good correlation between intrinsic rock strength and the dynamic elastic constant determined from sonic-velocity and density measurements.
The values of the mechanical properties determined from log data, such as the dynamic elastic constants derived from the measurement of the elastic wave velocities in the material, should be more a

... Show More
View Publication Preview PDF
Publication Date
Sun Feb 28 2021
Journal Name
Iraqi Geological Journal
Facies Analysis and Depositional Stages of The Albian-Aptian Succession in Balad Oil Field, Central Iraq

Carbonate-clastic succession which includes the Shu'aiba, Nahr Umr and Mauddud formations are representing a part of the Barremian-Aptian Sequence (Wasi'a Group). The present study includes three boreholes (Ba-1, 4 and 8) within the Balad Oil Field. The study area is located in central Iraq. This field represents a subsurface anticline with a northwest to southeast direction axis within the Mesopotamian Zone. Eight types of microfacies were recognized in the succession of the Mauddud and Shu’aiba formations. These microfacies represent shallow open marine, restricted and semi-restricted, reef - back reef, deep open marine and basinal depositional environments. While Nahr Umr Formation includes two successions, the first is the upp

... Show More
Scopus (6)
Crossref (1)
Scopus Crossref
View Publication Preview PDF
Publication Date
Tue Jan 30 2018
Journal Name
Iraqi Journal Of Science
hydrochemistry Evaluation of Groundwater Suitability for consumption in Yaychi area (Southwest Kirkuk city - North Iraq)

Groundwater suitability for consumption in the Yaychi area is determined by analyzing groundwater samples of 21 wells distributed in the area, for dry period which begin from May to October 2016 and wet period begin from October 2016 to May 2017. Results indicated that the temperature (T °C) have normal values and the
water of low alkaline and excessively mineralized, while most of these samples, for both periods, are slightly – brackish water. The mean ion concentrations for two periods indicates that all major and secondary ions are higher than water quality standards for drinking purposes according to World Health Organization (WQI) and
Iraqi Standard (IQS) except for K and Cl ions. The water in

... Show More
View Publication Preview PDF
Publication Date
Thu Dec 15 2022
Journal Name
Journal Of Petroleum Research And Studies
Selection of an Optimum Drilling Fluid Model to Enhance Mud Hydraulic System Using Neural Networks in Iraqi Oil Field

In drilling processes, the rheological properties pointed to the nature of the run-off and the composition of the drilling mud. Drilling mud performance can be assessed for solving the problems of the hole cleaning, fluid management, and hydraulics controls. The rheology factors are typically termed through the following parameters: Yield Point (Yp) and Plastic Viscosity (μp). The relation of (YP/ μp) is used for measuring of levelling for flow. High YP/ μp percentages are responsible for well cuttings transportation through laminar flow. The adequate values of (YP/ μp) are between 0 to 1 for the rheological models which used in drilling. This is what appeared in most of the models that were used in this study. The pressure loss

... Show More
Crossref
View Publication
Publication Date
Tue Feb 28 2023
Journal Name
Iraqi Journal Of Science
Applying Geoaccumulation Index and Enrichment Factor for Assessing Metal Contamination in the Sediments of Euphrates River, Iraq

The current study looked into heavy metal poisoning of the Euphrates river which runs from Al-Kifl to Kufa in Iraq. One of the goals of this research was to determine the pollution levels and the contamination sources. We looked at six heavy metal (Cd, Pb, Zn, Cr, Fe, and Mn) characteristics in sediment, taking samples from six sites along the Euphrates every season from March 2020 to January 2021. To assess pollution levels, three indices were chosen: enrichment factor (EF), geo-accumulation index (I-geo) and contamination factor (CF). According to EF, the Cd and Pb elements recorded considerable enrichment, very high enrichment and extremely high pollution at practically all sites in four seasons, while the remainder of the HMs recorde

... Show More
Crossref (1)
Scopus Crossref
View Publication Preview PDF
Publication Date
Mon Feb 04 2019
Journal Name
Journal Of The College Of Education For Women
North and north-eastern wind and its impact on the racial temperature and humidity in Iraq

The study area is witnessing divergence where I am North wind North East wind as we find that the north wind is getting replicated as we move from the south, The reason can be attributed to the nature of the surface of the region, with at least repeat this wind the northern region to the presence of mountain ranges, while we find that energizes the surface in the center and south helped to increase repeat this wind gusts, It also finds that the North wind East prevail in the northern region and least replicated as we move from the north to the south and to the fact that North stations are within blowing this wind sites for the circles near the display of high pressure located centers to the north-east, north and distancing itself from pa

... Show More
View Publication Preview PDF
Publication Date
Wed Feb 08 2023
Journal Name
Iraqi Journal Of Science
Heavy Metals Pollution Assessment of the Soil in the Northern Site of East Baghdad Oil Field, Iraq

Twenty four soil samples were collected from different sites in north sector of East Baghdad oil field, Iraq , and analyzed to assess the impact of urbanization and industrialization essential pollution. The soil samples were analyzed for heavy metals (As, Cd, Cr, Cu, Hg, Ni, Pb, and Zn) by using inductively coupled plasma–mass spectrometry (ICP-MS). Mean concentration of heavy metals in soil samples follows this pattern: Zn > Ni > Cr > Cu >Pb > As> Cd> Hg. The results show significant variations (lower and higher) in the concentrations of heavy metals compared with local and world studies, this variation is attributed to the natural anthropogenic sources. The pollution of studied soil was assessed using many soil

... Show More
View Publication Preview PDF
Publication Date
Tue Sep 25 2018
Journal Name
Iraqi Journal Of Science
Enhancement of Seismic reflectors by using VSP and Seismic Inversion in Sindbad oil field, south of Iraq

The purpose of this research is to enhance the methods of surface seismic data processing and interpretation operations by using the produced information of vertical seismic profile (measured velocity and corridor stack). Sindbad oil field (South of Iraq) is chosen to study goals and it's containing only one well with VSP survey (Snd2) that covering depth from Zubair to Sulaiy Formations and 2D seismic lines of Basrah Survey. The horizons were picked and used with low frequency contents from well data for the construction of low frequency model and it was used with high frequency of VSP to make the high frequency model that compensated to seismic main frequency through inversion process. Seismic inversion technique is performed on post s

... Show More
View Publication Preview PDF
Publication Date
Tue Sep 30 2014
Journal Name
Iraqi Journal Of Chemical And Petroleum Engineering
Analytical Model for Detection the Tilt in Originally Oil Water Contacts

Many carbonate reservoirs in the world show a tilted in originally oil-water contact (OOWC) which requires a special consideration in the selection of the capillary pressure curves and an understanding of reservoir fluids distribution while initializing the reservoir simulation models.
An analytical model for predicting the capillary pressure across the interface that separates two immiscible fluids was derived from reservoir pressure transient analysis. The model reflected the entire interaction between the reservoir-aquifer fluids and rock properties measured under downhole reservoir conditions.
This model retained the natural coupling of oil reservoirs with the aquifer zone and treated them as an explicit-region composite system

... Show More
View Publication Preview PDF