Preferred Language
Articles
/
joe-101
Two – Dimensional Mathematical Model to Study Erosion Problem of Tigris River Banks at Nu’maniyah
...Show More Authors

The high and low water levels in Tigris River threaten the banks of the river. The study area is located on the main stream of Tigris River at Nu’maniyah City and the length of the considered reach is 5.4 km, especially the region from 400 m upstream Nu’maniyah Bridge and downstream of the bridge up to 1250 mwhich increased the risk ofthe problemthat itheading towardsthe streetand causingdanger tonearbyareas.

The aim of this research is to identify the reason of slope collapse and find proper treatments for erosion problem in the river banks with the least cost. The modeling approach consisted of several steps, the first of which  is by using “mini” JET (Jet Erosion Test) device provides a simple method of measuring scour depth with the time for the riverbank and finding values of critical shear stress and erodibility factor for ten soil samples taken from right bank and bottom of Tigris River; the second of which involved setting up a static BSTEM software for two models (with and without treatment), then calculating the erosion amounts and factor of safety for the ten soil samples; the third approach involved implementing a two dimensional RMA2 to simulate four scenarios to find  the velocity, water depth, and water surface elevation distributions for two models (with and without treatment). Therefore, observed erosion in other discharges in natural case near the right bank [especially at cross section that are located in Tigris River at Nu’maniyah City from 500 m upstream Nu’maniyah Bridge and cross section that are located from 1800 m downstream Nu’maniyah Bridge] is high because of high erodibility coefficient in those cross sections that  causes high erosion. Also, failure occurs in natural case of Tigris River at Nu’maniyah City  because of erosion near the right bank and does not occur because of slope stability failure for right bank where the range of the velocities near the right bank for the study area for most discharges is  between 0.67 and 0.91 m/s. In addition to experimental work using "mini" JET device shows high erodibility coefficient in those cross sections  and (2+900)  which confirms that this device is  very good indicator for the possibility of bank scour. The velocities upstream of the island and near the right bank in the study area are between 0.64 and 1.47 m/s, while downstream of the island is between 0.64 and 1.04 m/s. In addition to soil of Tigris River right bank at Nu’maniyah is silty soil, the scour velocity is higher than 0.5 m/s, therefore the right bank is safe against scour only when the discharges of Tigris River are less than 500 m3/s. Thus, vegetation is unsafe treatment on right bank of Tigris River at Nu’maniyah City. The velocity causes removal of plants since treatment for river bank is 0.61 m/s where velocities near bank at most discharges are higher than this limit. Thus, treatment by riprap is the proper choice on the right bank of Tigris River at Nu’maniyah City because its cost with maintenance is 2 billion IQD less than gabion treatment in addition to velocity reduction ratio along the right bank by riprap ranges from 15% to 85%, while velocity reduction ratio along the right bank by gabion ranges from 8% to 25%, respectively.

 

View Publication Preview PDF
Quick Preview PDF
Publication Date
Wed Jan 01 2020
Journal Name
Pakistan Journal Of Agricultural Sciences
Pakistan Journal of Agricultural Sciences
...Show More Authors

View Publication
Crossref (6)
Crossref
Publication Date
Mon Jun 30 2008
Journal Name
Iraqi Journal Of Chemical And Petroleum Engineering
Simulation of Wiped Film Evaporator
...Show More Authors

A mathematical model and associated computer program were developed to simulate the steady state operation of wiped film evaporators for the concentration of glycerol-water solution. In this model, various assumptions were made to facilitate the mathematical model of the wiped film evaporator. The fundamental phenomena described were: sensible heating of the solution and vaporization of water. Physical property data were coded into the computer program, which performs the calculations of this model. Randomly selected experiments were carried out in a small scale wiped film evaporator from ALVAL COMPANY, using different concentrations of the glycerol solution (10, 30 and 50 Wt. %) for different feed rates (30, 50, 80, 100 and 120 l/h) and

... Show More
View Publication Preview PDF
Publication Date
Sun Mar 30 2008
Journal Name
Iraqi Journal Of Chemical And Petroleum Engineering
Characteristic Performance of Deionized Columns
...Show More Authors

The reclamation of makeup water is studied in terms of breakthrough time (i.e., the leakage of the cations). Makeup water was subjected to lab-scale ion exchangers of two types: strong acid cation and weak base anion exchanger. The experimental investigation was directed to study the ion exchanger performance in terms of four different parameters (i.e., copper concentration, total dissolved solids (TDS), feed rate and bed depth). Box-Wilson composite rotatable design was adopted in designing the experiments. Breakthrough times of the effluent stream are measured in terms of copper concentration of 2 to 25 ppm, TDS concentration of 250 to 1250 ppm, feed rate of 0.38 to 5.34 l/h and bed depth of 5 to 70 cm. Simulation the effect of the stu

