The identification of a bed’s lithology is fundamental to all reservoir characterization because the physical and chemical properties of the rock that holds hydrocarbons and/or water affect the response of every tool used to measure formation properties. The main purpose of this study is to evaluate reservoir properties and lithological identification of Nahr Umr Formation in Luhais well -12 southern Iraq. The available well logs such as (sonic, density, neutron, gamma ray, SP, and resistivity logs) are digitized using the Didger software. The petrophysical parameters such as porosity, water saturation, hydrocarbon saturation, bulk water volume, etc. were computed and interpreted using Techlog software. The lithology prediction of Nahr Umr Formation was carried out by appling IPSOM technique using density, neutron, and gamma ray logs. Nahr Umr Formation in well Luhais -12 was divided into three zones based on well logs interpretation and petrophysical Analysis: Zone-A, Zone-B, and Zone-C. The formation lithology is mainly composed of sandstone interlaminated with siltstone and shale according to interpretation of density, neutron, and gamma ray logs using IPSOM technique. Interpretation of formation lithology and petrophysical parameters shows that zone-C is characterized by clean sandstone with high porosity and water saturation whereas zone –B consists mainly of alternating shale beds with siltstone and sandstone with high porosity and water saturation less than zone –C and increasing of hydrocarbon saturation but Zone –A consists mainly of siltstone and sandstone layer with some of shale beds that contains hydrocarbon.
Fifteen samples of limestone, marls and, clay from the Fat'ha Formation are obtained from the location of Bashiqa village, Bashiqa anticline, Northeastern Iraq. A detailed investigation is carried out, during which twenty-four species of calcareous nannofossils identified, twenty- one are descried from other regions while three are left under an open name because of lack of material or insufficient samples. Besides, seventeen species of Ostracoda fossils were picked and diagnosed, including two subspecies, belonging to ten genera, and four subgenera.
The recorded calcareous nannofossil assemblages include two biozones which are from the lower to the upper part of the section: (1) Helicosphaera ampliaperta Interval Bio
... Show MoreExploitation of mature oil fields around the world has forced researchers to develop new ways to optimize reservoir performance from such reservoirs. To achieve that, drilling horizontal wells is an effective method. The effectiveness of this kind of wells is to increase oil withdrawal. The objective of this study is to optimize the location, design, and completion of a new horizontal well as an oil producer to improve oil recovery in a real field located in Iraq. “A” is an oil and gas condensate field located in the Northeast of Iraq. From field production history, it is realized the difficulty to control gas and water production in this kind of complex carbonate reservoir with vertical producer wells. In this study, a horizont
... Show MoreA surface section of the Gercus Formation (Middle-Late Eocene) was studied in Berafat area, Dohuk Governorate, Northern Iraq. The Gercus Formation consists of a mixed siliciclastic sediments, evaporates and carbonate sequences in the studied region, predominantly in the upper and middle parts. Nevertheless, it usually consists of upward-fining carbonate-rich sandstone cyclothems, marl, conglomerate and siltstone along with a gypsum lens and thin micrite carbonate beds. The Gercus Formation was deposited in delta and delta front of occasionally depositional environment which is represented by red-brown claystone and reddish-brown mudstone lithofacies. Cross bedded pebbly sandstone, trough cross-bedded sandstone and lamin
... Show MoreRock type identification is very important task in Reservoir characterization in order to constrict robust reservoir models. There are several approaches have been introduced to define the rock type in reservoirs and each approach should relate the geological and petrophysical properties, such that each rock type is proportional to a unique hydraulic flow unit. A hydraulic flow unit is a reservoir zone that is laterally and vertically has similar flow and bedding characteristics. According to effect of rock type in reservoir performance, many empirical and statistical approaches introduced. In this paper Cluster Analysis technique is used to identify the rock groups in tertiary reservoir for Khabaz oil field by analyses variation o
... Show MoreThe sequence in the upper part of the Balambo Formation is composed mainly of limestone alternating with marly limestones and dark grey shale in the Bosheen section (eastern Sulaymaniyah, northeastern Iraq) and has been studied in terms of its rare earth element (REE) content. The REEs are very low compared to modern marine sediments. They are depletion in LREEs, and enrichment in HREEs and (La/Yb)N in the studied rocks, indicating that these sediments retained the REEs pattern of marine waters. The negative Ce anomaly reflects direct sedimentation from marine waters under anoxic conditions with the contribution of terrigenous clays. The positive correlation of ∑REEs with Al, Ti, and Y, and the negative correlation of ∑REE
... Show MoreThis study focuses on determining the heterogeneity of Yamama Formation and its spatial distribution in south of Iraq using three indices namely, Coefficient of Variation, Lorenz Coefficient, and Dykstra – Parsons Coefficient. The porosity and permeability values from eleven wells in south of Iraq (Basra and Maysan oil fields) are used for computing heterogeneity indices. Ordinary kriging technique is used to interpolate the computed indices and to show the spatial distribution of these indices over the study area. Results indicated that the average values of Lorenz and Dykstra – Parsons Indices are 0.73 and 0.86, respectively which refer to the extremely heterogeneity nature of Yamama Formation in the study area.The spatial distribu
... Show MoreCalciturbidites are similar to siliciclastic turbidites in structure, texture, basin physiography and processes of deposition; nevertheless, their clasts (grains) are carbonate minerals. Turbidity currents transport carbonate grains from carbonate source areas and coastal areas to the deep basins after passing the shelf (peri-platform). These currents are triggered by short-lived catastrophic events, such as tsunamis, earthquakes, marine slides, and typhoons. The Late Cretaceous Zagros Foreland and Hinterland in NE-Iraq (Kurdistan Region) was an active source for the shedding of voluminous sediments to the deep basin of Zagros Foreland Basin. During late Campanian, Shiranish Formation was deposited in the foreland basin; it occurs in the
... Show MoreThe present study deals with the petrographic investigations revealed that the sandstone of Gercus Formation the studied samples of sandstone units composed primarily of rock fragments (sedimentary, igneous and metamorphic), quartz grains (monocrystalline and polycrystalline), and feldspars (orthoclase, microcline and plagioclase). These components are cemented by carbonate and iron oxides. The studied sandstones are classified as litharenites, Sandstone rocks of Gercus Formation are chemically and mechanically unstable due to the high percentage of rock fragments ,such a grain assemblage infers that the source of the rock fragments is nearby. The petrographic analyses indicate that the studied sandstones are immature mineralogically b
... Show MoreRecords of two regionalized variables were processed for each of porosity and permeability of reservoir rocks in Zubair Formation (Zb-109) south Iraq as an indication of the most important reservoir property which is the homogeneity , considering their important results in criterion most needed for primary and enhanced oil reservoir .Z and F tests that were calculated for the two above mentioned properties of pair units of Zubair Formation have shown the difference in depositional energy and different diagenesis between units IL and AB , DJ and AB , and the similarity in grains size , sorting degree , depositional environment and pressure gradients between IL and AB units , LS and IL units ; also the difference in the properties above betw
... Show MoreIn many oil-recovery systems, relative permeabilities (kr) are essential flow factors that affect fluid dispersion and output from petroleum resources. Traditionally, taking rock samples from the reservoir and performing suitable laboratory studies is required to get these crucial reservoir properties. Despite the fact that kr is a function of fluid saturation, it is now well established that pore shape and distribution, absolute permeability, wettability, interfacial tension (IFT), and saturation history all influence kr values. These rock/fluid characteristics vary greatly from one reservoir region to the next, and it would be impossible to make kr measurements in all of them. The unsteady-state approach was used to calculate the relat
... Show More