Preferred Language
Articles
/
ijcpe-821
Treating Wet Oil in Amara Oil Field Using Nanomaterial (SiO2) With Different Types of De emulsifiers
...Show More Authors

One of the most important problems in the oil production process and when its continuous flow, is emulsified oil (w/o emulsion), which in turn causes many problems, from the production line to the extended pipelines that are then transported to the oil refining process. It was observed that the nanomaterial (SiO2) supported the separation process by adding it to the emulsion sample and showed a high separation rate with the demulsifiers (RB6000) and (sebamax) where the percentage of separation was greater than (90 and 80 )%  respectively, and less than that when dealing with (Sodium dodecyl sulfate and Diethylene glycol), the percentage of separation was (60% and 50%) respectively.

   The high proportion of (NaCl + distilled water) raises the probability of the separation efficiency as the separation was (88.5,79)% and (65.5, 55) %  for (RB6000, SebaMax)respectively with (SiO2) at 70 °C, while the results of separation were (77,85)% and (65,40)  for (RB6000, Seba Max) respectively with (SiO2) at 50 °C after 120 minutes, where the (w/o ratio) was (9:1) for the high separation results and (7:3) for the lower separation results, at a speed of (12000rpm), and with a salt concentration of (1500) ppm, and less of these results at lower volumetric and temporal conditions. The (NaCl) salt deals with the wall films separating the droplets and reduces their viscosity [1].

   As for the pH factor, it is at the value (2 and 3) represent a stable emulsion that is difficult to separate easily, but with the passage of raising the pH away from the acidic medium and near to the basic direction, a significant increase in the separation process was observed compared with the acidic medium at lower values, after 120 minutes the separation seemed to be good efficient, reaching (60 and 70) % respectively, while at the same time the emulsion reached a more efficient separation level with a pH of (  8 and 7) equal to (80 and 87.3)  %, at 50 °C with SebaMax demulsifier in presence of (SiO2), and with the same pH values, an increase was observed in the separation with the increase in temperature to (70 °C), then it returns to be a reverse emulsifier when the value exceeds (10) to (11, 12, 13).

Crossref
View Publication Preview PDF
Quick Preview PDF
Publication Date
Tue Jan 25 2022
Journal Name
Iraqi Journal Of Science
Radiological hazard Assessment Due to Natural Occurring Radioactive Materials (NORM) in Oil and Gas Production Industry –East Baghdad Oil Field
...Show More Authors

Concentration of NORM then radiological hazard indices were investigated and assessed in different stages of oil and gas production industry that belongs to East Baghdad Oil Field. Sixteen samples of different types of materials were collected representing oil and gas production from first stage to final stage. The samples are prepared then sent to Radiation Protection Center (RPC) / Ministry of Environment for radioactivity analysis using gamma ray spectrometry system based on HPGe. The results show that max value of Ra-226 is 252.4 Bq/kg in sediment sample collected from the final stage of water treatment before it is transferred to disposal well and min value is 1.2 Bq/kg in formation water. The max. activity of Th-232 is 79.4Bq/kg al

... Show More
View Publication Preview PDF
Publication Date
Mon Oct 30 2023
Journal Name
Iraqi Journal Of Science
Structural Interpretations for Zubair Formation in Kumait oil field, Using 3D Seismic Reflection Data, Southern-East Iraq
...Show More Authors

     This study deals with the interpretation of structural 3D seismic reflection of the Kumait oil field in southern Iraq within the administrative boundaries of the Maysan Governorate. Synthetic seismograms are prepared by using available data of the Kt-1 oil field by using Petrel software to define and pick the reflector on the seismic section of the Zubair Formation, Which represents the Cretaceous Age. The study shows that the Kumait structure is an anticline fold. It is thought to be a structure trap caused by the collision of the Arabian and Iranian plates and trending in the same direction as driving factors in the area, which are from the northwest to the southeast, and the overall trend of strata is north and northeast. Sei

... Show More
View Publication Preview PDF
Scopus Crossref
Publication Date
Fri Nov 24 2023
Journal Name
Iraqi Journal Of Science
Geochemical Correlation of Mishrif Formation in AL-Nasiriyah Oil Field/ South of Iraq
...Show More Authors

Gas Chromatography GC, Gas Chromatography–Mass spectrometry GC/MS techniques used for analysis of the crude oils that taken from (10) producing wells in Nasiriyah oil field including (NS-1, NS-3, NS-4, NS-5, NS-6, NS-7, NS-8, NS-9, NS-10, and NS-12) from Mishrif reservoir . This reservoir is one of the important reservoirs in Al-Nasiriyah oil field, and it will be the main subject in the current study in order to provide information of crude oil analysis in this area, also to provide information on its characterizations. Mishrif Formation is one of the principle carbonate reservoir in central and southern Iraq. It is part of the wasia group and widespread throughout the Arabian gulf, It is deposited during Cenomanian-Early Turonian cyc

... Show More
View Publication Preview PDF
Publication Date
Sat Feb 08 2025
Journal Name
Journal Of Baghdad College Of Dentistry
Comparison of regional bond strength among different types of posts luted with different types of cement
...Show More Authors

Background: This in vitro study was carried out to investigate the effect of post space regions (coronal, middle and apical), the effect of post types ( Manually Milled Zirconia post, Prefabricated Fiber post, prefabricated Zirconia post) and the type of cement used (GIC, self-adhesive resin cement) on the bond strength between the posts and root dentin by using push-out test. Material and methods: Forty eight mandibular premolars extracted for orthodontic reasons (single rooted) were instrumented with ProTaper system (hand use) and obturated with gutta percha for ProTaper using AH26® root canal sealer following the manufacturer instructions. After 24 hours, post space was prepared using Zirix and Glassix drills no.3 creating 8 mm dept

