A total of 116 males with primary infertility and 32 fertile males (normozoospermia;
NOR) were studied to evaluate parameters of seminal fluid analysis. Based on WHO criteria
of 2010 for general seminal fluid analysis, the patients were distributed into three groups: 32
azoospermic (AZO), 40 oligozoospermic (OLI) and 44 asthenozoospermic (AST) patients.
AZO and OLI patients and NOR shared an approximated mean of seminal fluid volume (2.25,
2.75 and 2.50 ml, respectively), while it was significantly increased (3.58 ml) in AST patients.
In NOR men, the spermatozoa concentration was 65.13 x 10
6
spermatozoa/ml, while it was
significantly decreased in AST (51.42 x 10
6
spermatozoa/ml) and OLI (5.58 x 10
6
spermatozoa /ml) patients. The percentage frequency of progressive motility was significantly
decreased in OLI and AST patients as compared to NOR (9.6 and 16.3, respectively vs.
50.6%). In contrast, the non-progressive motile (45.4 and 30.4, respectively vs. 21.9%) or
immotile (45.0 and 52.5, respectively vs. 27.5%) spermatozoa were significantly increased in
the patients. OLI and AST patients shared an approximated mean of abnormal spermatozoa
frequency (56.7 and 58.3%, respectively), but both frequencies were significantly higher than
the observed frequency in NOR (23.1%).
(1)
The objective of this work is to investigate the performance of a conventional three phase induction motor supplied by unbalanced voltages. An effort to study the motor steady state performance under this disturbance is introduced. Using per phase equivalent circuit analysis with the concept of symmetrical components approach, the steady state performance is theoretically calculated. Also, a model for the induction motor with the MATLAB/Simulink SPS tools has been implemented and steady state results were obtained. Both results are compared and show good correlation as well. The simulation model is introduced to support and enhance electrical engineers with a complete understanding for the steady state performance of a fully loaded induc
... Show MoreAbstract
This work involves studying the effect of adding some selective organic component mixture on corrosion behavior of pure Al and its alloys in condensed synthetic automotive solution (CSAS) at room temperature. This mixture indicates the increasing of octane number in previous study and in this study show the increasing in corrosion resistance through the decreasing in corrosion rate values.
Electrochemical measurements were carried out by potentiostat at 3 mV/sec to estimate the corrosion parameters using Tafel extrapolation method, in addition to cyclic polarization test to know the pitting susceptibility of materials in tested medium.
The cathodic Tafel slope
... Show MoreInefficient wastewater disposal and wastewater discharge problems in water bodies have led to increasing pollution in water bodies. Pollutants in the river contribute to increasing the biological oxygen demand (BOD), total suspended solids (SS), total dissolved solids (TDS), chemical oxygen demand (COD), and toxic metals render this water unsuitable for consumption and even pose a significant risk to human health. Over the last few years, water conservation has been the subject of growing awareness and concern throughout the world, so this research focused on review studies of researches that studied the importance of water quality of wastewater treated disposal in water bodies and modern technology to management w
... Show More
Fiber Reinforced Polymer (FRP) bars are anisotropic in nature and have high tensile strength in the fiber direction. The use of High-Strength Concrete (HSC) allows for better use of the high-strength properties of FRP bars. The mechanical properties of FRP bars can yield to large crack widths and deflections. As a result, the design of concrete elements reinforced with FRP materials is often governed by the Serviceability Limit States (SLS). This study investigates the short-term serviceability behavior of FRP RC I-beams. Eight RC I-beams reinforced with carbon-FRP (CFRP) and four steel RC I-beams, for comparison purposes, were tested under two-point loading.
Deformations on the concrete and crack widths and spacing are measured and
(6)
(1)
(2)
(6)
Dam break is series phenomenon that can result in fatal consequences and loss of properties. Unfortunately, the observed consequences can only be available after the dam breaks. Therefore, it is important to anticipate what will happen prior to dam break to issue suitable warning and locate the possible risk areas. This study attempts to simulate the case of dam break in Blue Nile at Roseires dam and see its consequences downstream. Roseires dam lies at a distance of 630 km south of Khartoum, Sennar dam lies at about 260 km downstream of Roseires dam. In this study hydraulic model is developed based of Hydraulic Engineering Centre (HEC), River Analysis System (RAS), and HEC- RAS. The HEC-RAS based model is calibrated and validated usi
... Show MoreImproving" Jackknife Instrumental Variable Estimation method" using A class of immun algorithm with practical application