Biofilms formation by pathogens microbial Control considered important in medical research because it is the hazarded virulence factor leading to becoming difficult to treat because of its high resistance to antimicrobials. Glycopeptide antibiotic a (Vancomycin) and the commercial bacteriocin (Nisin A) were used to comparative with purification bacteriocin (MRSAcin) against MRSA biofilm. One hundred food samples were collected from Baghdad markets from July 2016 to September 2016, including (cheese, yogurt, raw milk, fried meat, grilled meat, and beef burger). All samples were cultures; S. aureus was confirmation by macroscopic culture and microscopic examination, in addition to biochemical tests. Methicillin resistance S. asureus (

The aim of this study is to investigate the main causes of the family violence and its
social effects.
The study reveals that main factors causes of the violence are interaction between
multi-factors.
The study shows that the poverty, low educational level, house crowded, large family
size, all of these variables causes of the violence, and then causes of family disorganization
and juvenile delinquency.
The study contain of three sections:
First: Focused on the causes of the violence.
Second: The interaction between multi factors.
Third: Social effects of family violence.

Acne scars are one of the most common problems following acne vulgaris. Despite the extensive list of available treatment modalities, their effectiveness depends upon the nature of the scar. Ablative lasers had been used to treat acne scars; one of them is the fractional CO2 laser. The aim of this study is to evaluate the outcome of fractional CO2 laser in the treatment of acne scars. Methods: Since January 2010 to June 2013, using 10600 nm fractional CO2 laser beams, the acne scar of 400 patients, 188 males and 212 females, mean age of 34 years, have been treated and classified according to severity into four grades following Goodman and Baron classification. Each patient underwent 3-5 sessions once monthly. The mean laser exposure time

Periodontal disease is typically treated with mechanical debridement of the tooth surface. It may, however, be insufficient to eradicate pathogenic microorganisms on its own. Because of the microbial etiology of periodontitis, systemic or local antibiotic therapy is used as an adjunct treatment. The present study aimed to determine the effects of curcumin gel on Porphyromonas gingivalis. Eleven patients with stage II and III periodontitis were registered in the study. A double-blinded split-mouth design followed. Periodontal pockets were distributed into 2 groups; the test group received scaling and root planing along with curcumin gel, while the control group received scaling and root planing along with a placebo gel. Plaque index,

This research aims to study the effect of microwave furnace heat on the mechanical properties and fatigue life of aluminum alloy (AA 2024-T3). Four conditions were used inside microwave furnace (specimens subjected to heat as dry for 30 and 60min. and specimens subjected to heat as wet (water) for 30 and 60 min.), and compared all results with original alloy (AA 2024-T3). Tensile, fatigue, hardness and surface roughness tests were used in this investigation. It is found that hardness of dry conditions is higher than wet conditions and it increases with increasing of time duration inside microwave furnace for dry and wet conditions. Also, tensile strength has the same behavior of hardness, but it increases with decreasing

       Swarming is one of the most important virulence factors used by bacteria to invade new sites. This study aimed to test the effects of gentamicin on swarming motility of Pseudomonas aeruginosa, both phenotypically and molecularly. The present results revealed that 11/25 isolates had gentamicin MIC of 1024 µg/ml.  However, gentamicin at sub-minimal inhibitory concentration significantly (P< 0.05) reduced the diameter of swarming in all P. aeruginosa isolates. Noticeably the mean and median swarming diameter before treatment with gentamicin 5.557 and 5.816 cm respectively had significantly (P < 0.001) reduced to 0.871 and 0.766 cm respectively. At the molecular level, amrZ (a global regulator of multiple genes) and

Pseudomonas aeruginosa has variety of virulence factors that contribute to its pathogenicity. Therefore, rapid detection with high accuracy and specificity is very important in the control of this pathogenic bacterium. To evaluate the accuracy and specificity of Polymerase Chain Reaction (PCR) assay, ETA and gyrB genes were targeted to detect pathogenic strains of P. aeruginosa. Seventy swab samples were taken from patients with infected wounds and burns in two hospitals in Erbil and Koya cities in Iraq. The isolates were traditionally identified using phenotypic methods, and DNA was extracted from the positive samples, to apply PCR using the species specific primers targeting ETA, the gene encoding for exotoxin A, and gyrB gene. The res

       Staphylococcus aureus is a common pathogenic agent due to its ability to cause various types of infections, ranging from mild skin infections to sever systemic diseases. One of the most virulence factors of this bacterium is its ability to from biofilms on solid surfaces by anchoring the planktonic cells and by producing a protective layer of extra polymeric substances. Biofilm formation is controlled through many genes. The most important ones are icaA and icaD. Dentures are prosthetic devices that are made of different materials to replace lost teeth. The aim of this study is to examine the ability of different types of denture materials to support the biofilm formation of S. aureus at phenotypic level by detecting ba

Background and aim: Pseudomonas putida is a non-capsulated, rod-shaped, oxidative, gram-negative Bacterium. The aim of the study was to isolate the pathogenic P. putida from a cow with respiratory infection and to evaluate pharmacodynamics indices of cinnamon oil against isolated bacteria in order to determine its the in vitro antibacterial efficacy for the first time in Iraq. Materials and methods: divided into two parts: first part involved the isolation and identification of pathogenic P. putida from cow with respiratory infection, swab samples were cultured on different media and examined microscopically. Results: The isolates were identified based on the production of pyoverdine dye on nutrient agar, beta-hemolysis on blood aga