... Show More
View Publication Preview PDF
Publication Date
Sun Dec 02 2012
Journal Name
Baghdad Science Journal
Bacterial Colonization of Burn Wounds
...Show More Authors

The objective behind this work was to find out the bacteriological profile of post burn infections in wound. The study was carried out from December 2010 to February 2011 at the Burns Unit of Al –Kindy Hospital and Al-Yarmook Hospital in Baghdad. Sixty burn patients have been investigated for bacterial profile of burn wound infections. Specimens were collected in the form of wound swabs. The organisms were isolated and identified by standard microbiological methods. Antimicrobial susceptibility test has been done by ATB-PSE5 kit(BioMereiux). Pseudomonas aeruginosa 35(58.3 %) was found to be the most common isolate followed by Klebsiella pneumonae 10(16.6%), Staphylococcus aureus 7(10%). ,E.coli 3(5%), Proteus merabilis 1(1.6 %), others 2

... Show More
View Publication Preview PDF
Crossref (2)
Crossref
Publication Date
Mon Apr 01 2013
Journal Name
International Journal Of Mathematical Archive
ON GROUPS OF GEOMETRIC FIGURES
...Show More Authors

In this paper we introduce the basic of definitions of groups for geometric figures; we describe some of geometric figures by using the properties of groups. The classification of some geometric figures by using the properties of some algebraic structures.

Publication Date
Mon Apr 01 2019
Journal Name
Journal Of Engineering
Characteristics of Paper-cement Composite
...Show More Authors

This study “discusses the benefit of “addition waste paper as a “new cellulose material “in mortar mixes. A partial addition of waste paper by cement weight was achieved to produce cement composite mortar.  Pulp and paper is the third major industrial dumper of air, soil and water. In recent year, paper and paperboard constitute a greater portion of many countries’ urban solid discarded generation. Beside, it increases characteristic “strength due to existence “of hydrogen links “in the microstructure of “paper. Furthermore, it consume “better thermal protection. The addition percentages “of waste paper used “in this work were (5%, 10%, 15% and 20%) by “mass of cement to measure and evaluat

... Show More
View Publication Preview PDF
Crossref (8)
Crossref
Publication Date
Sun Mar 19 2023
Journal Name
Journal Of Educational And Psychological Researches
Communicative Competence of University Students
...Show More Authors

Abstract

The current research aims to identify the communicative competence of university students, to identify the levels of communicative competence among university students and which of these levels are more common, and to identify the significance of differences in communicative competence among university students according to the variables of gender and specialization. The study population consisted of (782) male and female students, as the statistical analysis sample was limited to (400) male and female students to extract the psychometric properties of the current research tool. The study sample included (382) male and female students at the University of Baghdad who were chosen by the stratified random

... Show More
View Publication Preview PDF
Publication Date
Thu Mar 16 2017
Journal Name
Journal Of Translation Studies
Problems of Translating Computer Collocations
...Show More Authors

Publication Date
Sun Feb 10 2019
Journal Name
Journal Of The College Of Education For Women
The Geopolitical Problems of Eritrea
...Show More Authors

The subject of multi- ethnics is one of the most important subjects in the study of political
geography, as multi- ethnics and its consequent problems are global geopolitical phenomena
that started early and reached its peak with the beginning of the twentieth century, because of
major changes in the political landscape that resulted by wars and led to the collapse of many
empires and major powers, a matter which led to put new political maps according to certain
considerations of the colonial powers, especially in Africa and Asia. All these things led to
the most serious challenges based on ethnic and sectarian conflict and led to the development
of geopolitical problems. Among the examples what most countries in th

... Show More
View Publication Preview PDF
Publication Date
Tue Jun 01 2010
Journal Name
Al-khwarizmi Engineering Journal
Enhancement of Hoisting System Performance
...Show More Authors

In this paper it is required to enhance the performance of a mechanical system (here: a Hoisting System) where it is preferred to lift a different payloads with approximately the same speed of lifting and keeping at the same time the good performance, and this of course needs some intelligence of the system which will be responsible on measuring the present load and taking into account the speed and performance desired in order to achieve the requirements or the criteria. The process therefore is a Mechatronics System design which includes a measuring system, a control or automation technique, and an actuating system. The criteria built here in this research using a given Hoist system's characteristics and parameters and changing one of

... Show More
View Publication Preview PDF