The experiments were conducted in laboratory conditions of a temperature of 25± 2C and relative moisture of 40± 5 % to evaluate the effectiveness of the cinnamon, lavender and clove essential oils on some biological life aspects of cowpea beetle, C. maculates. Results of the obligative experiment for the effect of the oils on insect adult killing showed that the concentration of 5% caused a mortality percentage averaged 13.33% of the insect males. The mortality percentage of the insect females was 11.3% for the cinnamon and lavender oils. The lavender oil had the lowest effect on adult killing, not exceeding 0. For the effect of the oils on egg laying, clove oil affected the number of eggs highly at the concentration of 5%, resulting in 2.00 eggs on average. The lowest oil effect on egg number was for the lavender oil at the concentration of 1%, leading to an average of 14.73 eggs. The clove oil at the concentration of 5% showed effectiveness in adult emergence prevention as it was not observed that any insect emerged. In contrast, the same oil at the concentration of 1% had less effect, resulting in the highest emergence percentage reaching 13.33%. The same applies to the effect of the plant oils on insect productivity as the clove oil at the concentration of 5% was the most effective; no insect productivity was recorded, unlike the concentration of 1%, recorded productivity of 110.2 %. In the facultative experiment, the highest mortality percentage was recorded using clove oil against females, as the mortality percentage reached 4.00%. In contrast, the lowest mortality percentage was recorded using lavender oil against males, where no killing occurred, as the mortality percentage did not exceed 0.00%. For the effect of the oils on egg laying, the highest affected oil was cinnamon at a concentration of 5% as the number of eggs reached 5.60, while lavender oil at 3% was the least effective; the average number of eggs was 25. Clove oil at a concentration of 5% had the highest effect in reducing the emergence of the insect, so the emergence percentage did not exceed 0.33%. In comparison, its influence was low at 1%, recording the highest emergence percentage (18.67%). The lowest recorded insect productivity average was from the treatment of the clove oil at a concentration of 5%, which did not exceed 5.20%, while the highest productivity average was from the treatment of the lavender oil at 1%, which reached 89.6%. Keywords: essential oils, Cowpea beetle, Callosobruchus maculatus
In this study, a Hydroxyapatite (HA) coating was prepared on a titanium implant by an electrochemical deposition process. The titanium pre-treatment by anodizing in 1.65 mol/L sulfuric acid with (10V) at room temperature. The deposition was all conducted at a constant voltage of 6.0 V, for 1 h at room temperature. The coatings thus prepared were characterized with Fourier transform infrared spectroscopy (FTIR) and thickness of the coated layer.The electrochemical deposition of HA occurred on the titanium as a cathode. Coated titanium by HA after anodizing revealed a good corrosion protection efficiency even at a temperature ranged (293-323) K in artificial saliva. Activation energy and pre-exponential factor (kinetic parameters) were calcul
... Show MoreBackground: Studying and investigating the transverse strength(Ts), impact strength(Is), hardness (Hr) and surface roughness(Ra) of conventional and modified autopolymerizing acrylic resin with different weight percentages of biopolymer kraftlignin, after curing in different water temperatures; 40°C and 80°C. Material and Methods: Standard acrylic specimens were fabricated according to ADA specification No.12 for transverse strength, ISO 179 was used for impact testing, Shore D for hardness and profilometerfor surface roughness. The material lignin first dispersed in the monomer, then the powder PMMA is immediately added. Ligninadded in different weight percentages. Then cured using pressure pot (Ivomet) in two temperatures;40°C a
... Show MoreBackground: Hypothyroidism is a clinical syndrome prevalent in women, even those of reproductive age. Ovarian reserve can be defined as the number and quality of follicles in the ovary at any given time. Evaluation of ovarian reserve is recommended for patients at risk of decreased ovarian reserve. Objective: This study aims to evaluate the effect of hypothyroidism on ovarian reserve in Iraqi women by hormonal measurements of serum anti-mullerian hormones AMH, FSH, and LH. Subjects and methods: This case–control study was carried out at the Department of Biochemistry, College of Medicine, University of Baghdad, in collaboration with Endocrinology and Diabetes Clinic, Baghdad Teaching Hospital, and National Center for Teaching Labo
... Show MoreObjective(s): In the present study, glycerin is used as a substitute for tin-foil and cold mold seal (Alginate mould seal)
in the process of curing heat and cold-cure acrylic resin denture base against stone and plaster.
Methodology: 60 specimens were prepared from heat-cure acrylic resin and cold-cure acrylic resin denture base. The
study includes 12 groups of specimens depending on the type of processing, investment material and type of
separating medium that are used in curing process. Each group of them contains 5 specimens for each test.
Some of physical properties of the processed acrylic denture base that (water sorption and solubility) have been
compared with those processed using tin-foil and tin-foil substitut
The importance of physical and nonphysical architectural design values made architectural designers need good experience to be experts of architectural values reasonably without neglecting any value in the design process. The importance of such values made that ignoring any values and mistakes occurs in the design process. Simultaneously, architectural designers' different nature and the difference in their experiences are causing different understandings of the design values, thus causing architectural mistakes. The research problem appears from the randomly propagating of mistakes in contemporary architecture, which is about to become a phenomenon in Al Sulaymaniyah city. The research aims to find the main reason
... Show MoreThis study aims to know the types of insects belonging to the Sphaeroceridae family. During this study, one species registered for this family for the first time to Iraq (New genus and species). It is using two methods of killing are injurious machine (knife) and toxic substance (strychnine). Four areas within Karbala governorate studied and identified to know their spread and time of presence on the body during the stages of decomposition. During this experiment, the bodies of dogs used to identify types of insects attracted to the body during four seasons. The results indicated the presence of the species
Soil and plant contamination with heavy metals is one of the current problems in the world especially contamination with mercury. Heavy metals are very harmful because of their long biological half-lives, non-biodegradable nature and their possibility to accumulate at different body parts. Soil, well water and leafy plant samples (Apium graveoleus, Allium ampeloprasum, Lepidium sativum, Eruca sativa, Petroselinum hortense, Ocimum basilicum , Mentha pulegium) from three different agricultural fields (AL-Musafer village (site 1), AL-Autaifiyah (site 2) and AL-Huriyah (site 3)) in Baghdad government, Iraq were analyzed for mercury concentration. Hg level in so
... Show More<em>The aim of the research is to set a set of BioKinematic variables for the step of crossing barriers (3–6–9) in a 110-meter barrier for young runners. The researchers concluded the study by interpreting and discussing the results that the most important variables must be relied upon when training and selecting runners that got the best saturation on their factors: 1-The first factor which refers to the total distance of the plan to pass the third barrier + the total distance of the plan to pass the ninth barrier + the total distance Plan to cross the sixth barrier. 2-The second factor which refers to the total vertical speed before passing the third barrier + the total vertical speed before the sixth barrier + the total vertica
... Show More