Gas compressibility factor or z-factor plays an important role in many engineering applications related to oil and gas exploration and production, such as gas production, gas metering, pipeline design, estimation of gas initially in place (GIIP), and ultimate recovery (UR) of gas from a reservoir. There are many z-factor correlations which are either derived from Equation of State or empirically based on certain observation through regression analysis. However, the results of the z-factor obtained from different correlations have high level of variance for the same gas sample under the same pressure and temperature. It is quite challenging to determine the most accurate correlation which provides accurate estimate for a range of pressures,

Background: Thalassemias are a group of heterogeneous genetic disorders, in which the rate of production of hemoglobin is partially or completely suppressed due to reduced rate of synthesis of α or β- chain

Objectives: to estimate the prevalence of Hepatitis C infection among B thalassemia patients attending Ibn-AL-Baladi center of blood diseases in AL-Sader city, in AL-Resafa Quarter of Baghdad and to determine the possible risk factors.

Type of the study: Cross- sectional study.

Methods: A cross sectional study conducted on B Thalassemia patients attending the blood diseases center in Ibn-AL-Baladi hospital during the period from 1^st

The removal of direct blue 71 dye from a prepared wastewater was studied employing batch electrocoagulation (EC) cell. The electrodes of aluminum were used. The influence of process variables which include initial pH (2.0-12.0), wastewater conductivity (0.8 -12.57) mS/cm , initial dye concentration (30 -210) mg/L, electrolysis time  (3-12) min, current density (10-50) mA/cm2   were studied in order to maximize the color removal from wastewater. Experimental results showed that the color removal yield increases with increasing pH until pH 6.0 after that it decreased with increasing pH. The color removal increased with increasing current density, wastewater conductivity, electrolysis time, and decreased with increasing the concen

The placement of buildings and structures on/or adjacent to slopes is possible, but this poses a danger to the structure due to failures that occur in slopes. Therefore, a solution or improvement should be determined for these issues of the collapse of the structure as a result of the failure of the slopes. A laboratory model has been built to test the impact of some variables on the bearing capacity factor. The variables include the magnitude of static axial load applied at the center of footing, the depth of embedment, the spacing between geogrid reinforcement layer and the numbering of the geogrid sheet under the footing, the inclination angle of slope clayey soil (β), the spacing between the footing's edge and the slope's end (b/H). Th

Resumen

                       Este trabajo de investigación ofrece uno de los temas relevantes en la lengua, el cual es estudiar las dimensiones sintácticas, semánticas y pragmáticas de las preposiciones, en general, y de las dos preposiciones "Para" y  "Por" en concreto, en una unidad linguística más amplia que la llamada "Oración". En la parte  referida al  estudio de las dos preposiciones mencionadas,  estudiamos sus distntos usos funcionales, usos que se acercan, unas veces,  entre sí  y  se alejan en otras. 

Abstract    

RESUMEN:

 Pretendemos hacer con este trabajo un breve recorrido sobre lo que han dicho algunos gramáticos de las construcciones condicionales, a la par señalaremos los criterios que los mismos establecen y siguen para diferenciar entre distintos tipos de estructuras condicionales o entre las construcciones que ellos entienden o consideran como tales y las que no, atendiendo fundamentalmente a dos criterios; formal y semántico-pragmático. El presente trabajo tiene como objetivo la clasificación y la descripción de las construcciones condicionales, demostrando que no todas las condicionales son hipotéticas ni todas las hipotéticas son condicionales.

Abstract

We intend to make this work

Low-dimensional materials have attracted significant attention in developing and enhancing the performance of quantum well lasers due to their extraordinary unique properties. The optical confinement factor is one of the most effective parameters for evaluating the optimal performance of a semiconductor laser diode when used to measure the optical gain and current threshold. The optical confinement factor and the radiative recombination of single quantum wells (SQW) and multi-quantum wells (MQW) for InGaAsP/InP have been theoretically studied using both radiative and Auger coefficients. Quantum well width, barrier width, and number of quantum wells were all looked at to see how these things changed the optical confinement factor and