Visualization of subsurface geology is mainly considered as the framework of the required structure to provide distribution of petrophysical properties. The geological model helps to understand the behavior of the fluid flow in the porous media that is affected by heterogeneity of the reservoir and helps in calculating the initial oil in place as well as selecting accurate new well location. In this study, a geological model is built for Qaiyarah field, tertiary reservoir, relying on well data from 48 wells, including the location of wells, formation tops and contour map. The structural model is constructed for the tertiary reservoir, which is an asymmetrical anticline consisting of two domes separated by a saddle. It is found that the three formations in the tertiary reservoir is composed of limestone and dolomitic limestone with very thin shale rims introduced only in the Dhiban Formation, which have the minimum thickness compared to the main other two formations those considered the main reservoir units. Upscaling from the software has been used to distribute and correlate between the logs and core data, which came very acceptable results to be used for distribution to the entire field. Both log analysis and core data have showed that the reservoir is clean formation, no volume of shale has considered in the STIIOP calculations with average water saturation calculated to be 31.5% and average porosity of approximately 22% with temperature gradient of 1.2 °F/100 ft. This comes up with Stock Tank Initial Oil in Place calculated to be 6.519*109.
The demand on energy sources throughout the world have led to an increase in the production processes of crude oil which is considered to be the main source of energy, without considering the impact on the environment. The objective of this study is to evaluate the environmental impact of drilling processes and crude oil spillage on soil in the Rumaila oil field, Basra, Southern Iraq. An investigation was undertaken to determine the content of Polycyclic Aromatic Hydrocarbons (PAHs) and heavy metals in the soil. Ten soil samples were collected near oil wells and analyzed. The results showed a high concentration of PAHsin the soil, particularly (Acenaphthene, Fluorene, Anthracene, Fluoranthene and Pyrene) due to crude oil spillage. The he
... Show MoreThis study deals with the seismic reflection interpretation of Cretaceous Formations in Tuba oil field, southern Iraq, including structural and stratigraphic techniques. The study achieved by using Geofram , Geolog and Petrel software. The interpretation process, of 2-D seismic data and well logs have been used. Based on well logs and synthetic traces two horizons were identified and picked which are the tops of Mishrif and Zubair Formations. These horizons were followed over all the area in order to obtain their structural setting. Structural interpretation indicates that the Tuba oil field is an anticline structure as well as the presence of normal fault near Mishrif Formation trending NE-SW. Information from the wells appeared Mishrif
... Show MoreThe study deals with 3D seismic reflection in the central Iraq within Merjan oil field which is located approximately (130 km) to the southwest Baghdad and south of Razaza. The 3D seismic survey was interpreted; the results showed that the oil is found within Hartha Formation as stratigraphic traps and with the absence of structural traps. The major normal faults picked are trending N-S direction. There are also minor faults observed using the instantaneous phase and frequency sections, they proved the presence of the faults and showed that the ending of the Safawi reflector toward the north and northeast to the south and southeast and near the western border of fault because of the facies change in the area. The reflector shows a struct
... Show MoreThe current research deals with studying the petrophysical properties represented by the porosity and its distribution on the level of all units of the top and bottom of the Kirkuk Formation Group. The study area is located in Maysan province in the south-eastern part of Iraq in the Amara field. The Kirkuk Group was deposited in the Tertiary Age. The post-stack method using seismic inversion and creating a relationship between seismic data was accomplished using Hampson-Russel software at well Am-1 and Seismic lines Ama 20 and 30. The research results indicate high porosity values on top of the formation with a decrease in acoustic impedance (Z) and, therefore, a reduction in the density. At the same time, low porosity values were indica
... Show MoreThe cutting transport problem in the drilling operation is very complex because many parameters impact the process, which is nonlinearity interconnected. It is an important factor affecting time, cost and quality of the deviated and horizontal well. The main objective is to evaluate the influence of main drilling Parameters, rheological properties and cuttings that characterise lifting capacity through calculating the minimum flow rate required and cutting bed height and investigate these factors and how they influenced stuck pipe problems in deviated wells for Garraf oil field. The results obtained from simulations using Well Plan™ Software were showed that increasing viscosity depends on other conditions for an increase or dec
... Show MoreKirchhoff Time migration was applied in Pre and Post-Stack for 2D seismic survey for line AJ-99N, that is located in Ajeel oilfield in Salah Al-Din Governorate, Central Iraq. The process follows several accurate steps to reach the final time migration stage. The results of applied time migration give an accurate image for the Ajeel anticline reservoir and to improve the signal to noise ratio. Pre-Stack shows a clearer image for the structure in the study area, and the time-frequency analysis insure the result.
Five subsurface sections and a large number of thin sections of the Hartha Formation (age Late Campanian – Early Maastrichtian) were studied to unravel the depositional facies and environments. The Hartha Formation is important as an oil reservoir in Iraq.
Petrographic and microfacies analysis of selected wells from Balad and East Baghdad oil fields in Central Iraq, enable the recognition of three main Sedimentary paleoenvironments. These are restricted marine, the shallow open marine environment within the inner ramp, deep outer ramp.
The studied Formation represents by two asymmetrical cycles bounded below by sequence boundary (SB1) the contact between Hartha and Saadi Formations. The deep outer ramp facies of
... Show MoreThe Yamama Formation represents a part of the Late Berriasian-Aptian sequence, deposited during the Early Cretaceous period within the main shallow marine depositional environment. The studied area covers three oil fields; Sindbad oil field, Halfaya and Ad'daimah oil field, located in southeastern Iraq. Six major microfacies were recognized in the succession of the studied area represented by the Yamama Formation to determine and recognize depositional paleoenvironments. These microfacies are; Peloidal Packstone, Algal Wackestone to Packstone, Bioclastic Wackestone – Packstone, Foraminiferal Bioclastic Wackstone, Packstone, Peloidal – Oolitic Grainstone and Mudstone Microfacies. These microfacies are classified int
... Show MoreThis paper concerns the study of ripples that occur on the windward of Barchan dunes from the dunes field of Najaf governorate, Iraq. These dunes consist mainly of sand sediments with variable sizes, including medium, fine, and very fine sands. Quartz represents the major light mineral in the Najaf Dunes sand. The prevailing wind direction in the study area is NW-SE. The major ripple crest series of every pattern are oriented perpendicular to the NW-SE wind direction, whereas imbricated ripple groups within the troughs of the preexisting ripples are created by the WSW-ENE wind trend. These ripples tend to be formed by shortened ripples that occupy the troughs of the prolonged series. All crests of the ladderback ripples are oriented at r
... Show More