To investigate the effect of chemical mutagens: sodium azide (SA), hydrazine hydrate (HZ) and maleic hydrazine (MH) on morphological variations of faba bean traits. Seeds were soaked in distilled water for six hours, then in different concentrations of the above mentioned mutagens (0.01, 0.03, 0.05%) represented by (C1,C2 and C3 respectively) for six hours and planted in the field in winter 2013-2014. Factorial Experiment was arranged in Randomized Complete Block Design (RCBD) with three replications to each treatment. The results of statistical analysis showed significant differences among studied treatments. All mutagens showed significant reduction in plan height and number of branches per plant compared with control plants which gave the highest plant height and number of branches per plant (117.55cm and 13.73 respectively). SA gave a significant decrement in plant height (103.95cm). HZ gave the longest day for 50% flowering (80.78 days), a significant increase in leaf area index (4.10), chlorophyll content (43.50) have been achieved. MH caused an earliness in flowering of treated plants (79.22days). C3 was superior in the leaf area index (4.07), chlorophyll content (44.79) and earliness in flowering (78.78 days), while C1 gave a longer period of 50% flowering ( 80.89 days). Significant differences also observed in the interaction between mutagens and concentrations. (MHXC3) gave a less period to 50% flowering (77 days) and showed superiority in leaf area index (5.07) and number of branches per plant (14.79). HZ x C1 mean while an increment in number of days to50% flowering (82.66 days) but HZ x C2 gave highest plant height resulted in reached (121.18cm), while (SAxC2) treatment yielded in lowest plant height (96.49) cm and (SAxC3) gave maximum chlorophyll content (47.93).
Water pollution is one of the global challenges that the society must address in the 21st century aiming to improve the water quality, reduce human pollutants and ecosystem health impacts. In phytotoxicity test, the plant of Iresine herbstii was exposed to remove nickel from simulated wastewater using two different ratios (mass of plant to the mass of nickel) (,Rp/Ni) for 21 days with sub-surface batch system. During the exposure period, the removal of Ni concentrations (2, 5 and 10 mg/L) for two mass ratio (2,800 and 34,000) were (83.6%, 77.2%, 78.0%) and (86.8%, 97% and 95.6%), respectively. final result of the rate was found that the highest removal occurred, 97%, at a mass ratio of 34,000 and
... Show More
The paper is concerned with, the behavior of the hydrostatic thrust bearings lubricated with liquid-solid lubricants using Einstein viscosity formula, and taking into account the centrifugal force resulting from high speed. Also studied is the effect of the bearing dimensions on the pressure, flow rate, load capacity, shear stress, power consumption and stiffness.
The theoretical results show an increase in load capacity by (8.3%) in the presence of solid graphite particles with concentration of (16%) by weight as compared with pure oil, with increasing shear stress. .
In general the performance of hydrostatic thrust bearings improve for load carrying capacity, volume flow rate,
... Show More An experimental and computational study is conducted to analyze the thermal performance of heat sinks and to pick up more profound information in this imperative field in the electronic cooling. One important approach to improve the heat transfer on the air-side of the heat exchanger is to adjust the fin geometry. Experiments are conducted to explore the impact of the changing of diverse operational and geometrical parameters on the heat sink thermal
performance. The working fluid used is air. Operational parameters includes: air Reynolds number (from 23597 to 3848.9) and heat flux (from 3954 to 38357 W/m
2 ). Conformational parameters includes: change the direction of air flow and the area of conduct
This paper deals with prediction the effect of soil remoulding (smear) on the ultimate bearing capacity of driven piles. The proposed method based on detecting the decrease in ultimate bearing capacity of the pile shaft (excluding the share of pile tip) after sliding downward. This was done via conducting an experimental study on three installed R.C piles in a sandy clayey silt soil. The piles were installed so that a gap space is left between its tip and the base of borehole. The piles were tested for ultimate bearing capacity
according to ASTM D1143 in three stages. Between each two stages the pile was jacked inside the borehole until a sliding of about 200mm is achieved to simulate the soil remoulding due to actual pile driving. T
The anatomical features of Agave americana L. leaf have been described, transverse sections of the leaf have been examined, the epidermis is single-layered on both surfaces, the stomata are sunken and mesophyll is (2-3) layers of parenchyma cells, vascular bundles are collateral type. The pollen of A. americana was studied. The observation was made with L.M. (Light microscope) and S.E.M. (Scanning electron microscope) to determine the significance of pollen features as taxonomic characters. The pollen was monades, homopolar, monosulcate, and with large size, subprolate in shape from P/E ratio (Polar axis/ Equatorial diameter) and furrow length and width, exine thickness and ornamentation.
Eleven species of parasitic insects were recovered from puparia of house fly Musca domestica L. developing in animal dung in Baghdad during 1985-1987. Of the parasites obtained, representatives were found in five families of Hymenoptera and one family of Coleoptera. The most prevalent parasites were Spalangia cameroni Perkins, S. nigroaenea Curtis and S. endius Walk. Average parasitism for the two year was 11.30 %, the highest number of parasitism occurred in May and October.
In this work, the extraction of glycyrrhizin from Licorice using bulk liquid membrane technique was developed and optimized. The effect of various parameters such as pH of stripping and donor solutions, temperature, stirring speed and kinetic parameters were investigated. Moreover, to study the impact of the polarity of membrane solvent, two types of extraction solvents were used as a membrane solvent: n-Hexane was used as a non-polar solvent and 1-Hexanol was as a polar solvent. The optimum extraction condition was found (95.53%) using 1-Hexanol, rotating speed was 400 rpm, and pH of the acceptor and donor solutions were 8 and 5.5, respectively. The reaction kinetics constants ( and ) for the transport of glycyrrhizin from the donor pha
... Show MoreThis paper is a part of a cytological studies of the genus Bromus L. in Iraq . Cl number for 103 specimens ropro^eming l^species determined . The course of meiosis including an analysis of chromosome configuradon for 27 collections belonging to 8 species were investigated . Meiosis was regular in most species . Tetraploid for B.scoparius L. (new cytotype ) and hexaploid ?'or " Kunth. were re^rted for the first time, cytological findings were supported the view of maintaining the closely related species B.danthoniae Trin. and B.lanceolatus Roth, as distinct species .
Plant regeneration protocols were developed for medicinally important anise (Pimpinella anisum L.) that successfully achieved from seeds. Seeds were sterilized and inoculated on Murashige and Skoog (MS) medium with and without gibberellins (GA3) until full germination. The highest percentage of germination (100%) was recorded on MS medium treated with 2.0 mg/L GA3 after 7 days. For shoot proliferation, different concentrations of 6- benzyl adenine BA (1, 1.5, 2 mg/L) were used. To enhance shoot induction, 0.1 mg/L of naphthalene acetic acid (NAA) and 0.01 mg/L of thidiazuron (TDZ) were tested along with BA. Direct regenerated shoots were obtained on MS medium supplemented with BA alone (2mg/L) which gave (7
... Show More