Background Mirabegron is a β3-adrenergic receptor (β3-AR) agonist indicated for the treatment of overactive bladder. β3-AR agonists are located in the urinary bladder and adipose tissue, where they are involved in the regulation of thermogenesis and lipolysis. Objective To evaluate the effect of mirabegron on lipid profile (serum cholesterol and triglyceride) and BMI in patients with OAB. Materials and Methods In the medical city complex (Ghazi AL-Hariri Hospital) urology outpatient clinic, a prospective study of 40 patients diagnosed with OAB. These patients took a single dose of mirabegron 50 mg for 4 months and assessed its effect during this period on weight and fasting serum (s.) cholesterol and triglycerides. Results Investigation showed that there is a statistically significant reduction from baseline after 2 and 4 months of treatment with mirabegron (P-value = 0.001) in fasting s. Triglyceride, while fasting s. cholesterol level showed an increase in level after 2 and 4 months of treatment. However, this increment not statically significant after 2 months (P-value = 0.227) and after 4 months (P-value = 0.261) BMI showed slightly reduction after 2 and 4 months’ treatment with mirabegron but also this reduction not statically significant after 2 months (P-value = 0.114) and after 4 months (P-value = 0.562). Conclusion Mirabegron causes an interesting and useful decline in the level of triglyceride, which is responsible for cardiovascular disease.
In this study, the photodegradation of Congo red dye (CR) in aqueous solution was investigated using Au-Pd/TiO2 as photocatalyst. The concentration of dye, dosage of photocatalyst, amount of H2O2, pH of the medium and temperature were examined to find the optimum values of these parameters. It has been found that 28 ppm was the best dye concentration. The optimum amount of photocatalyst was 0.09 g/75 mL of dye solution when the degradation percent was ~ 96 % after irradiation time of 12 hours, while the best amount of hydrogen peroxide was 7μl/75 mL of dye solution at degradation percent ~97 % after irradiation time of 10 hours, whereas pH 5 was the best value to carry out the reaction at the highest degradation percent. In additio
... Show MoreThis study investigated the bioethanol production from green algae Chlorella vulgaris depending on its carbohydrate-enriched biomass. Four different phosphorous concentrations were employed to stimulate bioethanol production from Chlorella vulgaris. The impact of various phosphorous values on Chlorella vulgaris growth rate as well as primary product (carbohydrate) were evaluated. High performance liquid chromatography was utilized in this work. The stationary phase was identified as day 14, 12, 10 and 6 in treatments 6, 4, 2 and g/L, respectively. The findings suggest that the treatment without phosphorous addition had the highest record of carbohydrate content (22.64% dry weight) as well as the highest bioethanol yield (20.66% dry weight).
... Show MoreThis study used deep eutectic solvent (DES) as the liquid membrane in a bulk liquid membrane system (BLM) to remove glycerol from waste cooking oil‐based biodiesel. The DES was prepared from choline chloride and tetraethylene glycol at a molar ratio of 1:5. Diethyl ether was employed as a novel strip phase for the glycerol in BLM. The effects of the DES: biodiesel ratio, stirring speed, and extraction time on the extraction and stripping efficiencies were investigated. The results showed that BLM could give better glycerol removal from biodiesel than mechanical shaking. Increasing the DES: biodiesel ratio, stirring speed, and extraction time can enhance glycerol removal from the feed phase, achievi
In this study, the photodegradation of Congo red dye (CR) in aqueous solution was investigated using Au-Pd/TiO2 as photocatalyst. The concentration of dye, dosage of photocatalyst, amount of H2O2, pH of the medium and temperature were examined to find the optimum values of these parameters. It has been found that 28 ppm was the best dye concentration. The optimum amount of photocatalyst was 0.09 g/75 mL of dye solution when the degradation percent was ~ 96 % after irradiation time of 12 hours, while the best amount of hydrogen peroxide was 7μl/75 mL of dye solution at degradation percent ~97 % after irradiation time of 10 hours, whereas pH 5 was the best value to carry out the reaction at the highest degradation percent. In additio
... Show More