A mathematical model was proposed to study the microkinetics of esterification reaction of oleic acid with ethanol over prepared HY zeolite catalyst. The catalyst was prepared from Iraqi kaolin source and its properties were characterized by different techniques. The esterification was done under different temperature (40 to 70˚C) with 6:1 for molar ratio of ethanol to oleic acid and 5 % catalyst loading. The microkinetics study was done over two period of time each period was examined individually to calculate the reaction rate constant and activation energy. The impact of the mass transfer resistance to the reactant was also investigated; two different studies have been accomplished to do this purpose. The effect of the external mass transfer resistance was studied by exploring different stirring speed (400 to 800 rpm). The results show that, the oleic acid conversion increase with increasing the stirring speed until reached 600 rpm, after this rpm the conversion doesn’t increase significantly, which mean that, the effect of external mass transfer resistance was eliminated. The activation energy for the first period is equal to 41.84 kJ/mol while in the second period is equal to 52.03 kJ/mol. The Thiele modulus calculation results show that there is no effect of mass transfer on the reaction inside the catalyst pores.
The finite element method has been used in this paper to investigate the behavior of precast reinforced concrete dapped-ends beams (DEBs) numerically. A parametric investigation was performed on an experimental specimen tested by a previous researcher to show the effect of numerous parameters on the strength and behavior of RC dapped-end beams. Reinforcement details and steel arrangement, the influence of concrete compressive strength, the effect of inclined load, and the effect of support settlement on the strength of dapped-ends beams are examples of such parameters. The results revealed that the dapped-end reinforcement arrangement greatly affects the behavior of dapped end beam. The failure load decreases by 25% when
... Show MoreKey words:Jasminumsambac, Volatile oil, Antioxidant.
This study concerned with phytochemical investigation and methods of extraction and separation of active constituents from Valeriana officinalis plant cultivated in Iraq. Due to the large number of active constituents in Valeriana officinalis, it was necessary to make analytical study of its constituents to determine the chemical nature of these constituents and then determine the main classes (terpenes and iridoids) using chemical reagents specific for each class. Different organic solvents like ethanol (70%) used in soxhlet apparatus and hexane, ethyl acetate and methanol were used separately to extract the main active constituents by maceration. Through comparison between these solvents using thin layer chromatograph
... Show MoreThe aim of this study to investigate the tongue morphology and histology in house gecko Hemidactylus flaviviridis using light and scanning electron –microscopy (SEM ) technique.The morphology result revealed the presence of three parts : apex , body and lingual root .The light microscopy result showed that the tongue is covered with mucous membrane composed of non keratinized stratified squamous epithelium based on lamina propria which contain bundles of striated muscles its fibers in different directions including connective tissue , blood vessels and nerves. The lingual mucosa of the dorsal surface is covered with different pattern of lingual papillae which are widely distributed all over the dorsal surface except the apex. Noticed on t
... Show MoreThe adsorption of Malonic acid, Succinic acid, Adipic acid, and Azelaic acid from their aqueous solutions on zinc oxide surface were investigated. The adsorption efficiency was investigated using various factors such as adsorbent amount, contact time, initial concentration, and temperature. Optimum conditions for acids removal from its aqueous solutions were found to be adsorbent dose (0.2 g), equilibrium contact time (40 minutes), initial acids concentration (0.005 M). Variation of temperature as a function of adsorption efficiency showed that increasing the temperature would result in decreasing the adsorption ability. Kinetic modeling by applying the pseudo-second order model can provide a better fit of the data with a greater correla
... Show MoreThis paper discusses a comparative study to relate parametric and non-parametric mode decomposition algorithms for response-only data. Three popular mode decomposition algorithms are included in this study: the Eigensystem Realization Algorithm with the Natural Excitation Technique (NExT-ERA) for the parametric algorithm, as well as the Principal Component Analysis (PCA) and the Independent Component Analysis (ICA) for the non-parametric algorithms. A comprehensive parametric study is provided for (i) different response types, (ii) excitation types, (iii) system damping, and (iv) sensor spatial resolution to compare the mode shapes and modal coordinates of using a 10-DOF building model. The mode decomposition results are also compared using
... Show MoreThe main parameters and methods influencing the removal of Gentian Violet (GV) dye from aqueous media were investigated using a stachy plant in this study. The surface of the stachy plant was determined using FTIR spectra. Adsorption is influenced by the adsorbent's characteristic groups. The research took into account the usual conditions for GV dye adsorption by the stachy plant, such as the impact of contact time. Mass dosage , after 0.3 g the amount of adsorbed dye declines. Study pH and ionic strength, the results obtained showed that at pH 3 the largest adsorption of (GV) was seen, while at pH 9, the lowest adsorption was observed at 298 K, the adsorption kinetics and equilibrium constants were achieved, and the equilibr
... Show MoreThe Corrosion protection effectiveness of Alimina(Al2O3,50nm)and Zinc oxide (ZnO,30nm) nanoparticales were studied on carbon steel and 316 stainless steel alloys in saline water (3.5%NaCl)at four temperatures: (20,30,40,50 OC)using three electrodes potentiostat. An average corrosion protection efficiencies of 65 %and 80% was achieved using Al2O3 NP's on carbon steel and stainless steel samples respectively, and it seems that no effect of rising temperature on the performances of the coated layers. While ZnO NP'S showed protection efficiency around 65% for the two alloys and little effected by temperature rising on the performanes of the coated layers. The morphology of the coated spesiemses was examined by Atomic force microscope.