The experiment was conducted to evaluate and performance comparison for moldboard and disk plows in central of Iraq in 2011. Three factor were used in this study included Two types of plows included moldboard and disk plows which represented main plot , three forward speeds of the tillage was second factor included 1.85, 3.75 and 5.62 km / h which represented sup plot , and three levels of soil moisture was third factor included 21 , 18 and 14 % to determined data actual plow depth , Practical productivity, Volume of disturbed soil, Field efficiency , Slippage percentage in silt clay loam soil with depth 22 cm were studied in the experiment Split – split plot design under randomized complete block design with three replications using Least Significant Design was used . Mold board plough recorded best practical productivity was 0.3118 ha/hr , volume of disturbed soil was 629.77 m3/hr and field efficiency was 59.85 % , while disc plough recorded higher actual plow depth 21.02 cm and slippage percentage was9.71 % . Increasing forward speeds of the tillage from 1.85 to 3.75 then to 5.62 increasing slippage percentage from 6.39 to 8.26 then to 12.22 % , practical productivity from 0.1421 to 0.2845 then to o.4180 ha/hr and volume of disturbed soil from 299.89 to 592.38 then to 838.24 m3/hr , while decreased actual plow depth from 21.13 to 20.86 then to 20.08 cm and field efficiency from 58.98 to 58.21 then to 57.07 % . with decrease soil moisture from 21 to 18 % decrease actual plow depth from 20.92 to 20.70 cm and slippage percentage from 10.58 to 7.29 % , and increase practical productivity from 0.2712 to 0.2923 ha/hr, volume of disturbed soil from 562.01 to 598.98 m3/hr and field efficiency from 55.94 to 60.31 % . While continues decrease from 18 to 14 % decrease actual plow depth from 20.70 to 20.46 cm, practical productivity from 0.2923 to 0.2811, volume of disturbed soil from 598.98 to 569.52 m3/hr and field efficiency from 60.31 to 58.01 % , and increase slippage percentage from 7.29 to 9.00 % .
CO2 laser (10.6 μm) is the most often used laser in the oral surgery due to its high absorption by water of the oral tissues. Several benefits of the use of CO2 laser have been reported for oral surgical procedures. This study aims to evaluate the effect of CO2 laser on soft and hard oral tissues (in vitro study). This study was done on fresh tissues from sheep’s head. CO2Surgical Laser with different operation modes was used; 0.2 mm spot size using different laser parameters on the tongue, and bone making holes, incisions and cutting. The depths and widths of holes and incisions were measured using endodontic file under magnification. The speed of incisions was calculated and the required time for cutting was measured using sport clo
... Show MoreThis research aims to underscore the significance of women's emotional intelligence in enhancing the effectiveness of the Board of Directors, a crucial component of internal governance, particularly during crises. Despite strides made in recent decades in appointing women to senior roles in government, business, and education, challenges persist in improving women's leadership opportunities, especially in developing countries. The study utilizes statistical methods, including Pearson's correlation, to analyze the relationships between variables within a sample of banks listed on the Iraqi securities market, comparing periods before and during the COVID-19 pandemic (2019 and 2020). The goal is to measure the impact of female emotiona
... Show MoreThis study aims to assess the removal efficiency andestablish the BOD5 and COD statisticalcorrelation of the sewage flowing in Al-Diwaniyah wastewater treatment plant in Iraq during the study period (2005-2016). The strength of the influent wastewater entering the plant varied from medium to high in strength. High concentrations of BOD5 and COD in the effluent were obtained due to the poor performance of the plant. This was observed from the BOD5 /COD ratios that did not confirm with the typical ratios for the treated sewage. To improve the performance of this plant, regression equations for BOD5 and COD removal percentages were suggested which can be used to facilitate evaluation of liquid waste and optimal control process. The equations
... Show MoreThe aim of this work is to study the effect of diesel fuel percentage on the combustion processes in compression ignition engine using dual – fuel (diesel and LPG).
The brake thermal efficiency increased with the increase of diesel fuel rate at low loads, and decreased when load increased. To get sufficient operation in engine fueled with dual fuel, it required sufficient flow rate of diesel fuel, if the engine fueled with insufficient diesel fuel erratic operation with miss fire cycles presented.
Dual-fuel operation at part load showed higher specific fuel consumption than straight diesl operation. At full loads, brake specific fuel consumption of duel fuel engine approaches that for diesel fuel values.
some ecological (physical and chemical varible) of water samples were studies monthly from December 2008 to May 2009 at two stations( St.1) Al - Chibayesh marsh and (St.2) Abu – Zirik marsh which are located in the south of Iraq . These variables included : Temperature, pH, EC, Dissolved oxygen , Total alkalinity, Nitrate, Sulphate, and phosphate, Si-SiO2 and Ca ,Mg, Cl, The marsh Considered as fresh water and alkaline. Abu-Zirik less than Al-Chibayesh.
Four major factories (Petroleum Refineries Company, Detergents Plant, Thermal Power Plant, and Gaseous Power Plant) are located to the north of Baiji City. They release pollutants in form of gases, liquids and solids; they find their way to the surrounding environment. To assess the environmental pollution of the area, 18 samples of surface soil distributed around the industrial establishments were collected and analyzed to determine the concentration of polycyclic aromatic hydrocarbons (PAH) components which are often targets in the environmental checking. Identification and quantification of the 16 PAHs components was accomplished using High Performance Liquid Chromatography (HPLC) had a model Shimadzu LC-10 AVP. The total concentratio
... Show MoreThe study aimed to determine the extent of market knowledge in the companies researched, as if market knowledge is qualified to lead the companies researched to achieve marketing performance , for this purpose, formulated hypotheses of the study in three hypotheses, the first major hypothesis "there is a correlation with significance of market knowledge to improve the marketing performance , "while the second major hypothesis, "there is a significant moral influence of market knowledge to improve the marketing performance " these hypotheses targeting to determine the role played by market knowledge in the leadership of companies researched to achieve improvement in marketing perfor
... Show MoreThe research focuses on addressing one of the most important concepts of modern management that deal with the relationship between government institutions and stakeholders, Which now occupies a special significance in trends modern management, a concept of corporate governance it takes the internal mechanisms due to its key role and is important in the process of corporate governance and looking for building Effective mechanisms for this concept in light of laws and regulations that are available in the local environment and on the functioning of government institutions, Search has been applied in the Federal Board of Supreme Audit of Iraq (BSA) due to its particular importance as an institution control and as a awaits the societ
... Show MoreDue to the energy crisis and the stringent environmental regulations, diesel engines are offering good hope for automotive vehicles. However, a lot of work is needed to reduce the diesel exhaust emissions and give the way for full utilization of the diesel fuel’s excellent characteristics.
A kind of cetane number improver has been proposed and tested to be used with diesel fuel as ameans of reducing exhaust emissions. The addition of (2-ethylhexyl nitrate) was designed to raise fuel cetane number to three stages, 50, 52 and 55 compared to the used conventional diesel fuel whose CN was 48.5. The addition of CN improver results in the decre
... Show Morethe reality of small and medium enterprises analysis reflects weaknesses plaguing these enterprises and strengths that are characterized by, and thus the formulation of appropriate solutions to the obstacles faced by these enterprises to enhance its contribution to the achievement of economic and social development. Iraqi small and medium enterprises suffer from several obstacles stand in front of development and support their competitiveness, the finance one of the main obstacles which impede growth and development of these enterprises, noting the banking system in Iraq reluctance to lend to small and medium-sized enterprises, as a result of the high cost of lending these enterprises compared to large projects, as well as
... Show More