Surface water flow samples were collected with distances downstream over Saqlawiya main drain whose stretch of about 24.5 km. The drain travels through different land use pattern, before, flowing into Tigris River. Eight sampling points were carefully
selected downstream the channel during dry season. The examined water parameters were pH, NH3, NO3, PO= 4, BOD5, COD, TDS, S.S, Cl-, SO= 4, Na+ , Ca+2, Mg+2, and Oil and Grease. Descriptive and inferential methods through finding the best curve fit correlation were employed in the study to test the strength of the association between water chemical characteristics and distance downstream the channel. A comparison of the values of chemical parameters at the Al-Saqlawiya Drain-Tigris River meeting shows that nine parameters (i.e. pH, NH3, NO3, PO= 4, BOD5, COD, TDS, S.S, and Oil and Grease) out of the 14 parameters under study decreased in
their concentration at meeting point. In a further analysis, predictive models were obtained through using six sampling points (0. 1, 3, 5,7, 8) and leaving three (2, 4, 6) as activation function. The percentage error for the calculated values of pH, NH3, BOD5, COD, TDS, Cl-.
SO= 4, Na+ and Mg+2 ranges from (0.54 to 15) % which demonstrate the high predictive capacity of the models. While the high values of the determination coefficient (r higher than 0.9) for NH3,NO3, BOD5, COD, SS, Cl-. SO= 4, Na+ , Mg+2 and Oil and grease, demonstrate a good model capacity relating water values and distances downstream Finally the paper concludes that artificial purification efforts at the water works should be directed towards controlling the concentration of Cl- , SO= 4, Na+ , Ca+2 , Mg+2 which increased with increases in distance downstream and suggests further research in the area of monitoring water quality.
Phonetics has close relevance with Musicology; in this study I decided explaining the interlinkages and harmony between Phonetics and Musicology. Linguists preceded philosophers in an attempt to link Phonetics with Musicology; the 1st serious attempt to link Phonetics with Musicology was done by Ibn Jeny (Dead 392 IC), but the real attempt is found with Farabi through his book under title Al Musiqa Al Kabeer, he defined music and link it with tune and relation between melody and tone, This is the same as pointed out by Ikhwan Al Safa who followed the doctrine of al-Farabi, their attention was with music and link it with phoneme, as they made music independent science, and they created special mathematics rules for it. Melody in music can
... Show MoreBackground: Most adult smokers start smoking regularly some time before 18 years of age. Cigarette smoking is a major ‘preventable’ cause of morbidity and mortality worldwide. It is well-known that smoking has hazardous effect on many systems like pulmonary and cardiovascular system.
Objectives: Study the prevalence of smoking among school pupils according to the mode of smoking, age, school grade, school environment and possible health risk associated with smoking. Type of the study: A cross-sectional study.
Methods: Study was conducted between 1st of March 2014 to 30th of May 2014 at Al-Doura/Al- Kurkh/Baghdad by using convenient sample, including all pupils from 6 schools. The schools were 2 secondary schools, 3 in
... Show More
In the Name of God, the Most Gracious, the Most Merciful
Praise be to God, who has revealed the book, in which there are clear verses, insight and remembrance for the first people, and he promised those who learned it and did it with great rewards, and prayers and peace be upon those who pronounced the right and separated the speech, and on his family and companions the best of family and companions, and who followed them and guided them to the day of Moab .... ..
And yet: If we ponder a brief period and look at our course at a glance, we will find that those who lead us are the prophets, and those who guide us are the guardians, and those who protect us are the martyrs, an
The research included making a bibliography of the jurisprudential books available in the reference section of the central library at the University of Al-Mustansiriya. From this research, and I also saw that one of its objectives was to classify these books scientifically according to what was included in the Contemporary Islamic Fiqh Library of sections that were classified on its basis, according to what has settled in the custom of contemporary jurists, and according to the researcher’s view and his humble diligence, so the research was organized into an introduction and three topics. Each topic contained approximately five demands that included the sections of the contemporary jurisprudential lib
... Show MoreThe paper deals with the study of the sciences of the Qur’an according to the interpreter, Ayatollah Sayyid Mahmoud al-Talaqani, a religious jihadist figure from Iran. He is the author of the exegesis (Ishraq from Al-Quran), which consists of six parts, which he wrote inside the prisons of the Shah and in exile. Mr. Al-Talaqani agreed with some of the commentators in his positions on the sciences of the Qur’an, and some of them disagreed with others.
Naidid worms were sorted from 27 samples of aquatic macrophyta including ceratophyllum demersum , Potamogeton crispus and, Hydrilla verticellat with associated filamentous algae were collected from Euphrates River at Al-Mussayab city, 60 Km southwest Baghdad. The result of sorted worms revealed the presence of eight species of subfamily Naidinae, which are consider as new records for Iraq, including Stephensoniana trivandrana; Paranais frici, Ophidonais serpentine, Specaria josinae, Dero (Dero) evelinae , Dero (Aulophorus) indicus , Nais pseudobtusa and finally N. stolci. This investigation includes morphological descriptions for each species illustrated by identification criteria photos.
(1)
The current research aims to identify the impact of ambidextrous leadership behaviors on organizational energy in Al-Faris Company. The descriptive analytical method was used as a research approach. Adept leadership includes two dimensions (open leadership behaviors and closed leadership behaviors), and organizational energy includes three dimensions (emotional energy, physical energy, and cognitive energy ). The research sample included all the administrative leaders (General Manager, Associate General manager, Department Manager, Division Official ) in AL-Faris Company / the Iraqi Ministry of Industry. The researcher distributed (74) valid questionna
... Show More
الأهداف: تهدف الدراسة إلى التعرف على مستوى نزاع العمل والأسرة لدى الممرضات في المستشفيات التعليمية في مدينة
الناصرية , تحديد العلاقة بين نزاع العمل والاسرة و عمر الممرضات في المستشفيات التعليمية في مدينة الناصرية.
منهجية البحث: تم إجراء دراسة ذات تصميم وصفيي في المستشفيات التعليمية بمدينة الناصرية خلال الفترة من 1 نوفمبر 2020 إلى 1 أبريل 2021 من أجل تحديد ا
... Show MoreThe present paper aims at evaluating the vailability quality and future horizons of potable water in the city of Shatra as a model. This is done in accordance with certain subjective and objective factors alongside the classification map of Shatra as a residential area. This system follows geographical studies specialized in urban construction. The problem of the present paper as well as the data approaching that problem have been chosen from the records of 2018. The researcher offered (919) questionnaire forms to be answered by a sample of dwellers in that area. Besides, the researcher also followed lab analysis of water samples collected from districts in the city of Shatra. GIS technology was also used to arrive at the real water shar
... Show More
Milling process is a common machining operation that is used in the manufacturing of complex surfaces. Machining-induced residual stresses (RS) have a great impact on the performance of machined components and the surface quality in face milling operations with parameter cutting. The properties of engineering material as well as structural components, specifically fatigue life, deformation, impact resistance, corrosion resistance, and brittle fracture, can all be significantly influenced by residual stresses. Accordingly, controlling the distribution of residual stresses is indeed important to protect the piece and avoid failure. Most of the previous works inspected the material properties, tool parameters, or cutting parameters, bu
... Show More
(2)
