This paper aims to calculate the petrophysical properties in the Al-Ahdab field in the middle of Iraq within the Mauddud Formation. This study was based on the information available from well logs. The interactive petrophysical software IP (V4.5) was used to calculate the porosity, hydrocarbon saturation and shale volume, divide the formation into reservoir units and buffer units, and evaluate these units in each well. The Mauddud was divided into five units, two of them were considered good reservoirs having good petrophysical properties (high porosity, Low water saturation, and low shale volume). The other three are not reservoirs because of poor petrophysical properties.
In order to reduce hydrostatic pressure in oil wells and produce oil from dead oil wells, laboratory rig was constructed, by injecting LPG through pipe containing mixture of two to one part of East Baghdad crude oil and water. The used pressure of injection was 2.0 bar, which results the hydrostatic pressure reduction around 246 to 222 mbar and flow rate of 34.5 liter/hr fluid (oil-water), at 220 cm injection depth. Effects of other operating parameters were also studied on the behavior of two phase flow and on the production of oil from dead oil wells.
Tight oil reservoirs have been a concerned of the oil industry due to their substantial influence on oil production. Due to their poor permeability, numerous problems are encountered while producing from tight reservoirs. Petrophysical and geomechanical rock properties are essential for understanding and assessing the fracability of reservoirs, especially tight reservoirs, to enhance permeability. In this study, Saadi B reservoir in Halfaya Iraqi oil field is considered as the main tight reservoir. Petrophysical and geomechanical properties have been estimated using full-set well logs for a vertical well that penetrates Saadi reservoir and validated with support of diagnostic fracture injection test data employing standard equations
... Show MoreCarbonate matrix stimulation technology has progressed tremendously in the last decade through creative laboratory research and novel fluid advancements. Still, existing methods for optimizing the stimulation of wells in vast carbonate reservoirs are inadequate. Consequently, oil and gas wells are stimulated routinely to expand production and maximize recovery. Matrix acidizing is extensively used because of its low cost and ability to restore the original productivity of damaged wells and provide additional production capacity. The Ahdeb oil field lacks studies in matrix acidizing; therefore, this work provided new information on limestone acidizing in the Mishrif reservoir. Moreover, several reports have been issued on the difficulties en
... Show MoreThe current study aims to assess zooplankton diversity in Bahr Al-Najaf depression using diversity index, specimens were collected from five sites at Bahr Al-Najaf depression, Iraq during April 2017 to March 2018.
Forty-eight taxa of zooplankton were identified including 26 taxa to Copepoda, 17 taxa belonged to Rotifers and 5 taxa to Cladocera: Copepoda was the most dominant group (54.2%); Rotifera comprised (35.4%); Cladocera comprised (10.4%).
Relative abundance index of zooplankton showed Copepodite and nauplii of Harpacticoid, Hexarthra mira, Daphnia sp., Harpacticoid sp., and Copepodite and nauplii of Cyclops were more abundant. According to the constancy index
... Show MoreNoor Oil Field is one of Iraqi oil fields located in Missan province / Amarah city. This field is not subjected to licensing rounds, but depends on the national effort of Missan Oil Company. The first two wells in the field were drilled in seventies and were not opened to production until 2009. The aim of this study is to study the possibility of using the method of gas lift to increase the productivity of this field . PROSPER software was used to design the continuous gas lift by using maximum production rate in the design.
The design was made after comparing the measured pressure with the calculated pressure, this comparison show that the method of Beggs-Brill and Petroleum Exper
... Show MoreA geological model is a spatial representation of the distribution of sediments and rocks in the subsurface. Where this study on Halfaya oil field; it is located in Missan governorate, 35 km southeast of the city of Amara. It is one of the main fields in Iraq because it is production high oil. This model contains the structure, and petrophysical properties (porosity, water saturation) in three directions. To build 3D geological models of petroleum reservoirs. Khasib, Tanuma, and Sa’di formations in Halfaya oil field have been divided into many layers depending on petrophysical properties and facies.
The time spent in drilling ahead is usually a significant portion of total well cost. Drilling is an expensive operation including the cost of equipment and material used during the penetration of rock plus crew efforts in order to finish the well without serious problems. Knowing the rate of penetration should help in speculation of the cost and lead to optimize drilling outgoings. Ten wells in the Nasiriya oil field have been selected based on the availability of the data. Dynamic elastic properties of Mishrif formation in the selected wells were determined by using Interactive Petrophysics (IP V3.5) software based on the las files and log record provided. The average rate of penetration and average dynamic elastic propert
... Show MoreThis research had been achieved using 2D seismic sections to study the presence of subsurface salty bodies in the Khashim Al-Ahmer, Galabat, Injana fields as a case study. The selected oil fields is located to the northeast of Baquba city within Diyala Governorate.
The study aims to determine the salt accumulations of the selected fields and their role in the formation of oil traps.
The interpretation of seismic data was focused on two reflectors Fatha and Jeribe Formations which belong to the lower and Middle Miocene. Structurally, Two systems of reversal faults are affecting the fields, according to seismic sections, the first represents thrust faults affected on the top part of Fatha (Red Beds &
... Show MoreFive subsurface sections and a large number of thin sections of the Hartha Formation (age Late Campanian – Early Maastrichtian) were studied to unravel the depositional facies and environments. The Hartha Formation is important as an oil reservoir in Iraq.
Petrographic and microfacies analysis of selected wells from Balad and East Baghdad oil fields in Central Iraq, enable the recognition of three main Sedimentary paleoenvironments. These are restricted marine, the shallow open marine environment within the inner ramp, deep outer ramp.
The studied Formation represents by two asymmetrical cycles bounded below by sequence boundary (SB1) the contact between Hartha and Saadi Formations. The deep outer ramp facies of
... Show More