Euphorbia lateriflora is a popular traditional medicinal plant whose leaves are used in Africa, especially Nigeria, to treat wounds and many diseases. This study investigated the preliminary phytochemical constituents, secondary metabolites by High-Performance Liquid Chromatography “HPLC” technique, and antimicrobial potentials (Minimum Inhibitory Concentration “MIC”, Minimum Fungicidal Concentration “MFC” and disc diffusion assay) of various concentrations (100 mg/mL, 50 mg/ml, and 25 mg/mL) of the solvents (ethyl acetate and n-hexane) extracts of E. lateriflora against Staphylococcus aureus, Escherichia coli and Candida albicans. The phytochemical screening revealed that out of the thirteen constituents screened for, n-hexane extract contained seven components, including flavonoids, coumarin, steroid, glycosides, triterpenes, terpenoids, and alkaloids. In contrast, the ethyl acetate extract contains saponin, flavonoids, coumarin, steroid, glycosides, triterpenes, terpenoids, and alkaloids. The HPLC chromatogram of n-Hexane and ethyl acetate extracts of E. lateriflora detected numerous unidentified compounds along with a potential antimicrobial compound identified as caffeic acid. The low MIC (6.25 - 50 mg/mL), shown by the n-hexane extract signified a greater antimicrobial activity than ethyl acetate extract. This was further implicated by the varying concentrations levels, rather than the strain-dependent zone of inhibitions obtained. The highest diameter of zone of inhibition (14.23 mm) was obtained at 100 mg/mL by n-hexane extract against E. coli and S. aureus, respectively, while the lowest zone of inhibition (6.00 mm) was obtained by n-hexane at 25 mg/mL concentrated tested against S. aureus. However, the diameter of the zone of inhibition of Ciprofloxacin (50 mg/mL) ranged between 10-16 mm for E. coli and 6-10 mm for S. aureus. At the same time, 14.00 mm was obtained by itraconazole (antifungal agent) against C. albicans. Thus, this study shows that E. lateriflora harbors active compounds and supports the claim that its extract may be effective against infections caused by the test organisms, as practiced for years among rural dwellers in Nigeria.
The mineralogical study using X-ray diffraction (XRD) supported by scanning electron microscopic (SEM) examination and energy-dispersive spectroscopy (EDS) on the claystone of the Kolosh Formation from northern Iraq was conducted to Shows the provenance history of rocks. Chlorite, montmorillonite, illite, palygorskite, and kaolinite were recorded in different amounts in the study area. The association of montmorillonite and chlorite in the claystone of the Kolosh Formation (Paleocene) refers to the marine environment. Chlorite and montmorillonite are the common minerals in the Kolosh Formation with less common of illite, kaolinite and palygorskite. These clay minerals are of authigenic, detrital and diagenetically origin, which
... Show MoreBackground: The objective of this in vitro study was to evaluate the vertical marginal fit of crowns fabricated with ZrO2 CAD/CAM, before and after porcelain firing cycles and after glaze cycles. Materials and Methods: An acrylic resin model of a left maxillary first molar was prepared and duplicated to have Nickel-Chromium master die. Ten die stone dies were sent to the CAD/CAM (Amann Girrbach) for crowns fabrication. Marginal gaps along vertical planes were measured at four indentations at the (mid mesial, mid distal, mid buccal, mid palatal) before (Time 0) and after porcelain firing cycles (Time 1) and after glaze cycles (Time 2) using a light microscope at a magnification of ×100. One way ANOVA LSD tests were performed to determine wh
... Show MoreBackground: This study was aimed to investigate the effect of three lingual button (Nickel free / rectangular base, Nickel free / round base and Composite) and bonding environment, wet and dry enamel surface, on: the shear bond strength (SBS) of light and self-cured Resin Modified Glass Ionomer Cements, and the debonding failure sites. Materials and method: One hundred twenty no-carious, free of cracks maxillary first premolar teeth were selected. Three types of orthodontic lingual buttons were used in this study: Nickel free / rectangular base, Nickel free / round base and Composite buttons. The teeth were divided into two groups of sixty teeth each. One group was used for testing the chemically cured GC Fuji Ortho Resin modified Glass Io
