As the temperature of combustion gases is higher than the melting temperature of the turbine materials, cooling of turbine parts in a gas turbine engine is necessary for safe operation. Cooling methods investigated in this computational study included cooling flow losses. Film-cooling is one typically used cooling method whereby coolant is supplied through holes passage, in present study the holes placed along the camber line of the blade. The subject of this paper is to evaluate the heat transfer that occur on the holes of blade through different
blowing coolant rates. The cases of this study were performed in a low speed wind tunnel with two tip gap at small and large (0.03 and 0.09cm) and multiple coolant flow rates through the film-cooling holes. The
blowing ratios was studied whereby coolant was injected from holes placed along the tip of a large scale blade model with Reynolds number (2.1 x 105 ) of the engine was matched. Results showed that baseline
Nusselt numbers on the holes were reduced along the holes passage, and heat transfer coefficient is high values at iterance region. Overall, the cooling by holes appears to be a feasible method for prolonging blade life.
This research is presenting a study of optical and structural properties of (Fe2O3)1-x(MgO)x composites synthesized as thin film that can be used as a gas sensor. Pulsed laser deposition technique was used to prepare thin films of (Fe2O3)1-x(MgO)x. The pattern of X-ray diffraction of the composites powder showed the consistency of iron oxide (α-Fe2O3) hematite phase along with the planes (104) and (110) as preferred planes for crystal growth where the intensities of which varied with MgO content. The crystal size of the thin film material was varied in between (26.8-35.1) nm. The diffraction pattern of the pulsed laser deposited thin films was absent from any diffraction peaks. The maximum transparency obtained of hematite
... Show MoreThe present research was conducted to reduce the sulfur content of Iraqi heavy naphtha by adsorption using different metals oxides over Y-Zeolite. The Y-Zeolite was synthesized by a sol-gel technique. The average size of zeolite was 92.39 nm, surface area 558 m2/g, and pore volume 0.231 cm3/g. The metals of nickel, zinc, and copper were dispersed by an impregnation method to prepare Ni/HY, Zn/HY, Cu/HY, and Ni + Zn /HY catalysts for desulfurization. The adsorptive desulfurization was carried out in a batch mode at different operating conditions such as mixing time (10,15,30,60, and 600 min) and catalyst dosage (0.2,0.4,0.6,0.8,1, and 1.2 g). The most of the sulfur compounds were removed at 10 min for all catalyst types. The maximum
... Show More
Background Green synthesis of silver nanoparticles (AgNPs) using plant extracts has gained increasing attention as an environmentally friendly alternative to conventional chemical methods.
orphological changes, represented by erosion and sedimentation, are a natural phenomenon that occurs in most river estuaries, causing changes in waterways and affecting offshore structures. One of these estuaries is the Shatt Al-Arab River estuary, which is the main waterway for trade and a major outlet for oil exports, is suffering from these changes. Moreover, the Thalweg Line, which is the deepest point within the estuary, forms the international border between Iraq and Iran. This line is moving at some rate towards the Iraqi land. To understand the process of erosion and sedimentation within the Shatt Al-Arab River estuary, a hydraulic mathematical simulation by using both HEC RAS and ANSYS Software. The HEC RAS was used to simulate the
... Show MoreA Schiff base ligand (L) was used as primary ligand and potassium anthranilate (Anth) was used as the secondary ligand in the molar ratio M: L:2Anth to synthesize a new platinum(IV) mixed-ligand complex [Pt(L)(Anth)₂]Cl₂. The Schiff base ligand was synthesized by the condensation of 4-Aminoantipyrine with 4-Hydroxybenzaldehyde and was verified as a bidentate ligand. The UV-visible, FT-IR, 1 H NMR, 13 C NMR, CHN elemental analysis, molar conductance, chloride ion determination and melting point measurements were used to characterize the ligand and the complex. The results of the molar conductance showed that the electrolytic behavior was 1:2, where the two chloride ions were present outside the coordination sphere, while the spectroscopi
... Show MoreAmong the many modern skill-enhancing work practices, machine learning is among the mostskill-enhancing practices in the workplace, as it helps students remember more of what they havelearned, hone the technical talents and skills of football players, and make better use of theirmotor skills. The use of machine learning and its practical applications in football could havesignificant benefits by improving talent development and making better use of scientifictechniques. The primary objective of this study was to determine the effectiveness of machinelearning in improving soccer dribbling and passing accuracy in children aged 10-12 years. Thestudy authors hypothesized that soccer players in the Al-Zohour Neighborhood Youth Forumwould greatly
... Show MoreThis paper depends on sheding some litgt on the characteristics of political
relations between the arab and the Persian during the reign of sassane kings.
"Ardashir the first, shahbour the first, shahbour the second, Bahram the fifth; kisra
Anushrwan and kisrah abruis"
And who rulled the Persian before the Islamic conquest and were adopted in this studym
as a model. It was possible to get some information from invaluable refereces in order to
arrive at a clear image as regards the nature of these relations. These relations were
differently political according to the circumstances of ruling, interests and the personality
of those kings.