Euphorbia lateriflora is a popular traditional medicinal plant whose leaves are used in Africa, especially Nigeria, to treat wounds and many diseases. This study investigated the preliminary phytochemical constituents, secondary metabolites by High-Performance Liquid Chromatography “HPLC” technique, and antimicrobial potentials (Minimum Inhibitory Concentration “MIC”, Minimum Fungicidal Concentration “MFC” and disc diffusion assay) of various concentrations (100 mg/mL, 50 mg/ml, and 25 mg/mL) of the solvents (ethyl acetate and n-hexane) extracts of E. lateriflora against Staphylococcus aureus, Escherichia coli and Candida albicans. The phytochemical screening revealed that out of the thirteen constituents screened for, n-hexane extract contained seven components, including flavonoids, coumarin, steroid, glycosides, triterpenes, terpenoids, and alkaloids. In contrast, the ethyl acetate extract contains saponin, flavonoids, coumarin, steroid, glycosides, triterpenes, terpenoids, and alkaloids. The HPLC chromatogram of n-Hexane and ethyl acetate extracts of E. lateriflora detected numerous unidentified compounds along with a potential antimicrobial compound identified as caffeic acid. The low MIC (6.25 - 50 mg/mL), shown by the n-hexane extract signified a greater antimicrobial activity than ethyl acetate extract. This was further implicated by the varying concentrations levels, rather than the strain-dependent zone of inhibitions obtained. The highest diameter of zone of inhibition (14.23 mm) was obtained at 100 mg/mL by n-hexane extract against E. coli and S. aureus, respectively, while the lowest zone of inhibition (6.00 mm) was obtained by n-hexane at 25 mg/mL concentrated tested against S. aureus. However, the diameter of the zone of inhibition of Ciprofloxacin (50 mg/mL) ranged between 10-16 mm for E. coli and 6-10 mm for S. aureus. At the same time, 14.00 mm was obtained by itraconazole (antifungal agent) against C. albicans. Thus, this study shows that E. lateriflora harbors active compounds and supports the claim that its extract may be effective against infections caused by the test organisms, as practiced for years among rural dwellers in Nigeria.
new six mixed ligand complexes of some transition metal ions Manganese (II), Cobalt(II), Iron (II), Nickel (II) , and non transition metal ion zinc (II) And Cadmium(II) with L-valine (Val H ) as a primary ligand and Saccharin (HSac) as a secondary ligands have been prepared. All the prepared complexes have been characterized by molar conductance, magnetic susceptibility infrared, electronic spectral, Elemental microanalysis (C.H.N) and AA . The complexes with the formulas [M(Val)2(HSac)2] M= Mn (II) , Fe (II) , Co(II) ,Ni(II), Cu (II),Zn(II) and Cd(II) L- Val H= (C5H11NO2) , C7H5NO3S The study shows that these complexes have octahedral geometry; The metal complexes have been screened for their in microbiological activities against bacteria.
... Show MoreBackground: The aim of this study was to evaluate and compare the apical microleakage around retrograde cavities prepared with ultrasonic technique and filled with (Biodentineâ„¢) Materials and methods: 40 extracted single rooted human permanent maxillary teeth with mature apices were selected. The roots were prepared chemo-mechanically using k-files with crown-down technique and then obturated with lateral condensation gutta-percha technique. Teeth were divided into four main groups according to the cavity preparation method either manual or ultrasonic technique: Group A (n=10): A class I retrograde cavity at root end was prepared with traditional handpeice equipped and placement of Biodentine with manual condensation. Group B (n=10):
... Show MoreBackground: The aim of this study was to evaluate and compare the apical microleakage around retrograde cavities prepared with ultrasonic technique and filled with (Biodentineâ„¢) Materials and methods: 40 extracted single rooted human permanent maxillary teeth with mature apices were selected. The roots were prepared chemo-mechanically using k-files with crown-down technique and then obturated with lateral condensation gutta-percha technique. Teeth were divided into four main groups according to the cavity preparation method either manual or ultrasonic technique: Group A (n=10): A class I retrograde cavity at root end was prepared with traditional handpeice equipped and placement of Biodentine with manual condensation. Group B (n=10):
... Show MoreBackground: To evaluate the effect of antierosive agents (10% Nano-Hydroxyapatite (NHA), 10% Casein Phophopeptide-Amorphous Calcium Phosphate (CPP-ACP), and combination of 10% NHA and 10% CPP-ACP) on loss of minerals from enamel surface of permanent teeth treated with antierosive agents when exposed to an acidic beverage and investigate the morphological changes of treated enamel surface after demineralization with cola based beverage under Scanning Electron Microscope (SEM). Materials and Methods: Sixty maxillary first premolars were randomly divided into four groups, 15 teeth for each group. Group I treated with 10% NHA, Group II treated with 10% CPP-ACP, Group III treated with 10% NHA and 10% CPP-ACP, and Group IV did not treat with any
... Show MoreA new series of Fe (III) , Co (II) , Ni (II) and Cu (II) complexes of the Schiff base, 5 (2-hydroxy benzylidine) -2-thio ether -1, 3, 4-thiadiazole were prepared and characterized .The imine behaves as a bidentate. The nature of bonding and the stereochemistry of the complexes were deduced from metal analyses, infrared, electronic spectra,magnetic susceptibility and conductivity measurements, an octahedral geometry was suggested for all complexes except the copper complex has a square planar geometry .preliminary in vitro tests for antimicrobial activity show that all the prepared compounds except iron complex display good activity to gram positive Staphelococcus aures and gram negative Escherchia coli.
Evaluation of the Antibacterial Efficacy of Electrolyzed Oxidizing Water as an Irrigant against Enterococcus faecalis (An In vitro Study), Noor A Khait*, Muna Saleem Kalaf
Background: The marginal fit is the most characteristic that closely related to the longevity or success of a restoration, which is absolutely affected by the fabrication technique. The objective of present in vitro study was to evaluate the effect of four different CAD/CAM systems on the marginal fit of lithiµm disilicate all ceramic crowns. Materials and Methods: Adentoform tooth of a right mandibular first molar was prepared to receive all ceramic crown restoration with deep chamfer finishing line (1mm) and axial reduction convergence angle of 6 degree, dentoform model duplicated to have Nickel-Chromiµm master die. Thirty two stone dies produce from master die and distributed randomly in to four groups (8 dies for each group) accor
... Show MoreMushrooms have bioactive compounds that have antimicrobial, anti-cancer and antioxidant activities among other medicinal benefits. In the present study, we examined the anti-cell proliferation activities of mushrooms from eight genera obtained from the wild in Nigeria. Saccharomyces cerevisiae was used as a model organism to screen mushroom extracts for anti-cell proliferation activity. Polyphenols, high molecular weight polysaccharides and low molecular weight compounds from aqueous extracts were obtained from the test mushrooms using methanol and water respectively. The extracts were screened in vitro at different concentrations of extracts with the CyQuant cell proliferation assay. The high molecular
... Show MoreThe Neutron Fermi Age, t, and the neutron slowing down density, q (r, t) , have been measured for some materials such as Graphite and Iron by using gamma spectrometry system UCS-30 with NaI (Tl) detector. This technique was applied for Graphite and Iron materials by using Indium foils covered by Cadmium and the measurements done at the Indium resonance of 1.46 eV. These materials are exposed to a plane 241Am/Be neutron source with recent activity 38 mCi. The measurements of the Fermi Age were found to be t = 297 ± 21 cm2 for Graphite, t = 400 ± 28 cm2 for Iron. Neutron slowing down density was also calculated depending on the recent experimental t value and distance.