... Show MoreThe research includes the synthesis and identification of the mixed ligands complexes of M(II) Ions in general composition [M(Lyn)2(phen)] Where L- lysine (C6H14N2O2) commonly abbreviated (LynH) as a primary ligand and 1,10-phenanthroline(C12H8N2) commonly abbreviated as "phen," as a secondary ligand . The ligands and the metal chlorides were brought in to reaction at room temperature in ethanol as solvent. The reaction required the following molar ratio [(1:1:2) (metal): phen:2 Lyn -] with M(II) ions, were M = Mn(II),Cu(II), Ni(II), Co(II), Fe(II) and Cd(II). Our research also includes studying the bio–activity of the some complexes prepared against pathogenic bacteria Escherichia coli(-),Staphylococcus(-) , Pseudomonas (-), Bacillus (-)
... Show MoreThe environmental contamination by the polycyclic aromatic hydrocarbons (PAHs) and heavy metals (Pb, Cu, Ni, Cr, and Cd) concentrations in the leaves of plant Eucalyptus camaldulensis were determined at the city of Kirkuk in 15 selected locations using GPS. The pickings up of samples were carried out in two periods October 2010 and March 2011. Compared with results of other studies, the concentration levels of determined heavy metals show values within these studies results. The average total concentration of polycyclic aromatic hydrocarbons (PAHs) in the leaves of Plant Eucalyptus camaldulensis indicated 37.1 ppb in October, while in March 165.2 ppb.
The mode
... Show MoreBackground: This study compared in vitro the marginal adaptation of three different, low shrink, direct posterior composites Filtekâ„¢ P60 (packable composite), Filtekâ„¢ P90 (Silorane-based composite) and Sonic fillâ„¢ (nanohybrid composite) at three different composite/enamel interface regions (occlusal, proximal and gingival regions) of a standardized Class II MO cavity after thermal changes and mechanical load cycling by scanning electron microscopy. Materials and methods:Thirty six sound human maxillary first premolars of approximately comparable sizes were divided into three main groups of (12 teeth) in each according to the type of restorative material that was used: group (A) the teeth were restored with Filtekâ„¢ P6
... Show MoreDespite their long successful use, synthetic dyes have several problems due to their carcinogenic and toxic effects. Besides providing bright colors, some natural pigments have shown notable antimicrobial activity; thus, they could be utilized as functional dyes in many applications such as making colored antimicrobial textiles. In this work, a yellow pigment produced by Streptomyces thinghirensis AF7 and has a notable antimicrobial activity was used to produce a colored antimicrobial textile. The extracted yellow pigment was subjected to a purification step using silica gel column eluted with di ethyl ether solvent. The FTIR, GC-MS and NMR analysis showed that the colorings in this type of product are due to t
... Show MoreBackground: Pit and fissure sealant have been considered an outstanding adjunct to oral health care in the decrease of occlusal caries onset and low progression. The aims of this in vitro study were to evaluate the marginal microleakage of three different types of fissure sealants (SDI, Tg and tetric N-flow) by time interval, one day and 45 days, in the presence or absence of bonding agent among maxillary and mandibular teeth. Materials and methods: Seventy two sound human maxillary and mandibular first premolar teeth were collected which were free from obvious carious lesions. The teeth were randomly divided into two main equal groups, group (1) and group (2), each group consists of (36) teeth involving equal numbers of maxillary and mandi
... Show MoreABSTRACT Background: Improving the properties of heat- cured and self-cured acrylic resin have been studied by many researchers. However, little studies concerned with visible light cured resin (VLCR) improved through addition of nanofiller are available. The purpose of this study was to evaluate some properties of (VLCR) after addition of SiO2 nanofiller. Materials and Methods: SiO2 nanofiller were added to (VLCR) tray material after being dissolved in tetrahydrofuran (THF) solvent. According to the pilot study 2% SiO2 nanofiller addition exhibited better properties than the other percentages (1%, 3%). The main study conducted involved (100) specimens divided into 5 groups according to the test included. (20) Specimens were selecte
... Show More