The subject of indication is one of many subjects that the Arabic language interest in and we decide that this research which we called (Indication of the abstract and Augmented Tri verbs) in one of Al-Quran Suras which is Al-moulk to dive in the secrets and knowledge of its meanings and knowledge of its structure in terms of abstraction and increase, And the investigation of our ancient scholars of linguistics and interpreters in its meanings. The verbss were classified according to the structure in which they were presented. The research includes two sections followed by the conclusion of the research, sources and its references. The first section (the indication of the abstract Tri verbs) in the sura is divided into four branches in w
... Show MoreThe Criminal Order System is a special procedural system that represents a form of (a non-pleading convention), which is intended to confront a particular type of crime in order to put an end to the expiry of the lawsuit resulting from it in a simple and easy manner that does not observe the rules prescribed for ordinary trials. The basic idea in the system of criminal orders is that the case papers in simple crimes contain enough evidence to decide on them without the need to proceed in the normal way of pleading, confronting and hearing witnesses ... etc.
This work was conducted to study the extraction of pelletierine sulphate from Punica granatum L. roots by liquid membrane techniques. Pelletierine sulphate is used widely in medicine. The general behavior of extraction process indicates that pelletierine conversion increased with increasing the number of stages and the discs rotation speed but high rotation speed was not favored because of the increased risk of droplet formation during the operation. The pH of feed and acceptor solution was also important. The results exhibit that the highest pelletierine conversion was obtained when using two stages, (10 rpm) discs speed of stainless steel discs, (pH=9.5) of feed solution and (pH=2) of acceptor solution in n-decane. Assuming the existen
... Show MoreThis study examines the relationships between Kuwait and the Soviet Union from 1961 to 1991, chiefly by analyzing not only the factors that drove Kuwait to form diplomatic relationships with Moscow in 1963 but also how domestic, regional, and international variables affected the development of those relationships until 1991. The study presents the analytical and historical research methods used to reach its findings. Among the findings, Kuwait’s decision to forge diplomatic relationships with Moscow in 1963 indeed seems to have been driven by domestic, regional, and international factors, including Kuwait’s geographical situation, the historical background of the relationships between Kuwait and Moscow, and the structure of t
... Show MoreExciton model describes the excitation of particles in pre-equilibrium region of nuclear reaction by exciton. In pre-equilibrium region there is a small probability for occurring emission and the number of excitons be the probability of the emission of it possible more is called most probable exciton number MPEN. In this paper the MPEN formula was derived for protons and neutrons separately and so MPEN formula derived with taking into account the non equidistant spacing between the energy states. The MPEN was studied with the mass number where it is noticed the MPEN increases with increasing the mass number. Also, MPEN studied for different isotopes of Al, the MPEN increases with increasing mass number of isotopes. MPEN for neutron is co
... Show MoreThis paper predicts the resilient modulus (Mr) for warm mix asphalt (WMA) mixtures prepared using aspha-min. Various predictor variables were analyzed, including asphalt cement types, asphalt contents, nominal maximum aggregate sizes (NMAS), filler content, test temperatures, and loading times. Univariate and multivariate analyses were conducted to examine the behavior of each predictor variable individually and collectively. Through univariate analysis, it was observed that Mr exhibited an inverse trend with asphalt cement grade, NMAS, test temperature, and load duration. Although Mr increased slightly with higher filler and asphalt content, the magnitude of this increase was minimal. Multivariate analysis revealed that the rate of change
... Show MoreThe need to constantly and consistently improve the quality and quantity of the educational system is essential. E-learning has emerged from the rapid cycle of change and the expansion of new technologies. Advances in information technology have increased network bandwidth, data access speed, and reduced data storage costs. In recent years, the implementation of cloud computing in educational settings has garnered the interest of major companies, leading to substantial investments in this area. Cloud computing improves engineering education by providing an environment that can be accessed from anywhere and allowing access to educational resources on demand. Cloud computing is a term used to describe the provision of hosting services
... Show MoreTwo galaxies have been chosen, spiral galaxy NGC 5005 and elliptical galaxy NGC 4278 to study their photometric properties by using surface photometric techniques with griz-Filters. Observations are obtained from the Sloan Digital Sky Survey (SDSS). The data reduction of all images have done, like bias and flat field, by SDSS pipeline. The overall structure of the two galaxies (a bulge, a disk), together with isophotal contour maps, surface brightness profiles and a bulge/disk decomposition of the galaxy images were performed, although the disk position angle, ellipticity and inclination of the galaxies have been estimated.
In this paper, a microcontroller-based electronic circuit have been designed and implemented for dental curing system using 8-bit MCS-51 microcontroller. Also a new control card is designed while considering advantages of microcontroller systems the time of curing was controlled automatically by preset values which were input from a push-button switch. An ignition based on PWM technique was used to reduce the high starting current needed for the halogen lamp. This paper and through the test result will show a good performance of the proposed system.