Response surface methodology (RSM) based on central composite design was successfully applied to redesign MRS media for maximizing both biomass and bacteriocin production from Lactobacillus plantarum NH40. First, glucose and yeast extract were chosen as the best carbon and nitrogen sources based on classical optimization results of one factor at time which also revealed the possibility of eliminating peptone and meat extract from the original composition of medium without affecting the growth and bacteriocin production. Statistical experimental design based on a regression model generated using the Design expert 7 software showed that the optimum concentrations of glucose, yeast extract, tween80, NH4Cr, CH3COONa and K2PO4 were 40, 19.9, 1, 3.06, 7, 1.25 g/L respectively for maximum production of biomass (15.87 mg/mL) and bacteriocin (634.74 U/mL). In addition, from the analysis of variance, yeast extract with F-value 77.2 and glucose with 185.4 were the most effective factors on biomass and bacteriocin production. Formulation of empirical model explained that the interaction among factors showed that the determination coefficient R2 of biomass and bacteriocin production were 0.8777 and 0.8539 respectively. Furthermore, the accuracy of model of the optimized MRS medium suggested by design expert 7 for both biomass and bacteriocin was verified and results showed that concentrations of biomass and bacteriocin were 15 mg/mL and 640AU/mL respectively, which were approximately closed to predicted values.
Research was conducted to study the effect of proline and aspirin with 10 and 20 ppm on seed germination and seedling growth of Lycopersicon esculentum and the effect of surface growth of Fusarium oxysporum. The results showed that the proline and aspirin effected significantly to decreased percentage of seed germination, acceleration of germination, promoter indicator, elongation speed of radical and plumule and also the infection percentage of seed decay and surface growth of Fusarium oxysporum was reduced significantly.
The azo dye brilliant reactive red K-2BP (λmax = 534 nm) is widely used for coloring textiles because of its low-cost and tolerance fastness properties. Wastewaters treatment that contains the dye by conventional ways is usually inadequate due to its resistance to biological and chemical degradation. During this study, the continuous reactor of an advanced oxidation method supported the use of H2O2/sunlight, H2O2/UV, H2O2/TiO2/sunlight, and H2O2/TiO2/UV for decolorization of brilliant reactive red dye from the effluent. The existence of an optimum pH, H2O2 concentration, TiO2 concentration, and d
... Show More
(4)
Contents IJPAM: Volume 116, No. 3 (2017)
(3)
(1)
Nasryia oil field is located about 38 Km to the north-west of Nasryia city. The field was discovered in 1975 after doing seismic by Iraqi national oil company. Mishrif formation is a carbonate rock (Limestone and Dolomite) and its thickness reach to 170m. The main reservoir is the lower Mishrif (MB) layer which has medium permeability (3.5-100) md and good porosity (10-25) %. Form well logging interpretation, it has been confirmed the rock type of Mishrif formation as carbonate rock. A ten meter shale layer is separating the MA from MB layer. Environmental corrections had been applied on well logs to use the corrected one in the analysis. The combination of Neutron-Density porosity has been chosen for interpretation as it is c
... Show More
(1)
(1)
Thermonuclear reaction rates are calculated for three oxygen isotopes 14,15,16O in CNO cycles reactions occurring in red giant stars. These reactions are:, , , , and . Reaction rates have been calculated using Matlab codes, and related comparisons were made with NACRE II and Reaclib libraries, and the ratios of production to the destruction of 15,16O isotopes were found. Present reaction rate results were close to most of the selected reactions, and in some cases larger with a factor of 1-3. 15,16O production to destruction ratios indicated a special tendency to saturate at temperatures higher than ~ 2 GK, and these ratios were in general larger than 1 indicating an excess of producing such isotopes in re
... Show More
Yeast strain S9, which produced a high amount of biosurfactant, was isolated from pickledolive and identified as a strain of Candida guilliermondii using VITTEK 2 compact system, this strain was selected out of 13bioemulsifier producing strains. The effects of some environmental and nutritional factors on biosurfactant production were evaluated, the maximum value of E24% was observed at pH 4 which was 70% and the optimal temperature for biosurfactant production was 30 °C, E24% was 75%. Among different edible and heavy oils, the sesame oil and heavy oil 150 were the best carbon sources in production of biosurfactant, E24% was82% and 78% respectively and among different organic and inorganic nitrogen sources, the yeast extract was the bes
... Show More