Background: With the start of the current century, increased the interest in the role of the adipose tissue derived substances that named adipokines in the inflammatory diseases of the human being including the inflammatory periodontal disease, but scientific evidences were not clearly demonstrate the association between these adipokines and periodontal pathologies. Materials and Methods: Forty two subjects male only with normal body mass index were selected for the study with an age ranged (30-39 years). Samples were divided into three groups of 14 subjects in each group based on clinical periodontal parameters; clinically healthy gingiva (group I), gingivitis group (group II) and chronic periodontitis patients group (group III), from whom saliva and serum samples were collected for estimating the levels of leptin and resistin using Enzyme-Linked Immuno Sorbent Assay (ELISA). Results: The results showed that the serum level of leptin and resistin were significantly higher in chronic periodontitis patient (9.81 ng/ml, 6.55 ng/ml) respectively as compared to gingivitis and healthy control groups (leptin; 8.10 ng/ml, ng/ml, resistin; 5.85 ng/ml, 5.45 ng/ml) respectively. On the other hand the level of leptin in saliva of patients with chronic periodontitis (0.17 ng/ml) was significantly lower than that of its salivary levels in gingivitis and healthy control groups (0.21 ng/ml, 0.29 ng/ml) respectively. Whereas, salivary resistin levels was significantly higher in chronic periodontitis patient(14.45 ng/ml) when compared to the gingivitis group (11.59 ng/ml) and the health control group (6.43 ng/ml). Conclusions: Concomitant raise in serum leptin, serum resistin and salivary resistin, while a sensible reduction in salivary leptin with conversion from periodontal health state to periodontal disease state. These finding may draw a suggestion on the role of leptin and resistin in the relation between periodontal disease and the systemic health since the increase in their level were associated with a various systemic pathologies.
(2)
(2)
Direct field-orientation Control (DFOC) of induction motor drives without mechanical speed sensors at the motor shaft has the attractions of low cost and high reliability. To replace the sensor, information on the rotor speed and position are extracted from measured stator currents and from voltages at motor terminals. In this paper presents direct field-orientation control (DFOC) with two type of kalman filter (complete order and reduced order extended kalman filter) to estimate flux, speed, torque and position. Simulated results show how good performance for reduced order extended kalman filter over that of complete order extended kalman filter in tracking performance and reduced time of state estimation.
Praise be to God, Lord of the worlds, and prayers and peace be upon the most honorable of God’s creation, Muhammad bin Abdullah, the illiterate Arab prophet, the faithful, and his family and companions.
And yet ...
The realistic view is that Islamic jurisprudence is not exaggerated in the judgment of compensation, so it is judged for everything that has been lost by the victim of a profit or his loss, but he takes into account the bearing of the guarantee between profit and loss or the principle on which the theory of bearing liability is found, and it is clear through research that Islam The principle of respecting money, souls and rights is considered a public order, but it may exclude some ca
... Show MoreThis research presents experimental and theoretical investigation of 15 reinforced concrete spliced and nonspliced girder models. Splices of hooked dowels and cast in place joints, with or without strengthening steel plates were used. Post-tensioning had been used to enhance the splice strength for some spliced girders. The ANSYS computer program was used for analyzing the spliced and non-spliced girders. A nonlinear three dimensional element was used to represent all test girders. The experimental results have shown that for a single span girder using steel plate connectors in the splice zone has given a sufficient continuity to resist flexural stresses in this region. The experimental results have shown that the deflection of hooked do
... Show More
(2)
Piroxicam (PIR) is a nonsteroidal anti-inflammatory drug of oxicam category, used in gout, arthritis, as well as other inflammatory conditions (topically and orally). PIR is practically insoluble in water, therefore the aim is prepare and evaluate piroxicam as liquid self-nanoemulsifying drug delivery system to enhance its dispersibility and stability. The Dispersibilty and Stability study have been conducted in Oil, Surfactant and Co-surfactant for choosing the best materials to dissolve piroxicam. The pseudo ternary phase diagrams have been set at 1:1, 2:1, 3:1 as well as 4:1 ratio of surfactants and co-surfactants, also there are 4 formulations were prepared by using various concentrations of transcutol HP, cremophore EL and triacetin
... Show More
(7)
(3)
This study examined >140 relevant publications from the last few years (2018–2021). In this study, classification was reviewed depending on the operation's progress. Electrocoagulation (EC), electrooxidation (EO), electroflotation (EF), electrodialysis (ED), and electro-Fenton (EFN) processes have received considerable attention. The type of action (individual or hybrid) for each electrochemical procedure was evaluated, and statistical analysis was performed to compare them as a new manner of reviewing cited papers providing a massive amount of information efficiently to the readers. Individual or hybrid operation progress of the electrochemical techniques is critical issues. Their design, operation, and maintenance costs vary depending o
... Show More
(70)
(72)
(30)
(21)
(158)
(146)
In the current research, we investigated the absorption spectrum for R590 and C480 dyes in ethanol solvent for different dye solution concentrations of 10-4, 10-5 and 10-6M. These dyes have been prepared and studied before and after gamma irradiation (first, second ionization) using cesium-137 source with absorbed doses of 18.36 Gy (time exposure of 10 days) and 73.44 Gy (with time exposure of 40 days). We noticed that the absorption intensity was decreased with decreasing concentration, before gamma irradiation while the absorption spectrum peak shifted towards the short wavelength (blue shift). It was also found that the intensity of absorption spectrum increased and shifted the absorption spectrum peak towards the long wavelength (red
... Show More
Accurate predictive tools for VLE calculation are always needed. A new method is introduced for VLE calculation which is very simple to apply with very good results compared with previously used methods. It does not need any physical property except each binary system need tow constants only. Also, this method can be applied to calculate VLE data for any binary system at any polarity or from any group family. But the system binary should not confirm an azeotrope. This new method is expanding in application to cover a range of temperature. This expansion does not need anything except the application of the new proposed form with the system of two constants. This method with its development is applied to 56 binary mixtures with 1120 equili
... Show More