Engineering geological study of rock slope stability in two stations lying in the SW of Haibat Sultan mountain, along the Kalksmaq - Koisanjaq road was carried out. At each station, rock slopes and discontinuities were comprehensively surveyed and the relationships with failures were determined. The limestone rock was described in engineering terms, the types of failures recorded during field study were rock roll and toppling whiles the probable failures were sliding, toppling, and rock roll. The study also revealed that the factors affecting slope stability in the study area were slope angle, height, dip of strata, and discontinuities (which are almost perpendicular to the bedding plane). The laboratory test, of the rock samples (point-load test) showed that the average value of compressive strength of the rock for the study area is about 192 M.Pa. Landslide possibility index (LPI) classification of Bejerman (1998) is applied to the study area, it shows that slopes of both stations lie in the category IV of moderate (LPI). The hazards related to the (LPI) are also moderated (LPI). Some remedial measures were suggested to slopes, such as remove of unstable blocks, to avoid further failure problems and safeguard the slopes in the future.
Abstract:
The paper aims to measure an aggregated banking stability index reflecting the degree of stability of the banking system to help policy makers to take the necessary actions to avoid financial crises facing banks and to achieve a banking system with high efficiency in terms of banking risk.
Therefore, the problem of paper is that the Central Bank of Iraq did not seek until 2016 to build a aggregated index for the purpose of identifying the stability of the banking situation in Iraq, but rather on the adoption of scattered indicators, which depend on the mechanism of relative changes in those indicators for the purpose of identifying the situation of b
... Show More
(1)
3D geological model of a simple petroleum reservoir for Yamama Formation has
been built in Abu Amood Oil Field using Petrel software, which is a product of
Schlumberger. This model contains the structure, stratigraphy and reservoir
properties (porosity and water saturation) in three directions(X, Y and Z).Geologic
modeling is an applied science of creating computerized representations of portions
of the earth's crust, especially oil and gas fields.
Yamama Formation in Abu Amood Oil Field is divided into thirteen zones by
using well logs and their petrophysical properties, six of which are reservoir zones.
From the top of the formation these six zones are: (YB-1, YB-2, YB-3, YC-1, YC-2
and YC-3). These reservoir
The environmental impact was illustrated by rockslide and erosion on the Duhok Dam and its reservoir. The evaluation of the geotechnical characteristics of the Gercus Formation was conducted. The research plan was divided into three phases, field, laboratory, and office works. The fieldwork included studying all the geological phenomena of the region related to the environmental impact. The laboratory work focused on studying the geotechnical properties of the various rock samples taken from the Gercus Formation. Rocklab program was used to define the geotechnical properties of a rock mass. The results indicated the weak resistance of the Gercus Formation rocks to weathering and erosion processes, as well as their weak resistance to slid
... Show More
(3)
This work deals with the reporting of four helminthes in the rook partridge Alectoris graeca collected in G'ara area west of Iraq. The infection rates of the cestodes, Raillietina alectori and R. tetragona and the nematode. Hartertia gallinarum, and the trematode. Postharmostomum gallinum were 6.38%, 40.43%, 10.63%, and 10.63% respectively. The host relationships were discussed.
Reservoir rock typing integrates geological, petrophysical, seismic, and reservoir data to identify zones with similar storage and flow capacities. Therefore, three different methods to determine the type of reservoir rocks in the Mushrif Formation of the Amara oil field. The first method represents cluster analysis, a statistical method that classifies data points based on effective porosity, clay volume, and sonic transient time from well logs or core samples. The second method is the electrical rock type, which classifies reservoir rocks based on electrical resistivity. The permeability of rock types varies due to differences in pore geometry, mineral composition, and fluid saturation. Resistivity data are usually obtained from w
... Show More
(4)
(3)
Volcaniclastic rocks of Al Muqdadiya Formation (Pliocene) in Injana area, southern Hemrin anticline, NE of Iraq, were studied ( petrographically, physically, mineralogically and geochemically , as well as the engineering properties) to assess the suitability of volcaniclastic rocks to use them in industry as refractories. The results show that the physical and engineering properties change with the temperature change. The bulk density and the specific gravity increase by increasing temperature while the apparent porosity, water sorption and the linear shrinkage decrease. On the other hand the compressive strength increase by increasing temperature. The volcaniclastics have very low thermal conductivi
... Show MoreVolcaniclastic rocks of Al Muqdadiya Formation (Pliocene) in Injana area, southern Hemrin anticline, NE of Iraq, were studied ( petrographically, physically, mineralogically and geochemically , as well as the engineering properties) to assess the suitability of volcaniclastic rocks to use them in industry as refractories. The results show that the physical and engineering properties change with the temperature change. The bulk density and the specific gravity increase by increasing temperature while the apparent porosity, water sorption and the linear shrinkage decrease. On the other hand the compressive strength increase by increasing temperature. The volcaniclastics have very low thermal conductivity.
The petrography, mineralogy and
The current study deals with microfacies and the depositional environment of the Lower Cretaceous Sarmord Formation at selected sections in Sulaimani and Erbil Governorates, northern Iraq. The Sarmord Formation alternates rhythmically between yellowish grey marly limestones and grey black marls. These lithologies are observed in all studied sections of Sarmord Formation in northern Iraq. Petrographic investigation of this study based on 240 thin sections demonstrated that the carbonate constituents are mainly composed of skeletal and non-skeletal grains. The skeletal grains include a variety of foraminiferas (planktonic and benthonic), bioclasts, calcispheres, ostracods, radiolaria, echinoderms, sponge spicules, ammonoids and be
... Show More
The present study deals with the petrographic investigations revealed that the sandstone of Gercus Formation the studied samples of sandstone units composed primarily of rock fragments (sedimentary, igneous and metamorphic), quartz grains (monocrystalline and polycrystalline), and feldspars (orthoclase, microcline and plagioclase). These components are cemented by carbonate and iron oxides. The studied sandstones are classified as litharenites, Sandstone rocks of Gercus Formation are chemically and mechanically unstable due to the high percentage of rock fragments ,such a grain assemblage infers that the source of the rock fragments is nearby. The petrographic analyses indicate that the studied sandstones are immature mineralogically b
... Show More