Photonic crystal fiber interferometers are widely used for sensing applications. In this work, solid core-Photonic crystal fiber based on Mach-Zehnder modal interferometer for sensing refractive index was presented. The general structure of sensor applied by splicing short lengths of PCF in both sides with conventional single mode fiber (SMF-28). To apply modal interferometer theory; collapsing technique based on fusion splicing used to excite higher order modes (LP01 and LP11). Laser diode (1550 nm) has been used as a pump light source. Where a high sensitive optical spectrum analyzer (OSA) was used to monitor and record the transmitted. The experimental work shows that the interference spectrum of Photonic crystal fiber interferometer exhibits good sensitivity to refractive index variations. The response of the PCFI is observed for a range of refractive index values from (1.33 to 1.38), the position of the interference peaks is found to be shifted to longer wavelength with refractive index increasing. A different length of PCFs (2, 3, 4) cm were used, and the maximum refractive index sensitivity of (7.5 pm / RIU) is achieved with a PCF length of 4 cm. This refractive index sensor has distinguished properties as that it small size, high sensitivity, fast response time, design flexibility, and immunity to electromagnetic interference.
This work represents implementation and investigation of optical coherent communication system between two computers. A single mode optical fiber is selected as transmission medium. The data are sent via the RS-232 standard interface with a bit rate of 9.6 kbps from personal computer (PC1) by line receive to convert the data from electrical levels (-12/+12 V) into TTL level (0/5 V). The modulation of this data was accomplished by internal modulation using laser diode type (HFCT-5208M) 1310 nm wavelength. The optical D-coupler was used to combine the optical signal that come from laser source with optical signal of laser local oscillator (OTS-304XI) at 1310/1550 nm wavelength to obtain coherent (homodyne and heterodyne) detection respective
... Show MoreFour hundred and fifty urine samples were collected from patients suffering from urinary tract infection from the General Azadi hospital in Kurkuk province ,during the period of october 2007 till march 2008 . Results of bacteriological culture revealed that (168) out of (450) studied samples (37.3%) gave positive culture using blood agar and macConkey agar ; different species of bacterial isolates were detected using morphological and biochemical tests ,from these isolates the highest percentage of the isolates were from Escherichia coli when it was (100) isolates out of (190) isolate (52.63%) . one hundred isolates were distributed between (77) from females and (23) from
... Show MoreMany of the key stream generators which are used in practice are LFSR-based in the sense that they produce the key stream according to a rule y = C(L(x)), where L(x) denotes an internal linear bit stream, produced by small number of parallel linear feedback shift registers (LFSRs), and C denotes some nonlinear compression function. In this paper we combine between the output sequences from the linear feedback shift registers with the sequences out from non linear key generator to get the final very strong key sequence
The new 4-[(7-chloro-2,1,3-benzoxadiazole)azo]-4,5-diphenyl imidazole (L) have been synthesized and characterized by micro elemental and thermal analyses as well as 1H.NMR, FT-IR, and UV-Vis spectroscopic techniques. (L) acts as a ligand coordinating with some metal ionsV(IV), Fe(III), Co(II), Ni(II), Cu(II), and Zn(II). Structures of the new compounds were characterized by elemental and thermal analyses as well as FT-IR and UV-Vis Spectra. The magnetic properties and electrical conductivities of metal complexes were also determined. Study of the nature of the complexes formed in ethanol following the mole ratio method.. The work also include a theoretical treatment of the formed complexes in the gas phase, this was done using the (hyperch
... Show MorePurification of fifteen NaCl samples from natural and different area in the middle and south of Iraq are prepared and studied the structural characteristics of samples by powder X-ray diffraction analysis at ð›Œ=1.542Ã…. The present work considered the specific activities of naturally occurring radioactive materials in salt samples, which are measured and analyzed using high resolution HPGe system. Also, the radiological parameters have been considered in this work. The average specific concentration (in Bq.kg-1) of the salt samples is found 16.864.92 for 226Ra, 5.972.05 for 232Th and 9.852.8 for 40K, respectively, which are below the national levels, 40Bq.kg-1, 30Bq.k
... Show MoreThis paper displays the effect of uncoated and coated chopped carbon fibers with alumina Al2O3 or Tri calcium phosphate (TCP) on the impact strength of acrylic poly methyl methacrylate (PMMA) denture base resin. To improve bonding between carbon fibers and coating materials powders, the surface of carbon fibers has been treated with Para amino benzoic acid (C9H10N2O3) and poly vinyl alcohol (PVA) was also used. The morphology of the coating layers has been examined by field emission scanning electron microscope (FE-SEM). From the results, PMMA reinforced with uncoated chopped carbon fiber has high impact strength value but still have bad aesthetic. Samples prepared b
... Show MoreThis research dedicated to make an investigation for the variation of electron density concentration of D- region(NmD), at a characteristic height of 81 km throughout solar cycle 23, with solar activity(represented by sunspot number indices: international sunspot number(Ri), Northern hemisphere sunspot number(Rn) and Southern hemisphere sunspot number(Rs), as well as, the correlation between these indices for Baghdad city(lat.: 33.3o N, long.: 44.4o E) at local noon time during the ascending and the descending phases of solar cycle 23. A very strong directly relationship were found between Ri, Rn and Rs with NmD, as well as, the correlation coefficient between these parameters have been calculated and it has been found it is equal, i.e.,
... Show MoreThis study assessed the quality of hand-dug drinking water sources in Eku and its environs at Eku I, Samagidi, Eku 2, and Okuechi, using the weighted arithmetic water quality index method. Water samples collected from hand-dug wells at these locations returned values for analyzed parameters. Temperature 26 – 30(⁰C), dissolved Oxygen (D.O) 5.2-8mg/l, biological oxygen demand (BOD) 5.2-8(mg/l), Electrical Conductivity (EC) 77-119(µS/cm), Total suspended solids were (TSS) 20000-120000(mg/l), pH 5.31-7.09, Phosphates 2-9.2(mg/l), Alkalinity 28-160(mg/l), Turbidity, 0.02 -0.19(NTU) Total coliform 2 -48 (cfu/ml) and fungal count 1-502. Variations in the values of these parameters were only significant for phosphate, alkalinity, and turb
... Show MoreMetal contents in vegetables are interesting because of issues related to food safety and potential health risks. The availability of these metals in the human body may perform many biochemical functions and some of them linked with various diseases at high levels. The current study aimed to evaluate the concentration of various metals in common local consumed vegetables using ICP-MS. The concentrations of metals in vegetables of tarragon, Bay laurel, dill, Syrian mesquite, vine leaves, thymes, arugula, basil, common purslane and parsley of this study were found to be in the range of, 76-778 for Al, 10-333 for B, 4-119 for Ba, 2812-24645 for Ca, 0.1-0.32 for Co, 201-464 for Fe, 3661-46400 for K, 0.31–1.
... Show MoreThe tested isolate of Rhizobium leguminosarum bv. viciae was isolated from root nodules of vicia faba plant from Baghdad ,the isolated bacteria was examined for bioemulsifier production when growing in mineral salt medium that containing 1% sunflower oil as sole carbon source . Rhizobium isolate was able to produce bioemulsifier with initial emulsification index E24% was 38%. Many of physical and nutritional cultural conditions for optimum emulsifier production was examined including : pH , temperature ,incubation period ,carbon and nitrogen source. The maximum bioemulsifier production form Rhizobium isolate was 64.5% when bacteria growing in mineral salt medium with pH 9 ,incubated at temperature 30 ºC , incubation period was 10 days ,
... Show More