We have studied in this research litter (Taa) a morphological , sonic indicative and comparative study among four Semitic languages. They are Arabic , Hebrew, Syriac and Akkadian languages . We have divided the research into a number of pivots beginning with an entrance about the letter (Taa) in Semitic languages and the symbols which are used by these languages referring to . Then we have studied (Taa) from sonic side with letters phenomenon (b, g, k, p, t) the six in both Hebrew and Syriac languages . The letter (Taa) is formed one of them and the sonic change that is happening in articulation (Taa) according to sonic rules related to these letters in case of emphasis or in case of neglected (not emphasis). Then we have studied the process of standard replacement that happened as a result of sounds interaction and the effect of each other especially the standard replacement in the formation of (Iftala) as replacement between (Taa) and (Dal) and replacement between (Taa) and (Ta) and between (Taa) and (Thaa) and also between the sonic replacement between (Taa) and (Sad) and between (Ta) and (Seen) This replacement happens as a result of differences in dialects. Then we have studied the meanings and different indications of the letter (Taa) in the four Semitic languages mentioned above. The study included (Taa in the present) and (Taa the pronoun) it means the (Taa of the subject), (Taa of speech) , (Taa of feminine) (Taa of plural) and their indications in each pivot. It also included the study and comparison for a number of rhythms and nouns that feminine (Taa) followed with. (device noun) (place noun) (nomen vicis) (formation noun) (mimi infinitive) (artificial infinitive) The research has concluded with a number of results that we have reached through comparing process among four Semitic languages concerning this study.
In this work, monitoring of monthly variation (from May 2016 to October 2016) in the concentration of the metals (Co, Zn, Cd, Pb, Ni and Fe) from Al-Diwaniya city of Iraq. Investigation about the pollution with these metals was achieved from five selected sites locate in study area by flame atomic absorption spectroscopy. The results showed a wide variation in the levels of heavy metals from site to site and from month to month. A total of 180 surface soil samples were analyzed to detecting the pollution with selected samples. The resultsshowed that the highest concentration with Ni was 6.290 mg kg-1 while the lowest concentration detected with Ni was 0.080 mg kg-1. The results of pollution index (enrichment factor, contamination factor, po
... Show MoreIn this work, the emission spectra and atomic structure of the aluminum target had been studied theoretically using Cowan code. Cowan code was used to calculate the transitions of electrons between atomic configuration interactions using the mathematical method called (Hartree-Fock). The aluminum target can give a good emission spectrum in the XUV region at 10 nm with oscillator strength of 1.82.
The hydrodynamic properties of laser produced plasma (LPP) were investigated for the purpose of creating a light source working in the EUV region. Such a light source is very important for lithography (semiconductor manufacturing). The improved MEDUSA (Med103) code can calculate the plasma hydrodynamic properties (velocity, electron density,
In The Name of Allah Most Gracious Most Merciful
The reason for choosing this topic was:
First: It is my great love for the Prophet Muhammad, may God’s prayers and peace be upon him, his family, his companions, his followers, the followers of their followers, and the scholars after them until the Day of Judgment.
Secondly: Showing a great jurisprudential figure who has contributed by speaking about important jurisprudential issues in the life of this nation, and bringing out this immortal book to put it in the hands of scholars, so I chose a figure from the followers (may God be pleased with them all).
Third: The study of the jurisprudence of the companions
An effort is made to study the effect of composite nanocoating using aluminum-9%wt silicon alloys reinforced with different percentage (0.5,1,2,4)wt.% of carbon nanotubes (CNTs) using plasma spraying. The effect of this composite on corrosion behavior for AA6061-T6 by extrapolation Tafel test in sea water 3.5wt% NaCl was invested. Many specimens where prepared from AA6061-T6 by the dimension (15x15x3)mm as this first set up and other steps include coating process, X-ray diffraction and SEM examination .The results show the CNTs increase the corrosion rate of the nanocomposite coatings with increasing the weight percentage of CNTs within the Al-Si matrix. Al-9wt%Si coating layer itself has less corrosion rate if compared with both n
... Show MoreWater injection equipments such as pipelines, which are used in the second recovery of oil in the Al-Ahdeb wells, suffer from the corrosion in water during maintaining vacuum deoxygenated tower that used to decrease concentration of the dissolved oxygen gas in the water from 6.2-9.1 ppm to o.5 ppm. This study involved calculation the corrosion rates of the internal surfaces of the pipelines either during operation of the vacuum unit or when the tower out of operation. Finally, find the solution by one of the following suggestions. In the first suggestion removal of the dissolved O2 from water is achieved by increasing the dosage of the oxygen scavenger (sodium sulphite). The second suggestion involves re
... Show MoreThe study focuses on identifying the reality of administrative creativity of secondary schools' managers in Al-zarqaa province. The descriptive approach was adopted to conduct this study. To achieve the study objective, the author designed a questionnaire composed of (24) items included (4) domains applied on (80) male and female school managers were selected randomly. The results showed that the administrative creativity level of secondary school's managers over all domains were too high which ranked as school management domain followed by public community domain then teacher domain and finally, school environment domain. Additionally, each of male, private sector, and experience over 10 years revealed significant differences.
One and two-dimensional hydraulic models simulations are important to specify the hydraulic characteristics of unsteady flow in Al-Gharraf River in order to define the locations that facing problems and suggesting the necessary treatments. The reach in the present study is 58200m long and lies between Kut and Hai Cities. Both numerical models were simulated using HEC-RAS software, 5.0.4, with flow rates ranging from 100 to 350 m3/s. Multi-scenarios of gates openings of Hai Regulator were applied. While the openings of Al-Gharraf Head Regulator were ranged between 60cm to fully opened. The suitable manning roughness for the unsteady state was
... Show MoreSafe drinking water is essential for the present and future generations' health. This study aims to assess drinking water quality in Baghdad's Al-Rusafa neighborhood. Water samples were taken from 32 neighborhoods on this side. The quality of the examined potable water samples differed depending on the water source. This investigation's pH, chlorine, EC, TDS, TSS, Cd, and Pb levels were below acceptable ranges. TDS levels in Al-Mada'in are more significant than acceptable (>600ppm) water levels. Bacteria have polluted six communities (Shigella, Salmonella, Escherichia coli, and Klebsiella). Bacterial quality of drinking water and gram-negative bacteria resistant to chlorine in Baghdad's municipal water supply. Regarding pH, the w
... Show MoreWater injection equipments such as pipelines, which are used in the second recovery of oil in the Al-Ahdeb wells, suffer from the corrosion in water during maintaining vacuum deoxygenated tower that used to decrease concentration of the dissolved oxygen gas in the water from 6.2-9.1 ppm to o.5 ppm. This study involved calculation the corrosion rates of the internal surfaces of the
pipelines either during operation of the vacuum unit or when the tower out of operation. Finally, find the solution by one of the following suggestions. In the first suggestion removal of the dissolved O2 from water is achieved by increasing the dosage of the oxygen scavenger (sodium sulphite). The second suggestion involves removing the dissolved O2 from w
