Natural convection in a trapezoidal enclosure with partial heating from below and symmetrical cooling from the sides has been investigated numerically. The heating is simulated by a centrally located heat source on the bottom wall, and four different values of the dimensionless heat source length, 1/5, 2/5, 3/5, 4/5 are considered. The laminar flow field is analyzed numerically by solving the steady, two-dimensional incompressible Navier-Stokes and energy equations. The Cartesian velocity components and pressure on a collocated (non-staggered) grid are used as dependent variables in the momentum equations discretized by finite volume method; body fitted coordinates are used to represent the trapezoidal enclosure, and grid generation technique based on elliptic partial differential equations is employed. SIMPLE algorithm is used to adjust the velocity field to satisfy the conservation of mass. The range of Rayleigh number is (103≤ Ra ≤105) and Prandtl number is 0.7. The results show that the average Nusselt number increases with the increases of the source length.
Natural Convection in Trapezoidal Enclosure Heated Partially from Below
Natural Convection
Trapezoidal Enclosure
Finite Volume
Publication Date
Sat Oct 01 2022
Journal Name
Environmental Advances
Stability and performance studies of emulsion liquid membrane on pesticides removal using mixture of Fe3O4Â nanoparticles and span80
The current study investigated the impact of nonionic surfactant span 80 in the existence of Fe3O4 magnetic nanoparticles on the emulsification of mixture of kerosene as petroleum based organic solvents and corn oil as a green diluent in the ratio 1:1
HCl was used as internal phase and the stability of the emulsion was carried out. The proposed Pickering emulsion liquid membrane has been exploited to investigate it is ability in the extraction of Abamectin pesticides from aqueous solution without utilizing carrier agent. Further
the effects of experimental parameters on extraction efficiency and emulsion stability such as
homogenizer speed
emulsification speed
contact time
Fe3O4-Span 80 ratios
HCL concentration
internal to membrane volume ratio (I/O) and pH of the external feed solution were carried out. The results showed that more than 99% of Abamectin could be extracted at 10 min contact time with a minimum breakage percent of 0.52% at the optimal conditions. The kinetic of the extraction were studied and the mass transfer coefficient was found to be for external phase () of 1.2
interfacial reaction rate constant () of 5.83 and the overall mass transfer coefficient () of 3.91 . The results of recyclability of the PELM revealed that the emulsion stability and extraction efficiency was nearly unchanged after three cycles.
(12)
(10)
Publication Date
Mon Apr 06 2020
Journal Name
August
INFLUENCE OF SOME FACTOR ON SOMATIC EMBRYOS INDUCTION
AND GERMINATION OF DATE PALM CV BARHI BY USING CELL
SUSPENSION CULTURE TECHNIQUE
This study was done to examine different concentrations of mercuric chloride (Hgcl2) for Explants sterilization and different
concentration of NAA) mg/L with 2iP for their effect on initiation primary callus and subsequent embryogenesis in Phoenix
dactyliferae cultivar Barhi. Leaf primordial and shoot tips were excised from 2-3 years old offshoot. The result showed that
contamination percentage decreased with an increase in concentration of Hgcl2 for two explants where in the control (0.0)%
gave highest value 75% and 62.5% of contamination for leaf primordial and shoot tip respectively while the addition (0.1)%
gave a significant decrease 37.5 and 0% for explants respectively. The Explants were inoculated onto Murashiege and Skoog
1962 (MS) medium supplemented with 2iP 3mg/L and containing 0
25
50 or 100 mg/L of NAA
the addition (50) mg/L of NAA
gave highest value 68.8% in percentage of callus initiation with significant difference from addition 0% gave lowest value
(18.8)%
as well Explants of shoot tip gave significant difference was 53.1% while leaf primordial gave 28.1%
Primary callus
was transferred to fresh MS medium containing (0
5
10 and 20) mg/L of NAA with 3mg/L 2iP
Results were recorded after 12
weeks. A highest value of embryonic callus induction percentage or fresh weight and dry weight 87.5% or 1.56g and 0.47g for
the character respectively for the treat 20 mg/L while control treatment 0.0 gave the lowest value 12.5% or 0.37g and 0.14g for
same character respectively. Inoculated 1g fresh biomass into a 250 ml Erlenmeyer flask containing 50 ml MS liquid medium
supplemented with NAA 20mg/L and agitated at 150 rpm by shaker to making suspension culture the measurements of
packed cell volume ( pcv) or fresh and dry weight taken weekly for 12 weeks
maximum values were reached in the eighth week
of PCV and fresh weight but the dry weight reached to highest value in seventh week
then the curve began to decline
gradually until it reached stability in the last two weeks. The cell suspension was Diluted to different initial cell density of 100
500
10000
50000 and 100000 cells /ml with hemocytometer. The initial cell number of (10000) cells gave significant different
of plating efficiency PE (11.6)% while (100) cells gave lowest value 1.8% of PE.