In this study, zinc ferrite magnetic nanoparticles (ZnFe₂O₄, ZFO MNPs) were employed as a sorbent for the removal of oil spill from water surfaces. ZFO MNPs were synthesized via a sol-gel process and characterized by Fourier transform infrared spectroscopy (FTIR) and X-ray powder diffraction (XRD). Both the apparent density and magnetic force were determined. ZFO MNPs presented a considerable magnetic force (40.22 mN) and an adequate density (0.5287 g/cm³), which are important for the magnetic separation and flotation. Four oil samples (gasoline engine oil, crude oil, used motor oil and diesel engine oil) were used to investigate the gravimetric oil removal capability of ZFO MNPs. The oil sorption capacit

Phosphorus is usually the limiting nutrient for eutrophication in inland receiving waters; therefore, phosphorus concentrations must be controlled. In the present study, a series of jar test was conducted to evaluate the optimum pH, dosage and performance parameters for coagulants alum and calcium chloride. Phosphorus removal by alum was found to be highly pH dependent with an optimum pH of 5.7-6. At this pH an alum dosage of 80 mg/l removed 83 % of the total phosphorus. Better removal was achieved when the solution was buffered at pH = 6. Phosphorus removal was not affected by varying the slow mixing period; this is due to the fact that the reaction is relatively fast.
The dosage of calcium chloride and pH of solution play an importa

bstract         This study was performed to isolate and identify the Burkholderia cepacia from rhizosphers of different plants and study their ability to produce Siderophore, the study was also aimed to assess the antifungal activity of the bacterial filtrate and extracts of the isolates against some pathogenic fungi.     The isolate which showed higher inhibitory effects was selected for extraction of some active metabolites produced by it, and evaluate the activity in vitro, via inhibition of the growth of the fungi using different concentrations of extract (50, 100, 200 )µL/ml , The results showed that out of  (250) samples of soil , (8) isolates (3.2%) gave positive

The Escherichia coli isolated from UTIs, were identified with biochemical tests and vitek test.The ethanolic extracts of Zingiberofficinale(Z.officinale) were tested against E.coli by using the good agar diffusion test, the alcoholic extracts from (25 -100) mg/ml showed antimicrobial activity against tested microorganism. The diameter of inhibition zone increase at high concentrations and rang from (18-20mm) , and these results compared with antibiotics  sensitivity discs were used by discs diffusion method against E.coliisolates, they were resisted to all antibiotics used in this study. It could be concluded that alcoholic extract of Z.officinalehad good antimicrobial effects, and may be able to use for treatment UTIs caused by E.c

The adhesion strength between Polyethylene (PE) film and Aluminum surface by using the adhesive material (Cyanoacrylate) has been studied. Aluminum (Al) was used as a substrate, and polyethylene (PE) was used as a film adhered to the Al surface. Standard specimens were prepared to use in the peeling test in dry condition, other specimens were immersed in water for 12 days at room temperature. the results for the specimens in the dry condition had shown that high value in the peel force and the peel energy, the peel force was 0.38*103 N/m and the peel energy was 0.605*103 N/m, peeling the film from Al surface leaves a residual of the adhesive material on both adherend, the failure for this specimen were combination of adhesive and cohesive f

In the current study, synthesis and characterization of silver nanoparticles (AgNPs) before and after functionalization with ampicillin antibiotic and their application as anti-pathogenic agents towards bacteria were investigated. AgNPs were synthesized by a green method from AgNO3 solution with glucose subjected to microwave radiation. Characterization of the nanoparticles was conducted using UV-Vis spectroscopy, scanning electron microscopy (SEM), zeta potential determination and Fourier transform infrared (FTIR) spectroscopy. From SEM analysis, the typical silver nanoparticle particle size was found to be 30 nm and Zeta potential measurements gave information about particle stability. Analysis of FTIR patterns and UV-VIS spectroscopy con