Preferred Language
Articles
/
joe-966
Petrophysical Analysis of an Iraqi Gas Field (Mansuriya Gas Field)
...Show More Authors

Mansuriya Gas field is an elongated anticlinal structure aligned from NW to SE, about 25 km long and 5-6 km wide. Jeribe formation is considered the main reservoir where it contains condensate fluid and has a uniform thickness of about 60 m. The reservoir is significantly over-pressured, (TPOC, 2014).

This research is about well logs analysis, which involves the determination of Archie petrophysical parameters, water saturation, porosity, permeability and lithology. The interpretations and cross plots are done using Interactive Petrophysics (IP) V3.5 software.

The rock parameters (a, m and n) values are important in determining the water saturation where (m) can be calculated by plotting the porosity from core and the formation factor from core on logarithmic scale for both and the slope which represent (m) then Pickett plot method is used to determine the other parameters after calculating Rw from water analysis .

The Matrix Identification (MID), M-N and Density-Neutron crossplots indicates that the lithology of Jeribe Formation consists of dolomite, limestone with some anhydrite also gas-trend is clear in the Jeribe Formation.

The main reservoir, Jeribe Formation carbonate, is subdivided into 8 zones namely  J1 to J8, based mainly on porosity log (RHOB and NPHI) trend, DT trend and saturation trend.

 Jeribe formation was considered to be clean in terms of shale content .The higher gamma ray because of the uranium component which is often associated with dolomitisationl and when it is removed and only comprises the thorium and potassium-40 contributions, showed the gamma response to be low compared to the total gamma ray response that also contains the uranium   contribution.While the Jeribe formation is considered to be clean in terms of shale content so the total porosity is equal to the effective porosity.No porosity cut off is found if cutoff permeability 0.01 md is applied while the porosity cut off approximately equal to 0.1 only for unit J6 & J8 if cutoff permeability 0.1 md is applied .

It can be concluded that no saturation cutoff for the units of Jeribe formation is found after a cross plot between water saturation and log porosity for the reservoir units of Jeribe formation and applied the calculated cut off porosity.

The permeability has been predicted using two methods: FZI and Classical, the two methods yield approximately the same results for all wells.

Crossref
View Publication Preview PDF
Quick Preview PDF
Publication Date
Thu Feb 07 2019
Journal Name
Journal Of The College Of Education For Women
The Role of Military institution in the Nigerian Political life
...Show More Authors

The intervention in the military institute represents a great role in the Nigerian
political life since 1960. There are many reasons behind this domination. The First is that
many African militants participated in liberating their countries from colonization. The
second is that they tried to stay in power as long as they could stay through the rule of one
party.
There fore, they depend on the process of political and economic reform to get rid of
military rule that dominated the Nigerian Political life to be a civilian state

View Publication Preview PDF
Publication Date
Thu Jan 12 1995
Journal Name
مجلة العلوم الزراعية العراقية 26 (1), 88-92
The Possible Use Of Pollen Radiation in Date Palm Breeding‏
...Show More Authors

Publication Date
Sun Dec 07 2014
Journal Name
Baghdad Science Journal
Corrosion Behavior of Copper and Carbon Steel in Acidic Media
...Show More Authors

The corrosion behavior of copper and carbon steel in 1M concentration of hydrochloric acid (HCl) and sulphuric acid (H2SO4) has been studied. The corrosion inhibition of copper and carbon steel in 1M concentration of hydrochloric acid (HCl) and sulphuric acid (H2SO4) by Ciprofloxacin has been investigated. Specimens were exposed in the acidic media for 7 hours and corrosion rates evaluated by using the weight loss method. The effect of temperature (from 283 ºK to 333 ºK), pH (from 1to 6), inhibitor concentration (10-4 to 10-2) has been studied. It was observed that sulphuric acid environment was most corrosive to the metals because of its oxidizing nature, followed by hydrochloric acid. The rate of metal dissolution increased with incre

