Thanks allah and peace be upon our prophet muhammed and upon his family and his
followers……
The name is only called by the Almighty, One of the Names of the Creator Deity
features and slavery. He is the idol who worshiped.
The creator is derived from the creation of a sophisticated and significant from create Aharaz
for crust, and tailor the gown and the end of launch on God's creation of the creature, and this
release was a matter of metaphor One of the names of Allah, God is the creator himself is not
a partner Creator of all things, is the one who created
man from Nothingness began creating Adam peace be upon him and that he has passed the
stages in the process of creation, namely: He created him from dust, and when you add water
to him became mud and then turning mud to flesh elderly any clay black, and when dried mud
became Salsala not be untouched by the fire, and then inflatable God of his soul Creating
Adam, the first human beings. God Almighty has created man from clay Mitt not motionless
in it and make his descendants out of the bottom of the crucifixion ofwater is weak, called a
drop, then turned the sperm into a piece of blood frozen called leech then turned clot to the
piece of meat small called embryo and then turned into a bone and then God meat again and
then completed his creation and filmed and enter the spirit.
High temperature superconductors with a nominal composition HgBa2Ca2Cu3O8+δ
for different values of pressure (0.2,0.3, 0.5, 0.6, 0.9, 1.0 & 1.1)GPa were prepared by
a solid state reaction method. It has been found that the samples were semiconductor
P=0.2GPa.while the behavior of the other samples are superconductor in the rang
(80-300) K. Also the transition temperature Tc=143K is the maximum at P is equal to
0.5GPa. X-ray diffraction showed a tetragonal structure with the decreasing of the
lattice constant c with the increasing of the pressure. Also we found an increasing of
the density with the pressure.
This paper deals with prediction the effect of soil re-moulding (smear) on the ultimate bearing capacity of driven piles. The proposed method based on detecting the decrease in ultimate bearing capacity of the pile shaft (excluding the share of pile tip) after sliding downward. This was done via conducting an experimental study on three installed R.C piles in a sandy clayey silt soil. The piles were installed so that a gap space is left between its tip and the base of borehole. The piles were tested for ultimate bearing capacity according to ASTM D1143 in three stages. Between each two stages the pile was jacked inside the borehole until a sliding of about 200mm is achieved to simulate the soil re-moulding due to actual pile driving. The re
... Show MoreThe paper reports the influence of annealing temperature under vacuum for one hour on the some structural and electrical properties of p-type CdTe thin films were grown at room temperature under high vacuum by using thermal evaporation technique with a mean thickness about 600nm. X-ray diffraction analysis confirms the formation of CdTe cubic phase at all annealing temperature. From investigated the electrical properties of CdTe thin films, the electrical conductivity, the majority carrier concentration, and the Hall mobility were found increase with increasing annealing temperatures.
(1)
This paper presents stochastic analysis using the perturbation method to model the structure of a container to verify the distributions of probability of maximum and minimum axial forces reactions in piles. The proposed simulation of a container port terminal under 11 scenarios of load combinations was presented. The probability distributions for live loads are assigned according to the input parameters of simulation data. Part of the load itself is implicitly combined such as vertical live load which includes the weight of equipment and containers and wind load. The structural model was simulated in the software STAAD Pro., while the statistical analyses were performed with MATLAB. The results demonstrated that, the most significant extern
... Show More
(5)
(4)
(3)