... Show More
View Publication Preview PDF
Publication Date
Thu Jan 30 2020
Journal Name
Journal Of Engineering
Calculation of Pressure Loss of Two Drilling Muds in Noor Oil Field
...Show More Authors

   

In this work, calculation of pressure losses in circulating system for two drilling muds is evaluated in Noor oil field. Two types of drilling muds that were used for drilling section 12 1/4" and 8 3/4" which are Salt saturated mud and Ferro Chrome Lignosulfonate-Chrome Lignite mud. These calculations are based on field data that were gathered from the drilling site of well Noor-15, which are included, rheological data, flow data and specification of drill string. Based on the obtained results, the best rheological model that fit their data is the Herschel-Bulkley model according to correlation coefficient value for their two drilling mud. Also, the difference between the calculated pressure lo

... Show More
View Publication Preview PDF
Crossref
Publication Date
Fri Jun 30 2023
Journal Name
Iraqi Journal Of Science
Evaluation of Vanadium Contamination in Some Soils of the East Baghdad Oil Field
...Show More Authors

     Since oil is the primary source of vanadium in the environment and crude oil has a correspondingly high percentage of vanadium. Vanadium is crucial as a sign of oil contamination. Twenty soil samples were taken from various locations surrounding the East Baghdad oil field in Iraq during February 2022 and then analyzed to determine the effects of industrialization along with urbanization-related pollutants. The soil samples were analyzed using spectrophotometry analysis. In soil samples taken from the research area, vanadium concentrations range from (0.26 to 1.2 ppm). The contamination (CF), geoaccumulation (Igeo) and Enrichment factors (EF) indicated that all the soil samples are uncontaminated.

View Publication Preview PDF
Scopus (2)
Scopus Crossref
Publication Date
Thu Jun 30 2022
Journal Name
Iraqi Journal Of Science
3D Geological Modelling for Asmari Reservoir In Abu Ghirab Oil Field
...Show More Authors

    Building a geological model is an essential and primary step for studying the reservoir’s hydrocarbon content and future performance. A three-dimensional geological model of the Asmari reservoir in Abu- Ghirab oil field including structure, stratigraphy, and reservoir petrophysical properties, has been constructed in the present work. As to underlying Formations, striking slip faults developed at the flank and interlayer normal. Abu Ghirab oilfields are located on the eastern anticlinal band, which has steadily plunged southward. 3D seismic interpretation results are utilized to build the fault model for 43 faults of the Asmari Formation in Abu Ghirab Oilfield. A geographic facies model with six different rock facies types

... Show More
Crossref (1)
Crossref
Publication Date
Tue Feb 28 2023
Journal Name
Iraqi Geological Journal
3D Geological Model for Zubair Reservoir in Abu-Amood Oil Field
...Show More Authors

The Zubair reservoir in the Abu-Amood field is considered a shaly sand reservoir in the south of Iraq. The geological model is created for identifying the facies, distributing the petrophysical properties and estimating the volume of hydrocarbon in place. When the data processing by Interactive Petrophysics (IP) software is completed and estimated the permeability reservoir by using the hydraulic unit method then, three main steps are applied to build the geological model, begins with creating a structural, facies and property models. five zones the reservoirs were divided (three reservoir units and two cap rocks) depending on the variation of petrophysical properties (porosity and permeability) that results from IP software interpr

... Show More
View Publication Preview PDF
Scopus (4)
Scopus Crossref
Publication Date
Thu Jun 30 2022
Journal Name
Iraqi Journal Of Science
3D Geological Modelling for Asmari Reservoir In Abu Ghirab Oil Field
...Show More Authors

    Building a geological model is an essential and primary step for studying the reservoir’s hydrocarbon content and future performance. A three-dimensional geological model of the Asmari reservoir in Abu- Ghirab oil field including structure, stratigraphy, and reservoir petrophysical properties, has been constructed in the present work.

As to underlying Formations, striking slip faults developed at the flank and interlayer normal. Abu Ghirab oilfields are located on the eastern anticlinal band, which has steadily plunged southward. 3D seismic interpretation results are utilized to build the fault model for 43 faults of the Asmari Formation in Abu Ghirab Oilfield. A geographic facies model with six different rock facies type

... Show More
View Publication Preview PDF
Scopus (3)
Crossref (1)
Scopus Crossref
Publication Date
Sun Apr 30 2023
Journal Name
Iraqi Journal Of Science
Petroleum System Modeling of Halfaya Oil Field South of Iraq
...Show More Authors

The petroleum system of Halfaya oil field shows that the hydrocarbon generation of these Formations such as Sha′uiba and Nahr Umr are immature and have generated few oil TR ≤ 50% which are neglected as compared to Formations below them which are very rich source rock. The Formations of Yamama, Ratawi and Sulaiy are mature with TR ≤ 100%. Other Formations such as Sargelu ,Najma,Zubair and Gotnia are with very high maturity with TR ≥ 100% and completely generated hydrocarbon and depleted after hydrocarbon are expelled and migrate to reservoir rock of structure traps and this study indicates that the major seals of Upper Jurassic are Gotnia and Allan Formations and of Middle Miocene is LowerFars fatha Formation.

View Publication Preview PDF