Background: Human teeth considered to be an important etiological host factor in relation to dental caries through its morphology and composition. Elements may incorporate in tooth structure during pre and post-eruptive period changing the resistance for caries. The aims of this study were to determine the concentration of selected major (Calcium and phosphorus) and trace elements (Ferrous iron, nickel, chromium and aluminum) in permanent teeth and enamel among a group of adolescent girls in relation to severity of dental caries Material and Methods: The study group consisted of 25 girls with an age of 13-15 years old referred by Orthodontists for extractions of upper first premolars (two sides). Tooth and enamel samples were prepared for chemical analysis according to method described by Lappalainen and Knuttila (1979). Dental caries was diagnosed by both clinical and radiographical examinations following the criteria of D1-4MFS index described by Muhlemann (1976). All data were analyzed using SPSS version 19. Results: The concentration of major elements in teeth and enamel (measured in % of dry weight) showed that Ca ions were higher than P ions. On the other hand the concentration of trace elements in teeth and enamel samples (measured in ppm) showed that Al ions was the highest followed by Ferrous Fe then Ni ions, while Cr ions were the least in concentration. All elements showed statistically highly significant difference in concentration between teeth and enamel samples. Ca/P ratio was higher in enamel than tooth, but the difference was statistically not significant. Major elements (calcium and phosphorus) in tooth and enamel samples recorded negative correlations with DMFS. Trace elements except chromium ions recorded positive correlations with DMFS. They were not significant except for nickel ions in tooth and aluminum ions in enamel. Conclusions: The presence of these elements in both teeth and enamel samples indicated that these elements present in our environment; as foods, water, and air so they incorporate through out the tooth layers during the pre-eruptive period of tooth development, and incorporate the outer enamel surface during the demineralization and remineralization processes that occurs in the post-eruptive periods. Ca and p ions play an important role in mineralization of tooth and enamel. Cr ions may play a role in improving mineralization and crystallity of teeth, while Fe, Ni and Al may act as cariogenic elements.
Background: This clinical trial aims to evaluate the color changes of direct resin composite veneer (DCV) restorations based on spectrophotometric analysis of 4 different types of resin composites between the baseline immediately after polishing and after one year of follow-up. Materials and methods: 28 patients were assessed for eligibility for participation, aged between 18 and 38 years old, who indicated for DCV restorations in anterior maxillary teeth were considered for participation in this study. In total, 25 patients who met the inclusion criteria were selected (6 males and 19 females, mean age: 20.9 at the time of restoration placement), and 3 patients were excluded. Partic
... Show MoreCognitive methods play the role of regulator of the human environment for its direct relationship with sensory stimuli and stimuli associated with the organization of information and ideas and their preparation for use in subsequent situations. These methods determine the characteristic or ideal way of individual personality in the differentiation and integration of attitudes or cognitive field to which he is exposed. Therefore, the research aimed at the level of psychological stress and its relation to some personal characteristics that show the personality of the artist or the students of art.
Current research aims to.
- Identifying the extent of psychological stress and its relation to the personal ch
A cantilevered piezoelectric beam with a tip mass at its free end is a common energy harvester configuration. This paper introduces a new principle of designing such a harvester which increases the generated voltage without changing the natural frequency of the harvester: The attraction force between two permanent magnets is used to add stiffness to the system. This magnetic stiffening counters the effect of the tip mass on the natural frequency. Three setups incorporating piezoelectric bimorph cantilevers of the same type in different mechanical configurations are compared theoretically and experimentally to investigate the feasibility of this principle. Theoretical and experimental results show that magnetically stiffe
... Show MoreIn this research, radon concentrations in some types of healthy drinking water samples available in Iraq's market were measured using a technique called Durridge RAD-7-H2O with closed loop. Then the rate of annual effective dose in human taken this water is determined.
It was found that, radon concentrations in studied samples ranged between 1.2 Bq.m-3 to 142 Bq.m-3. The results of the radon concentrations and the rate of annual effective dose for drinking water samples were significantly lower than the USEPA and WHO recommended limits that equal 500 Bq/m3 and 1 mSv/y resp
... Show MoreThe aim of the research is to demonstrate of the relation and the influence of the components of economic intelligence (strategic alertness, information security policy, impact policy) in achieving of economic growth (creativity, competitiveness, quality improvement). The questionnaire was used as a main tool for selected sample. Answers analyzed by using the statistical program (SPSS) to calculate the arithmetic mean, standard deviation, weight percentage, correlation, F test, and Squared factor (R2).
The research derived its importance from the distinguished role of information systems in the work of industrial companies, and its impact toward achieving economic growth rates in its various activities. T
... Show MoreMany studies and researches related to the audio and visual medium have shed light on the creative process that has taken place through them as well as the aesthetic and artistic creation and have dealt with many fields of knowledge and creativity in this field of art, which managed to study and follow its intellectual and technical tools for creating achievements through this medium, in its forefront come the elements of the cinematic language, which is characterized by possessing multiple features of aesthetic and semantic employment to reach the recipient as it is a tool of the artistic expression that gives the material it deals with aesthetic and intellectual dimensions from various aspects. "The artistic expression cannot be achiev
... Show MoreSUMMARY. The objectives of the present study were to assess the possible predictors of COVID-19 severity and duration of hospitalization and to identify the possible correlation between patient parameters, disease severity and duration of hospitalization. The study included retrospective medical record extraction of previous coron avirus COVID-19 patients in Basra hospitals, Iraq from March 1st and May 31st, 2020. The information of the participants was investigated anonymously. All the patients’ characteristics, treatments, vital signs and laboratory tests (hematological, renal and liver function tests) were collected. The analysis was conducted using the SPSS (version 22, USA). Spearman correlation was used to measure the relations
... Show MoreBackground: Debonding and fracture of artificial teeth from denture bases are common clinical problem, bonding of artificial teeth to heat cure acrylic and high impact heat cure acrylic denture base materials with autoclave processing method is not well known. The aim of this study was to evaluate the effect of autoclave processing method on shear bond of artificial teeth to heat cure denture base material and high impact heat cure denture base material. Materials and methods: Heat polymerized (Vertex) and high impact acrylic (Vertex) acrylic resins were used. Teeth were processed to each of the denture base materials after the application of different surface treatments. The sample (which consist of artificial tooth attached to the dentur
... Show More