... Show More
View Publication Preview PDF
Crossref (2)
Crossref
Publication Date
Fri Nov 19 2010
Journal Name
مجلة جامعة كربلاء
Interaction of Cysteine in aqueous Dimethylformamide solution at deferent temperatures
...Show More Authors

Publication Date
Mon Jul 01 2013
Journal Name
Journal Of Engineering
Behavior of Reinforced Gypseous Soil Embankment Model under Cyclic Loading
...Show More Authors

The construction of embankment for roadway interchange system at urban area is restricted due to the large geometry requirements, since the value of land required for such construction is high, and the area available is limited as compared to rural area. One of the optimum solutions to such problem is the earth reinforcement technique which requires a limited area for embankment construction. Gypseous soil from Al-Anbar governorate area was obtained and subjected to various physical and chemical analysis to determine it is properties. A laboratory model box of 50x50x25 cm was used as a representative embankment; soil has been compacted in five layers at maximum dry density (modified compaction) and an aluminum reinforcement strips we

... Show More
Publication Date
Wed Jan 09 2002
Journal Name
Journal Of Pharmaceutical Negative Results¦ Volume
Antibacterial Improvement of Disease-Protective Face Masks Using Gold Nanoparticles
...Show More Authors

In this work, the antibacterial effectiveness of face masks made from polypropylene, against Candida albicans and Pseudomonas aeruginosa pathogenic was improved by soaking in gold nanoparticles suspension prepared by a one-step precipitation method. The fabricated nanoparticles at different concentrations were characterized by UV-visible absorption and showed a broad surface Plasmon band at around 520 nm. The FE-SEM images showed the polypropylene fibres highly attached with the spherical AuNPs of diameters around 25 nm over the surfaces of the soaked fibres. The Fourier Transform Infrared Spectroscopy (FTIR) of pure and treated face masks in AuNPs conform to the characteristics bands for the polypropylene bands. There are some differences

... Show More
Scopus (2)
Scopus
Publication Date
Wed Mar 18 2020
Journal Name
Baghdad Science Journal
Identification of Cladosporium sp. Fungi by in- silico RFLP-PCR
...Show More Authors

Cladosporium sp. plays an important role in human health, it is one of the pathogenic fungi which cause allergy and asthma and most frequently isolated from airborne spores.  In this study, a couple of universal PCR primers were designed to identify the pathogenic fungi Cladosporium sp. according to conserved region 5.8S, 18S and 28S subunit ribosomal RNA gene in Cladosporium species. In silico RFLP-PCR were used to identify twenty-four Cladosporium strains. The results showed that the universal primer has the specificity to amplify the conserved region in 24 species as a band in virtual agarose gel. They also showed that the RFLP method is able to identify three Cladosporium spe

... Show More
View Publication Preview PDF
Scopus (7)
Crossref (2)
Scopus Clarivate Crossref
Publication Date
Sun Dec 30 2018
Journal Name
Advances In Remote Sensing And Geo Informatics Applications
Correlation Between Surface Modeling and Pulse Width of FWF-Lidar
...Show More Authors

View Publication
Scopus Clarivate Crossref
Publication Date
Wed May 01 2019
Journal Name
Iraqi Journal Of Science
Fabrication and Study of Nano catalysis for Alkaline Fuel Cell
...Show More Authors

Preview PDF
Scopus
Publication Date
Sat Mar 30 2013
Journal Name
Iraqi Journal Of Chemical And Petroleum Engineering
Theoretical Study on Heat Transfer in the Presence of Fouling
...Show More Authors

The fouling depositions of crude oil stream were studied theoretically in a shell and tube heat exchanger to investigate the effect of depositions on the heat transfer process. The employed heat exchanger was with steam flowing in the inner tubes and crude oil in the shell at different velocities and bulk temperatures. It is assumed that fouling occurs only on the heated stream side (crude oil). The analysis was carried out for turbulent flow heat transfer conditions with wide range of Reynolds number, bulk temperature and time. Many previously proposed models for fouling resistance were employed to estimate a new model for fouling rate. It is found that the fouling rate and consequently the heat transfer coefficient were affected by Rey

... Show More
View Publication Preview PDF