The research work covers a study of the possibility of producing porous ceramic bodies
as a thermal insulators by adding fired Dechla kaolinite (grog)to the same non burned
kaolinite.
Different weight percentage ranged between (0,15,25,35and40)from grog and sawdust
passed through mesh 50 to Deuchla-clay kaolinit.Cylindrical shape samples (30mm diameter
and 30mm height) were prepared by the semi-dry methed,moulding pressure was 50 N/mm
2
.
After drying at 110
o
c,the samples were burnet in the furnace at temperatures
900,950,1000,1050,and 1100
o
c. The sawdust burnt out and leaves air spaces which contribute
to the high thermal insulation value.
The fired samples were investigated to determine bulk density , porosity, compressive
strength and the thermal conductivity .It was found that the increase of grog ratio produces a
decrease in bulk density ,compressive strength and thermal conductivity, but addition of
sawdust to the samples produces decrease greater than when addition the grog
The Isolated Combustion and Diluted Expansion (ICADE) internal combustion engine cycle combines the advantages of constant volume combustion of the Otto cycle with the high compression ratio of the Diesel cycle. This work studies the effect of isolated air mass (charge stratification) on the efficiency of the cycle; the analysis shows that the decrease of isolated air mass will increase the efficiency of the cycle and the large dilution air mass will quench all NOx forming reactions and reduce unburned hydrocarbons. Furthermore, the effect of Fuel / Air ratio on the efficiency shows that the increase of Fuel / Air ratio will increase efficiency of the cycle.
The main objective of this study is to understand the work of the pile caps made of lightweight aerated foam concrete and study the many factors affecting the ability and the capacity of the shear. The study was done by analyzing previous practical and theoretical experiences on the reinforced concrete pile caps. The previous practical results indicated that all specimens failed by shear diagonal compression or tension modes except one specimen that failed flexural-shear mode. Based on test specimens' practical results and behavior, some theoretical methods for estimating the ultimate strength of reinforced concrete pile caps have been recommended, some of which evolved into the design documents available on the subject.
... Show MoreIn this research, analytical study for simulating a Fabry-Perot bistable etalon (F-P cavity) filled with a dispersive optimized nonlinear optical material (Kerr type) such as semiconductors Indium Antimonide (InSb). An optimization procedure using reflective (~85%) InSb etalon (~50µm) thick is described. For this etalon with a (50 µm) spot diameter beam, the minimum switching power is (~0.078 mW) and switching time is (~150 ns), leading to a switching energy of (~11.77 pJ) for this device. Also, the main role played by the temperature to change the etalon characteristic from nonlinear to linear dynamics.
This study was carried out on 10 adult females of albino mice , aged 8 – 10 weeks and 24 – 27 gm weight . In addition to 10 males were used for mating in order to determine the effect of injection of bromocriptine on the early stages of pregnancy and this was observed by measuring the weights of some component of female reproduction . The animals were divided into groups
... Show MoreIn this research (100* 40* 4 cm) solar cell panel was used in Baghdad at autumn season (2010), to get best solar cell panel angles experimentally, and then a mirror (40*50 cm) is use to concentrate incident sunlight intensity on a panel. At first case we get (Tilt angle ?P =60°and Surface Azimuth angle ?P =36°E) is the best angles and other case, we add a mirror at angle = 120° at bottom of panel, then we get output power (27.48watt) is bigger than without using a mirror (25.16watt). We can benefit from these cases in variety applications.
In this paper, some estimators for the unknown shape parameter and reliability function of Basic Gompertz distribution have been obtained, such as Maximum likelihood estimator and Bayesian estimators under Precautionary loss function using Gamma prior and Jefferys prior. Monte-Carlo simulation is conducted to compare mean squared errors (MSE) for all these estimators for the shape parameter and integrated mean squared error (IMSE's) for comparing the performance of the Reliability estimators. Finally, the discussion is provided to illustrate the results that summarized in tables.
The genus Latrodectus Walckenaer, 1805 (Araneae: Theridiidae) is a worldwide distribute genus (Graudins et al., 2001), it includes a group of species commonly referred to as widow spiders. It's considered a taxonomically complex genus as the status of several forms had not been properly evaluated and specific boundaries are not well defined or understood (Levi, 1959; 1967; Garb et al., 2001), therefore, in multiple cases, populations has been uncritically referred to as different taxa. Discriminating between Latrodectus species using morphology has always been problematic (Levi, 1983), it is difficult taxonomically and readily separated from members of other Theridiid genera (Mirshamsi, 2005). The Genus Asagena Sundevall, 1833 was revalidat
... Show MoreThe relation between anemia and inflammatory immune response has lately had much attention. This research was conducted from October 2018 until April 2019, including (110) children below 12 years from both gender in some Hospitals, Primary Health care centers, Public Primary Schools and Kindergarten in Baghdad, Iraq. The objective of this study is to determine the possible correlation between iron deficiency anemia and inflammatory immune response among children infected with Entamoeba histolytica or Giardia lamblia. Blood samples were taken from all groups to measure hemoglobin level, serum iron, total iron binding capacity (TIBC), mean corpuscular volume (MCV), and mean corpuscular hemoglobin concentration
... Show More