The geochemical study of the Oligocene-Miocene succession Anah, Euphrates, and Fatha formations, western Iraq, was carried out to discriminate their depositional environments. Different major and trace patterns were observed between these formations. The major elements (Ca, Mg, Fe, Mn, K, and Na) and trace elements (Li, V, Cr, Co, Ni, Cu, Zn, Ga, Rb, Sr, Zr, Cs, Ba, Hf, W, Pb, Th, and U) are a function of the setting of the depositional environments. The reefal facies have lower concentrations of MgO, Li, Cr, Co, Ni, Ga, Rb, Zr, and Ba than marine and lagoonal facies but have higher concentrations of CaO, V, and Sr than it. Whereas dolomitic limestone facies are enriched V, and U while depletion in Li, Cr, Ni, Ga, Rb, Sr, Zr, Ba, an

This study aims to use claystone beds exposed in the Injana Formation (Late Miocene) at Karbala-Najaf plateau, middle of Iraq for the manufacturing of perforated and ordinary bricks. The claystone samples were assessed as an alternative material of the recent sediments, which are preferred to remain as agricultural land. The claystones are sandy mud composing of 29.1 - 39.1% clay, 37.2 - 54.8% silt and 14.1-26.8% sand. They consist of kaolinite, illite, chlorite, palygorskite, and montmorillonite with a lot of quartz, calcite, dolomite, gypsum and feldspar. Claystone samples were characterized by linear shrinkage 0.01 - 0.1%, volume shrinkage 0.1 - 0.9%, bulk density 1.2 - 2.11gm/cm3 (1.68 g / cm3 average), and the efflorescence is

The research aims to study Sabkha mineralogy to determine the mineral types, the nature of the precipitation, and the patterns of salt crystallization. Two Sabkhas in Abu Ghraib, west of Baghdad, were studied. It was found that the Sabkhas were formed in flat ponds from saturated solutions in a semi-arid to arid climate. Halite predominates, followed by anhydrite and gypsum as evaporite minerals. As for the minerals of the Sabkha soil, it consisted of feldspar, calcite, quartz, and dolomite, in addition to the clay minerals represented by kaolinite, illite, and chlorite. Needle forms, hopper shapes, dendritic crystals, and polygon shapes are the main crystallization patterns dominantly found in the Sabkhas. All these types of crysta

Several directional wells have been drilled in Majnoon oilfield at wide variation in drilling time due to different drilling parameters applied for each well. This technical paper shows the importance of proper selection of the bit, Mud type, applied weight on Bit (WOB), Revolution per minute (RPM), and flow rate based on the previous wells drilled. Utilizing the data during drilling each section for directional wells that's significantly could improve drilling efficiency presented at a high rate of penetration (ROP). Based on the extensive study of three directional wells of 35 degree inclination (MJ-51, MJ-52, and MJ-54) found that the applied drilling parameters for MJ-54 and the bit type within associated drilling parameters to drill

Crude oil is one of the most important sources of energy in the world. To extract its multiple components, we need oil refineries. Refineries consist of multiple parts, including heat exchangers, furnaces, and others. It is known that one of the initial operations in the refineries is the process of gradually raising the temperature of crude oil to 370 degrees centigrade or higher. Hence, in this investigation the focus is on the furnaces and the corrosion in their tubes. The investigation was accomplished by reading the thickness of the tubes for the period from 2008 to 2020 with a test in every two year, had passed from their introduction into the work. Where the thickness of more than one point was measured on each tube in the sa

Back ground: A urinary tract infection is one of the most common diseases occurring from neonate up to geriatric age groups
Patients and Methods: A total of (100) Midstream urine (MSU) samples were collected from patients having signs and symptoms of Lower urinary tract infection. These patients were attending Urology Clinic, Ramadi General Hospital.
Result: Culturing of (100) MSU samples on MacConky and blood agar resulted in (5) types of bacteria which included: Escherichia coli (46%) and it was found the most frequent bacteria causing LUTI. This is followed by Klebsiella pneumonia (23%), Pseudomonas aeruginosa (13%), Proteus mirabilis (10%) and Staphylococcus epidermidis (8%).
Conclusion: Out of