A two-dimensional computational study had been performed regarding aerodynamic forces and pressures affecting a cambered inverted airfoil, CLARK-Y smoothed with ground effects by solving the Reynolds-averaged Navier-Stokes equations, using the commercial software COMSOL Multiphysics 5.0 solver. Turbulence effects are modeled using the Menter shear-stress transport (SST) two-equation model. The negative lift (down-force), drag forces and pressures surface were predicted through the simulation of wings over inverted wings in different parameters namely; varying incidences i.e. angles of attack of the airfoils, varying the ride hide from the ground covering various force regions, two-dimensional cross-section of the inverted front wings to be fixed on nose of a race car- and varying speeds of initial airflow (Reynolds number). The results show that the down-force increases as the angle of attack increases; however, if an inverted wing is fixed on a car at high angles of attack the wing starts to stall which is not a desired condition that affects the vehicle stability and performance. As the ride height was reduced, the down-force was increased; at clearances between the suction surface and the ground of less than 0.2 of the chord length c, the down-force is significantly higher. Very close to the ground, at a ride height of less than 0.1c, down-force decreases as the wing stalls. Also, down-force increases as the free-stream velocity (Reynolds number) increases. The pressures for lower and upper surface of the wing increased with increasing both of angle of attack and ride height, but remains relatively ineffective with varying the speeds.
Complexes of some metal ions with 2-thiotolylurea were prepared in ethanolic medium using (1:1) (Metal : Ligand) ratio yielded series of neutral complexes as the general formula [M(L)Cl2]. The prepared complexes were identified by atomic absorption FT.IR, UV-Visble spectra, molar conductivity and magnetic properties. From the above data the tetrahedral structure was suggested for all complexes.
Linear discriminant analysis and logistic regression are the most widely used in multivariate statistical methods for analysis of data with categorical outcome variables .Both of them are appropriate for the development of linear classification models .linear discriminant analysis has been that the data of explanatory variables must be distributed multivariate normal distribution. While logistic regression no assumptions on the distribution of the explanatory data. Hence ,It is assumed that logistic regression is the more flexible and more robust method in case of violations of these assumptions.
In this paper we have been focus for the comparison between three forms for classification data belongs
... Show MoreIn this research we assumed that the number of emissions by time (𝑡) of radiation particles is distributed poisson distribution with parameter (𝑡), where < 0 is the intensity of radiation. We conclude that the time of the first emission is distributed exponentially with parameter 𝜃, while the time of the k-th emission (𝑘 = 2,3,4, … . . ) is gamma distributed with parameters (𝑘, 𝜃), we used a real data to show that the Bayes estimator 𝜃 ∗ for 𝜃 is more efficient than 𝜃̂, the maximum likelihood estimator for 𝜃 by using the derived variances of both estimators as a statistical indicator for efficiency
Trigeminal Neuralgia (TN) is one of the most commonly painful cranial neuralgia characterized by paroxysmal attacks as short lasting facial pain along the trigeminal nerve branches. The aim of the present study is to innovate a biochemical relationship between (melatonin, GALNT12 and Zn) and TN and also to examine the biochemical action of tegretol (carbamazepine) as a treatment on the above biochemical parameters. Blood samples were collected from fifty four (54) trigeminal neuralgia patients diagnosed by magnetic radiation image (MRI). Patients were classified into four groups: G3 (40- 70) years composed of (12) diagnosed male (without treatment), G4 (48- 75) years composed of (12) diagnosed female (without treatment), G5 (34- 76)
... Show MoreIn this research, the efficiency of low-cost unmodified wool fibers were used to remove zinc ion from industrial wastewater. Removal of zinc ion was achieved at 99.52% by using simple wool column. The experiment was carried out under varying conditions of (2h) contact time, metal ion concentration (50mg/l), wool fibers quantity to treated water (70g/l), pH(7) & acid concentration (0.05M). The aim of this method is to use a high sensitive, available & cheep natural material which applied successfully for industrial wastewater& synthetic water, where zinc ion concentration was reduced from (14.6mg/l) to (0.07mg/l) & consequently the hazardous effect of contamination was minimized.
Six species of aquatic snails were sorted from three sites, the irrigation canal of Baghdad University campus (S1), River Tigris at Al-Za'afaraniah district / Baghdad(S2) , and River Euphrates at Al-Haideriah district Al-Najaf province(S2). The species included Melanopsis nodosa ;Melanoides tuberculata ; Thaiodaxsas jordani ; Lymnaea auricularia ; Physa acuta and Bellamya bengalensis. The first specis recorded the highest total number and was found in high density in the R. Euphrates site (S3), while the last species was the most widely distributed species, and found in all study sites. The last three species were found in Tigris river (S2) , while the first and last species were collected from the irrigation canal (S1).The result reveal
... Show MoreIn this work, CdS/TiO2 nanotubes composite nanofilms were successfully synthesized via electrodeposition technique. TiO2 titania nanotube arrays (NTAs) are commonly used in photoelectrochemical cells as the photoelectrode due to their high surface area, excellent charge transfer between interfaces and fewer interfacial grain boundaries. The anodization technique of titanium foil was used to prepare TiO2 NTAs photoelectrode. The concentration of CdCl2 played an important role in the formation of CdS nanoparticles. Field emission scanning electron microscopy (FESEM) shows that the CdS nanoparticles were well deposited onto the outer and inner of nanotube at 40 mM of CdCl2. X-ray diffraction (XRD) and energy dispersive X-ray (EDX) analyses wer
... Show MoreHeat transfer process and fluid flow in a solar chimney used for natural ventilation are investigated numerically in the present work. Solar chimney was tested by selecting different positions of absorber namely: at the back side, front side, and at the middle of the air gap. CFD analysis based on finite volume method is used to predict the thermal performance, and air flow in two dimensional solar chimney under unsteady state condition, to identify the effect of different parameters such as solar radiation. Results show that a solar chimney with absorber at the middle of the air gap gives better ventilation performance. A comparison between the numerical and previous experimental results shows fair agreement.