The piled raft is a geotechnical composite construction consisting of three elements: piles, raft and soil.
In the design of piled rafts, the load shared between the piles and the raft, and the piles are used up to a
load level that can be of the same order of magnitude as the bearing capacity of a comparable single
pile or even greater. Therefore, the piled raft foundation allows reduction of settlements in a very
economic way as compared to traditional foundation concepts.
This paper presents experimental study to investigate the behavior of piled raft system in sandy
soil. A small scale “prototype” model was tested in a sand box with load applied to the system through
a compression machine. The settlement was measured at the center of the raft, strain gages were used
to measure the strains and calculate the total load carried by piles. Four configurations of piles (2x1,
3x1, 2x2 and 3x2) were tested in the laboratory, in addition to rafts with different sizes. The effects of
pile length, pile diameter, and raft thickness on the load carrying capacity of the piled raft system are
included in the load-settlement presentation.
It was found that the percentage of the load carried by piles to the total applied load of the
groups (2x1, 3x1, 2x2, 3x2) with raft thickness of 5 mm, pile diameter of 9 mm, and pile length of 200
mm was 28% , 38% , 56% , 79% , respectively. The percent of the load carried by piles increases with
the increase of number of piles.
Streptococcus pluranimalium was first isolated in 1999. Recently, several case reports have been published that have revealed that S. pluranimalium can infect humans as well. The pathogenicity and pathophysiology of this pathogen is poorly studied and its characteristics are not well known. In this study, S. pluranimalium was first isolated and then identified from infants and children who suffered from upper respiratory infections. 90 samples were collected from nasopharyngeal cavity. Among them, 83 Streptococcus spp. isolates were identified. 3 out of which were biochemically and molecularly identified as S. pluranimalium. 16S rRNA sequencing based identification revealed that all iso
... Show MoreThat any industrial company that must think about marketing mechanisms and who are the beneficiaries and the pursuit of gain customer satisfaction with access to competitive advantages. Most industrialized our companies from a variety of problems experienced both in the field of production, marketing, or keep up with new developments or commitment to quality standards, which caused the reluctance of customers to buy local products for various reasons, and especially in light of unplanned economic policy and exposure to market to imported products flooding the market with various goods and services that do not can the domestic industry rival, which has competitive advantages and meet business requirements, but others arrived to stop or as
... Show MoreAloin extracted into alcohol-rich phase with high extraction efficiency,
meanwhile majority polysaccharides, proteins, mineral substances and other
impurities were extracted into salt-rich phase. Partitioning of AQs[Anthraquinones]
is dependent on hydrophobic interaction, hydrogen bond interaction, and salting-out
effect in Aqueous tow –phase system [ATPS]. Aloin was partially purified by using
1-propanol [NH4] 2SO4, the use of this solvent showed high efficiency 90.61%
compared with other solvent [2-propanol and ethanol]. The concentration of aloin
detected by HPLC technique, which reached to 91.84% as focus turns out that there
is compatibility between the sample and the standard in shape and retention time
In this research, the study effect of additive titanium dioxide powder (TiO2) as a lone composite ( Ep+TiO2) and a mixture of (TiO2) and silicon oxide (SiO2), ( Ep+ TiO2+SiO2)as a hybrid composite on the mechanical and physical properties for epoxy coating. Thescompsiteswere prepared by (Hand Lay- the molding) method. The samples were tested for compressive strength, surface hardness, modulus of elasticity, thermal conductivity and diffusion coefficient, from the results obtained showed improvement in mechanical properties after adding ceramic powders, as the alone composite (EP+ TiO2) had the highest compressive strength ( 53.738 ) ᴍPa, the hybrid composite ( EP+TiO2 +SiO2 ) had the
... Show MoreGrapes and grape seeds are important samples employed for environmental medical studies . The air of this work was to identify and concentration calculation of the elements in grapes fruit and thier seeds by using X-Ray fluoresces technique (XRF) . Samples were collected from Abo Ghraib of Baghdad city ,the grape seeds were obtained from those samples . Both samples were taken under experimental procedure to obtain the sample which were ready for analysis . The samples were then submitted to experimental conditions using a radiation source and then samples were applied for counting analysis shows the elements Na , Mg , Al , Si , P , S , Cl , K , Ca , and Sr as major components of the samples. Fe , Sr , I , Ba and V were
... Show MoreThe quality of groundwater is just as important as its quantity. The kinds and concentration of salts in groundwater depend on the environment, movement, and the source of the groundwater. During the field work, 20 samples have been collected from water wells from Al-Salman basin for two seasons represent wet and dry seasons in November 2017 and April 2018. After water well samples have been analyzed the Electrical conductivity values range from (2260 to 5500) μS/cm for dry season and range from (2540 to 5630) μS/cm for wet season, the Total dissolved solids values range from (1289 to 3582) ppm for dry season and range from (1710 to 3960) ppm for wet season, and pH values range from (7.11 to 7.3) for dry and wet seasons. The Hydroc
... Show MoreThe study area of Baghdad region and nearby areas lies within the central part of the Mesopotamia plain. It covers about 5700 Km2. The remote sensing techniques are used in order to produce possible Land Use – Land Cover (LULC) map for Baghdad region and nearby areas depending on Landsat TM satellite image 2007. The classification procedure which was developed by USGS used and followed with field checking in 2010. Land Use-land cover digital map is created depending on maximum likelihood classifications (ML) of TM image using ERDAS 9.2.The LULC raster image is converted to vector structure, using Arc GIS 9.3 Program in order to create a digital LULC map. This study showed it is possible to produce a digital map of LULC and it can be co
... Show MoreThe aim of this study to determine the genetic distance and relationship among some Iraqi date palm cultivars by using the Random Amplified Polymorphic DNA (RAPD) technique. Molecular analysis was performed by using 10 random primers. These primers produced 176 fragment lines across 14 cultivars, Of these, 166 or 94.3% were polymorphic. The size of the amplified bands ranged between 200-2250 bp. The genetic polymorphism value of each primer was determined and ranged between 7.5-16.9%. In terms of unique banding patterns, the most characteristic banding pattern was for the Barhee cultivar with primer OP-M06 and for the Khadhrawy Mandily cultivar with primer OP-C02. Genetic distance values ranged from 0.868 to 0.125 among studied date palm
... Show More