This paper aims to study the effect of circular Y-shaped fin arrangement to improve the low thermal response rates of a double-tube heat exchanger containing Paraffin phase change material (PCM). ANSYS software is employed to perform the computational fluid dynamic (CFD) simulations of the heat exchanger, including fluid flow, heat transfer, and the phase change process. The optimum state of the fin configuration is derived through sensitivity analysis by evaluating the geometrical parameters of the Y-shaped fin. For the same height of the fins (10 mm), the solidification time is reduced by almost 22%, and the discharging rate is enhanced by almost 26% using Y-shaped fins compared with the straight fins. The results demonstrate that the sol

Alloys from AgSb(SxSe1-x)2 with different compositions were prepared using quenching from the melt . This was done by put the appropriate amount of Ag, Sb,S and Se in an evaluated quartz ampoule , sealed and left at oven in temperature 1273 for 5 hours. Thin films with different composition were deposited by pulsed deposition technique PLD onto glass substrates at ambient temperature . This paper concerned on the investigate effect of composition on structural morphology, and electrical properties. The structure and morphology of the prepoared thin films were checked using X–ray diffraction and atomic force microscope. The D.C conductivity of the AgSb(SxSe1-x)2thin films with various x content was measured

Indoor air pollution is a critical environmental challenge with negative impacts on human health, especially in urban and enclosed settings. This study aimed to evaluate the tolerance of three indoor ornamental plants—Epipremnum aureum, Sansevieria trifasciata, and Syngonium podophyllum Schott—against pollutants generated by cigarette smoke and kerosene combustion. Plants were exposed under controlled indoor conditions, while particulate matter (PM₁. ₀, PM₂. ₅, PM₁₀), total volatile organic compounds (TVOCs), and carbon dioxide (CO₂) were measured before, during, and after exposure. Plant tolerance was assessed using the Air Pollution Tolerance Index (APTI), calculated from total chlorophyll content, leaf extract pH, ascor