The investigation of the effect of tempering on thermal analysis of
Al-Ti-Si alloy and its composites with MgO and SiC particles was
performed. Thermal analysis was performed before and after
tempering by DSC scan. Optical microscopy was used to identify the
phases and precipitations that may be formed in base alloy and
composites. X-ray diffraction test indicated that the Al3Ti is the main
phase in Al-Ti-Si alloy in addition to form Al5Ti7Si12 phase. Some
chemical reactions can be occurred between reinforcements and
matrix such as MgO.Al2O3 in Al-Ti/MgO, and Al4C3 and Al(OH)3 in
Al-Ti/SiC composite. X-ray florescence technique is used to
investigate the chemical composition of the fabricated specimens.
H

In this research the effect of cooling rate and mold type on mechanical properties of the eutectic
and hypoeutectic (Al-Si) alloys has been studied. The alloys used in this research work were (Al- 12.6%Si
alloy) and (Al- 7%Si alloy).The two alloys have been melted and poured in two types of molds with
different cooling rates. One of them was a sand mold and the other was metal mold. Mechanical tests
(hardness, tensile test and impact test) were carried out on the specimens. Also the metallographic
examination was performed.
It has been found that the values of hardness for the alloys(Al-12.6%Si and Al-7%Si) which poured in
metal mold is greater than the values of hardness for the same alloy when it poured in a heated

    Three different rotational speeds (800, 1000 and 1250 rpm) and traverse speeds of (0.42 mm/sec) at a constant taped pin have been employed to produce the stir zones generated from friction stir processing (FSP) of near eutectic Al- 14 wt.% Si alloy. The processed samples were thoroughly analyzed macroscopically and microscopically. The as-cast microstructure of eutectic (α Al+ Si) and primary Si were fragmented to produce spheroidization of small size of Si and deformed matrix. The stir zones showed an increase in hardness from around 45-50 Hv for as-cast to 40-65 depending on the variables applied. All the processed samples were characterized by advanced and retreated regions with large single piping defects formed m

Abstract:
Rabi’a tribe lived on the land of Euphrates since the first century of the
Christ. Then that land becomes her homeland. The Persians tried many times
to drive her away from that land, but with out result.
In the course of time Rabi’a become more knowledgeable of Persia.
This tribe proved her love and sanctification to the land of Euphrates, in the
battle of Dhyqar.
Rabi’a converted to Islam quickly and helped the Muslims to conquer
Iraq with a big number of fighters in many battles like al- Qadisyyah. That
influenced the anger of Mudriat Arab tribes who were their old enemies.
Mudriat tribes did their efforts to reduce the importance of Rabi’a because of
some its branches were among of t

In this research an Artificial Neural Network (ANN) technique was applied for the prediction of Ryznar Index (RI) of the flowing water from WTPs in Al-Karakh side (left side) in Baghdad city for year 2013. Three models (ANN1, ANN2 and ANN3) have been developed and tested using data from Baghdad Mayoralty (Amanat Baghdad) including drinking water quality for the period 2004 to 2013. The results indicate that it is quite possible to use an artificial neural networks in predicting the stability index (RI) with a good degree of accuracy. Where ANN 2 model could be used to predict RI for the effluents from Al-Karakh, Al-Qadisiya and Al-Karama WTPs as the highest correlation coefficient were obtained 92.4, 82.9 and 79.1% respectively. For

This study is concerned with the effect of adding two kinds of ceramic materials on the mechanical properties of (Al-7%Si- 0.3%Mg) alloy, which are zirconia with particle size (20μm > P.S ≥ 0.1μm) and alumina with particle size (20μm > P.S ≥ 0.1μm) and adding them to the alloy with weight ratios (0.2, 0.4, 0.6, 0.8 and 1%). Stirring casting method has been used to make composite material by using vortex technique which is used to pull the particles to inside the melted metals and distributed them homogenously.

After that solution treatment was done to the samples at (520ºC) and artificial ageing at (170ºC) in different times, it has been noticed that the values of hardness is increased with the aging time of the o

Abstract The success of the system of government in any country needs to have a handle on the amount of power efficiency , capacity , capability and wisdom, Iraq has gone through since its inception through several stages of time, namely: The first stage: which ran from August 23, 1921 until July 14, 1958 and was ruling monarchy (rule of the royal family) and punishing power of political elites both of them and works access to power without taking into consideration the laws and principles of the Constitution, and as a result of the inability of civilian powers and political parties access to power to grant that army officers regulatory and disciplinary specifications as well as possessing arms and overthrow the rule of the minority coup

Abstract:
This tribe had lived in Iraq since the first century A.D. Persia tried to
keep this tribe away from Iraq, but without result. The tribe managed to get
victory against Persia in the battle of Dhyqar.
When the Muslims had come to conquer Iraq, Rabi’a welcomed them
and takes part in that action.
That tribe helped the caliph Ali in the Jammal and Sifffen wars in order
to remain Iraq the center of the Islamic caliphates this tribe had felt very sad
and sorrowful when the caliphate become to the Umayyad . This tribe did not
give up, so this tribe did what could be done to help those who had revolted
against the Umayyad. Rabi’a did that in order to get ride of the Mudriat alsham,
and favored Rabi

Adsorption techniques are widely used to remove organics pollutants from waste water particularly, when using low cost adsorbent available in Iraq. Al-Khriet powder which was found in legs of Typha Domingensis is used as bio sorbent for removing phenolic compounds from aqueous solution. The influence of adsorbent dosage and contact time on removal percentage and adsorb ate amount of phenol and 4- nitro phenol onto Al-Khriet were studied. The highest adsorption capacity was for 4-nitrophenol 91.5% than for phenol 82% with 50 mg/L concentration, 0.5 gm. dosage of adsorbent and pH 6 under a batch condition. The experimental data were tested using different isotherm models. The results show that Freundlich model resulted in the best fit also