In order to evaluate the performance of introduced varieties of maize and test them under different levels of plant density, and to determine which of the introduced varieties give a high yield and at what plant density, a field experiment was carried out at Station A in the Department of Field Crops- College of Agricultural Engineering Sciences - University of Baghdad- Jadiriyah, for the fall season 2021, the RCBD design was used with four replications, in a split plot arrangement, the three plant densities (50.000, 70.000, and 90.000 Plant s ha-1) were the main plates, while the varieties represented the secondary factor, which is six varieties of maize, class 2 = 5783 DKC, Class 3 = 6315 DKC, Class 4= 6590 DKC, which are introduced and compared with three local varieties: Fajr, Sarah and Al-Maha, The traits of yield components (the ear length, the number of rows ear-1, the number of grains row-1, the number of grains ear-1, the number of ears, the weight of 100 grain) and their relationship to the plant yield were studied, The plant density significantly affected all the studied traits except for the number of ears, it was not significant. Low plant density outperformed the highest plant yield (157.2 g) due to its superiority in ear length, number of rows ear-1, number of grains row-1, number of grains ear-1 and weight of 100 grains. The plant over the local varieties, especially variety 3, which gave the highest plant yield (168.2 g), followed by variety 4 (155.4 g), due to their superiority in ear length, number of grains row-1, number of grains ear-1, number of ears, and weight of 100 grains. The interaction between varieties and plant density was significant in all studied traits. We suggest planting the introduced varieties at different planting dates and locations to show their ability to environmentally imprint Iraq's climate and study them in the spring season, and test them under other abiotic stresses such as drought.
In any language there is some amount of difference between written language (planned) and spoken language (spontaneous). Since planned speech could be considered a form of written language, it could be inferred that there are also differences between planned speech and spontaneous speech. Some of these differences are very clear in terms of syntax, lexis, phonology and discourse. These differences are highlighted in order to make a clear distinction between spontaneous and planned speech.
This paper is an attempt to show the differences between the two forms of a language (written & spoken English) as far as number of linguistic features are tackle
... Show MoreAn experimental study was performed to estimate the forced convection heat transfer performance and the pressure drop of a single layer graphene (GNPs) based DI-water nanofluid in a circular tube under a laminar flow and a uniform heat flux boundary conditions. The viscosity and thermal conductivity of nanofluid at weight concentrations of (0.1 to 1 wt%) were measured. The effects of the velocity of flow, heat flux and nanoparticle weight concentrations on the enhancement of the heat transfer are examined. The Nusselt number of the GNPs nanofluid was enhanced as the heat flux and the velocity of flow rate increased, and the maximum Nusselt number ratio (Nu nanofluid/ Nu base fluid) and thermal performance factor
... Show MoreMassive multiple-input multiple-output (massive-MIMO) is considered as the key technology to meet the huge demands of data rates in the future wireless communications networks. However, for massive-MIMO systems to realize their maximum potential gain, sufficiently accurate downlink (DL) channel state information (CSI) with low overhead to meet the short coherence time (CT) is required. Therefore, this article aims to overcome the technical challenge of DL CSI estimation in a frequency-division-duplex (FDD) massive-MIMO with short CT considering five different physical correlation models. To this end, the statistical structure of the massive-MIMO channel, which is captured by the physical correlation is exploited to find sufficiently
... Show More
(5)
(5)
(3)
(4)
(14)
(1)