Hetero junctions are fabricated by depositing antimony (Sb) and Al films on n-type single crystal(c-Si) wafers by the method of vacuum evaporation with thickness (0.25µm), with rate of deposition equals to 2.77 Å/sec, all samples are annealed in a vacuum for one hour at 473K. The tests have shown that all the films have polycrystalline structure for all Sb films. The barrier heights in (Sb/c-Si) junction was found to be equal 0.825eV, but(Al/c-Si) junction ohmic contact. Current-voltage measurements confirm this behaviour.
In this study, the effect of glass fiber reinforced polymer (GFRP) section and compressive strength of concrete in composite beams under static and low velocity impact loads was examined. Modeling was performed and the obtained results were compared with the test results and their compatibility was evaluated. Experimental tests of four composite beams were carried out, where two of them are control specimen with 20 MPa compressive strength of concrete deck slab and 50 MPa for other. Bending characteristics were affected by the strength of concrete under impact loading case, as it increased maximum impact force and damping time at a ratio of 59% and reduced the damping ratio by 47% compared to the reference hybrid beam. Under stat
... Show MoreThe work in this paper focuses on the system quality of direct and coherent communication system for two computers. A system quality is represented by Signal to Noise ratio (SNR) and Bit Error Rate (BER). First part of the work includes implementation of direct optical fiber communication system and measure the system quality .The second part of the work include implementation both the( homodyne and heterodyne)coherent optical fiber communication system and measure the system quality . Laser diode 1310 nm wavelength with its drive circuit used in the transmitter circuit . A single mode of 62.11 km optical fiber is selected as transmission medium . A PIN photo detector is used in the receiver circuit. The optical D-coupler was u
... Show MoreUndoped and Iodine (I)–doped chrome oxide (Cr2O3)thin films have been prepared by chemical spray pyrolysis technique at substrate temperatures(773K) on glass substrate. Absorbance and transmittance spectra have been recorded as a function of wavelength in the range (340-800 nm) in order to study the optical properties such as reflectance, Energy gap of allowed direct transition, extinction coefficient refractive index, and dielectric constant in real and imagery parts all as a function of wavelength. It was found that all the investigated parameters affect by the doping ratios.
Urotensin-II (UII), a pluripotent vasoactive cyclic peptide, exhibits the progression of cardiovascular diseases and the glucose metabolic disorder of insulin resistance. Type 2 Diabetes Mellitus (T2DM) is entirely associated with insulin resistance. This study aimed to demonstrate the association of UII with insulin resistance in diabetic and non-diabetic subjects. A total of 73 male and female subjects aged 40-60 years were recruited in this case-control study. They included 35 non- diabetic subjects with a body mass index of (BMI) ≤ 25 and 38 patients with Diabetes Mellitus and BMI ≥ 25. UII levels were assessed beside other vasoactive and clinical parameters. The results re
... Show MoreIn this paper, we have provided a very thorough analysis of a new novel chelate metal ion complex of [Cu(II),Ag(I)] prepared via the interaction with the ligand{ 2-amino-8-((4-chloro-3-hydroxyphenyl) diazenyl)azo]guanine} [LAAG], which is synthesized by diazo coupling of the 5-amino-2-chlorophenol with amino acid guanine. The ligand and its complexes are identified by a variety of techniques, like [HNMR, FTIR, and Uv-vis] spectral, thermal analysis (TGA), and element analyses (CHN). The molar ratio was achieved so that the Cu(II) complex has (1:2) (M:L) with octahedral geometry; however, the Ag(I) complex has (1:1) (M:L) with tetrahedral geometry, and the ligand acts as neutral N,N-bidentate; as well as the ligand (LAAG) and its complexe
... Show MoreThe present study experimentally and numerically investigated the impact behavior of composite reinforced concrete (RC) beams with the pultruded I-GFRP and I-steel beams. Eight specimens of two groups were cast in different configurations. The first group consisted of four specimens and was tested under static load to provide reference results for the second group. The four specimens in the second group were tested first under impact loading and then static loading to determine the residual static strengths of the impacted specimens. The test variables considered the type of encased I-section (steel and GFRP), presence of shear connectors, and drop height during impact tests. A mass of 42.5 kg was dropped on the top surface at the m
... Show MorePick and place system is one of the significant employments of modern robots utilized in industrial environments. The objective of this research is to make a comparison of time sequences by combining multiple axes of sequences. A pick-place system implemented with pneumatic linear double-acting cylinders to applicator in automated systems processes for manufacturing. The challenge of 3-axes movement control was achieved using the PLC (Programmable Logic Controller) controller such that the merging between two or three axes was achieved according to the selected sequence of the program. The outcomes show the contrasted sequences and the reference in a constant velocity. The main variable parameter is the number of steps for each sequ
... Show MoreBackground: Multiple sclerosis (MS) is one of the increasing prevalent neurologic disorders. Epidemiologic and family studies implicate genetic and environmental factors in determining
susceptibility to MS. The exact effect of the former is intended for investigation in our study.
Objectives: The objective of the study is to compare the demographic features, clinical presenting features, and clinical course between familial and sporadic cases of MS.
Materials and Methods: this is a retrospective cohort study conducted in Multiple Sclerosis Center in the Medical City in Baghdad. The records of the MS center in Baghdad Teaching Hospital were surveyed, and data from 13 patients with positive family history of MS
Background: Multiple sclerosis (MS) is one of the increasing prevalent neurologic disorders. Epidemiologic and family studies implicate genetic and environmental factors in determining
susceptibility to MS. The exact effect of the former is intended for investigation in our study.
Objectives: The objective of the study is to compare the demographic features, clinical presenting features, and clinical course between familial and sporadic cases of MS.
Materials and Methods: this is a retrospective cohort study conducted in Multiple Sclerosis Center in the Medical City in Baghdad. The records of the MS center in Baghdad Teaching Hospital were surveyed, and data from 13 patients with positive family history of MS