The objective of this research is to study experimentally and theoretically the girder vertical load share of the curved I-Girder bridges subjected to the point load in addition to the self-weigh and supper imposed dead loads. The experimental program consist of manufacturing and testing the five simply supported bridge models was scaled down by (1/10) from a prototype of 30m central span. The models carriageway central radii are 30 m, 15m or 10m. The girder spacing of the first two models is 175 mm with an overall carriageway width of 650mm. The girder spacing of the other three bridge models is 200mm with the overall carriageway width of 700 mm. The overall depth of the composite section was 164 mm. To investigate the effect of live load position on the girder vertical load share a point load was applied at different load levels and was varied across bridge width. Experimental results show that the main factor effect on the girder load share were the point load position, load level and the bridge curvature value, while the girder spacing had a less effect than that. The ANSYS Worckbench 14.5 commercial software was adopted to build up the Finite Element model. Results have shown that the numerical model was slightly stiffer than the experimental test bridge model. A good agreement was obtained between the experimental and analytical results for all models, the maximum deviation in results reach to13% in such a single case, while the convergence results are the prevailing situation.
To develop a petrol engine so that it works under the bi-engine pattern (producer gas-petrol) without any additional engine modifications, a single-point injection method inside the intake manifold is a simple and inexpensive method. Still, it leads to poor mixing performance between the air and producer gas. This deficiency can cause unsatisfactory engine performance and high exhaust emissions. In order to improve the mixing inside the intake manifold, nine separate cases were modelled to evaluate the impact of the position and angle orientation inside the intake manifold on the uniformity and spread of the mixture under AFR=2.07. A petrol engine (1.6 L), the maximum engine speed (8000 rpm), and bi-engine mode (petrol-producer ga
... Show MoreTax fraud is following different methods of tax evasion (bypassing the laws, instructions and regulations related to tax) by not showing the real taxable income by using laws, instructions and regulations improperly, and because of the weak basic role of forensic accounting in detecting and reducing tax fraud, the problem has become more influential on the state general tax income. The main objective of the research is to identify forensic accounting and the extent to how it can be applied in the General Tax Authority to assist forensic authorities in issuing judgments in fraud cases. To achieve the objectives of the research, the descriptive analytical approach was used to reach the topic of the research, and a questionnaire (co
... Show More
There is poverty because of the difference in capacity and material resources, Previously poverty known on the basis of disparity between income and inadequate income. It realize later that fare wore effects of poverty is the erosion of human capital. The human poverty is the loss of food, education, health care and shelter.
In order to provide a database that target the poor , it have been propped a document on the features of poverty and the whereabouts of the poor and the rate of disparity between provinces.
Here the goal of the research is the identify the factors affecti
... Show MoreKriging, a geostatistical technique, has been used for many years to evaluate groundwater quality. The best estimation data for unsampled points were determined by using this method depending on measured variables for an area. The groundwater contaminants assessment worldwide was found through many kriging methods. The present paper shows a review of the most known methods of kriging that were used in estimating and mapping the groundwater quality. Indicator kriging, simple kriging, cokriging, ordinary kriging, disjunctive kriging and lognormal kriging are the most used techniques. In addition, the concept of the disjunctive kriging method was explained in this work to be easily understood.
After the fall of the Iraqi regime in the 9th of April 2003, and after the disintegration of the country, political and party political chaos that had never been witnessed before, has now taken over. In the past 2 years, the American military forces had a primary role in spreading this chaos and disorder by applying a set of wrong measures and policies. This chaos that is still affecting the iraqi people was completely ignored by the USA even 2 years after the occupation, no serious steps have been taken in order to bring back order and security, on the other hand, most of the government institutions and its forces were disintegrated, along with the decision made by Paul Bremer of dismissing all the iraqi journals and the workers of the
... Show MoreThis study identified intellectual and applied research in key variables (Strategic Control and Strategic Pitfalls) through internal dimensions then founded the (Federal Board of Supreme Audit) is the good area for analyzing the relationship and effect between variables by (125) questionnaire selected from (148) was distributed to the top and middle management as a seniors in controlling action. Appropriate methods, statistical tools, and programs were used to enhance the basic outputs, represented as a set of Conclusions and recommendations from the real control work with a specificity of potential Pitfalls in the effectiveness impact by Strategic Control in other dimensions which Studied.
Given a matrix, the Consecutive Ones Submatrix (C1S) problem which aims to find the permutation of columns that maximizes the number of columns having together only one block of consecutive ones in each row is considered here. A heuristic approach will be suggested to solve the problem. Also, the Consecutive Blocks Minimization (CBM) problem which is related to the consecutive ones submatrix will be considered. The new procedure is proposed to improve the column insertion approach. Then real world and random matrices from the set covering problem will be evaluated and computational results will be highlighted.