Geomechanical modelling and simulation are introduced to accurately determine the combined effects of hydrocarbon production and changes in rock properties due to geomechanical effects. The reservoir geomechanical model is concerned with stress-related issues and rock failure in compression, shear, and tension induced by reservoir pore pressure changes due to reservoir depletion. In this paper, a rock mechanical model is constructed in geomechanical mode, and reservoir geomechanics simulations are run for a carbonate gas reservoir. The study begins with assessment of the data, construction of 1D rock mechanical models along the well trajectory, the generation of a 3D mechanical earth model, and running a 4D geomechanical simulation using a two-way coupling simulation method, followed by results analysis. A dual porosity/permeability model is coupled with a 3D geomechanical model, and iterative two-way coupling simulation is performed to understand the changes in effective stress dynamics with the decrease in reservoir pressure due to production, and therefore to identify the changes in dual-continuum media conductivity to fluid flow and field ultimate recovery. The results of analysis show an observed effect on reservoir flow behaviour of a 4% decrease in gas ultimate recovery and considerable changes in matrix contribution and fracture properties, with the geomechanical effects on the matrix visibly decreasing the gas production potential, and the effect on the natural fracture contribution is limited on gas inflow. Generally, this could be due to slip flow of gas at the media walls of micro-extension fractures, and the flow contribution and fracture conductivity is quite sufficient for the volume that the matrixes feed the fractures. Also, the geomechanical simulation results show the stability of existing faults, emphasizing that the loading on the fault is too low to induce fault slip to create fracturing, and enhanced permeability provides efficient conduit for reservoir fluid flow in reservoirs characterized by natural fractures.
In this research the a-As flims have been prepared by thermal evaporation with thickness 250 nm and rata of deposition r_d(1.04nm/sec) as function to annealing temperature (373 and 473K), from XRD analysis we can see that the degree of crystalline increase with T_a, and I-V characteristic for dark and illumination shows that forward bias current varieties approximately exponentially with voltage bias. Also we found that the quality factor and saturation current dependence on annealing temperatures.
The Invar effect in 3D transition metal such as Ni and Mn, were prepared on a series composition of binary Ni1-xMnx system with x=0.3, 0.5, 0.8 by using powder metallurgy technique. In this work, the characterization of structural and thermal properties have been investigated experimentally by X-ray diffraction, thermal expansion coefficient and vibrating sample magnetometer (VSM) techniques. The results show that anonymously negative thermal expansion coefficient are changeable in the structure. The results were explained due to the instability relation between magnetic spins with lattice distortion on some of ferromagnetic metals.
Highly plastic soils exhibit unfavorited properties upon saturation, which produce different defects in engineering structures. Attempts were made by researchers to proffer solutions to these defects by experimenting in practical ways. This included various materials that could possibly improve the soil engineering properties and reduce environmental hazards. This paper investigates the strength behavior of highly plastic clay stabilized with brick dust. The brick dust contents were 10%, 20%, and 30% by dry weight of soil. A series of linear shrinkage and unconfined compression tests were carried out to study the effect of brick dust on the quantitative amount of shrinkage experienced by highly plastic clay and the undra
... Show MoreThis research deals with shedding light on the issue of the poor understanding of students of Islamic sciences colleges for the subject of modern sciences; their causes and treatment, and it started with an introduction and an introductory research; The general weakness of the level of students of colleges of Islamic sciences in this article, and I detailed these reasons that relate to: the curriculum, the teaching staff, and students, and then concluded it with proposals and recommendations that would address this weakness.
Cosmetic products must be safe for use by consumers , It is also regulated and required the legislation of countries all over the world . In this study out of 80 cosmetic products analyzed and 32.5% were found to be contaminated .Products such as mascara, lip pencil and eye pencil were analyzed . The contaminants including bacteria such as Staphylococcus aureus , Staphylocoocus epidermidis , Pseudomonas aeruginosa , Escherichia coli and Klebsiella pneumonia which were ranging in number from (103-104 ) C.F.U. /ml and fungi such as Penicillium spp. , <
... Show MoreThe current study included a detail morphological study of all parts of the two species of the genus Tropaeolum L. (Tropaeolumceae) cultivated in different gardens, the roots, stems, leaves, flowers and fruit were studied in detail, also the pollen grains were studied, and there are photographs for all that parts were putted. A specimens of that taxa were studied in some Iraqi herbaria. The study found that there are many characters were used in differentiation of two species under study.
A total of 228 domestic and wild animals, including sheep, goats, cows, buffaloes, camels, horses, donkeys, dogs, cats, wild hares, Asiatic jackals, and red foxes were examined for ixodid ticks in the central region of Iraq. Nine species of ixodid ticks belong to two genera namely Hyalomma anatolicum Koch, 1844, H. excavatum Koch, 1844, H. turanicum Pomerantsef, 1946, H. scupense Delpy, 1946, H. dromedarii Koch, 1844, H. schulzei Olenev, 1931, Rhipicephalus annulatus (Say, 1821), R. turanicus Pomerantsef & al., 1940 and R. leporis Pomerantsef, 1946 were recovered. Their distribution among hosts and infestation rates were di
... Show MoreObjectives: The study aims to assess the female adolescents’ risk-health behaviors, to identify their
determinants, to determine the association between the risk health behaviors and the stage of
adolescence for these females' demographic variable.
Methodology: A purposive sample of (268) female adolescents is selected from intermediate and
secondary schools in Baghdad City. These adolescents have presented the age of (14-19) year old and
divided into two groups of (14-16) year and (17-19) year. A questionnaire is constructed for the purpose
of the study, it is composed of (10) major parts, and the overall items, which are included in the
questionnaire, are (106) item. Reliability and validity of the questionnaire
Copper is a cheaper alternative to various noble metals with a range of potential applications in the field of nanoscience and nanotechnology. However, copper nanoparticles have major limitations, which include rapid oxidation on exposure to air. Therefore, alternative pathways have been developed to synthesize metal nanoparticles in the presence of polymers and surfactants as stabilizers, and to form coatings on the surface of nanoparticles. These surfactants and polymeric ligands are made from petrochemicals which are non- renewable. As fossil resources are limited, finding renewable and biodegradable alternative is promising.The study aimed at preparing, characterizing and evaluating the antibacterial properties of copper nanoparticle
... Show More