Buzurgan oil field suffers from the phenomenon of asphaltene precipitation. The serious negatives of this phenomenon are the decrease in production caused by clogging of the pores and decrease in permeability and wettability of the reservoir rocks, in addition to the blockages that occur in the pipeline transporting crude oil. The presence of laboratories in the Iraqi oil companies helped to conduct the necessary experiments, such as gas chromatography (GC) test to identify the components of crude oil and the percentages of each component, These laboratory results consider the main elements in deriving a new equation called modified colloidal instability index (MCII) equation based on a well-known global equation called colloidal in

  This study included prepared samples of epoxy reinforced by the novolac , aluminum , glass powder and epoxy reinforced by aluminum , glass powder and epoxy alone .They are used as reinforced materials of volum fraction amounting 40% .  The mechanical properties inclouded ( tensile , compressive and wear) where the wear test inclouded different applied loads (5,10,15) . From the results showed the epoxy reinforced by aluminum and glass powder has higher compressive strength (56.91) Mpa and higher tensile strength (132.2) Mpa .But the epoxy alone has higher wear rate and the epoxy reinforced by aluminum and glass powder which have higher elasticity of modulus from the tensile test (315.7) Mpa

Drilling with casing (DWC) can be considered as a modern drilling technique in which both of drilling and casing operations done in the same time by using the casing to transfer the hydraulic and mechanical power to the bit instead of traditional drilling string. To overcome oil well control, minimizing the total cost through enhancing drilling efficiency, drilling with casing was proposed as an enabling technology.

   Two surface sections (17 1/2 - and 12 1/4- inch) were drilled successfully in Rumaila oil field with  casing strings which reached 655m and 1524m measured depths respectively.

   By using DWC technique, the total drill/case phase time was reduced up to 20% comparing to conventional

The main aims purpose of this study is to find the stabilizer groups of a cubic curves over a finite field of order 16, also studying the properties of their groups, and then constructing all different cubic curves, and known which one of them is complete or not. The arcs of degree 2 which are embedding into a cubic curves of even size have been constructed.  

In this study ZnS thin film was prepared by using thermal evaporation vacuum technique under the pressure (10-6) Torr on glass substrate at room temperature and annealing at 523 K Samples were irradiated to CO2 laser of power (1 watt) and wave length (10.6) μm at distance 10 cm from the source during (5 sec). The absorbance spectra was recorded by using UV-visible spectrophotometer and used to calculated some of optical properties investigated including their transmittance, reflectance spectra, energy gap, and extinction coefficient. From the result of thin films samples at room temperature and at 523 K, we conclude that the irradiation by laser causes a decrease in the transmittance and increasing in reflection and extinction coeffic

  This researchs the preparation of particulate polymer composites from Alkyd resin and Iraqi Burn Kaolin which were added as (20%,30%,40%,50%)and comparing  with the  polymer.  It studied Thermal conductivity and Dielectric strength for both of  the Alkyd resin and  the Composite Material.        The result showed an  increase in Dielectric strength after adding the Iraqi Burn Kaolin , also the Thermal conductivity was  increased by adding the Iraqi Burn Kaolin .

       The lithostratigraphic and biostratigraphic studies of the Shiranish Formation in the Diana area, Erbil, Northern Iraq, were conducted to distinguish the main lithostratigraphic units, depositional environment and the formation age. The Shiranish Formation in the study area can be divided into three rock units. The lower and upper units consist of marly limestone, marl and limestone deposited in the outer shelf environment, while the middle unit is dominated by laminated calcareous shale and marl deposited in the upper bathyal environment. Calcareous nannofossils showed the presence of about 20 species/genera in the studied Shiranish Formation. Three biozones are identified; Misceomarginatus pleniporus biozone;

Sedimentary structures of Gercus Formation in NE Iraq was little studied in the last decades. In this study the identified sedimentary structures display alternative graded and fining upward cycles, load and flute casts, submarine channels, sand and clay balls and pillow structures, convolute and slump beddings, of marine turbidity origin. The foreland part of Tethys basin characterized by deep marine Tanjero and Kolosh Formations followed by the Gercus formation with conformable relationships. The Eocene aged Flysch comprises predominantly litharenitic sandstones and interbedded mudstones, both of turbiditic affinities and most likely derived from a NE Arabian Plate source. The sediments provide excellent examples of distal fan sands as

Biofilm formation (BF) is one of the most important virulence factors of
Candida spp. The aim of this study was to detect the prevalence of genes
responsible in biofilm formation of C. albicans by conventional PCR technique.
Among 49 vaginal specimens (VC), C. albicans was the most predominant species
in percentage 22/49 (45%) and 27(55%) were non albicans. Out of 47 oral
specimens (OS), 22/47(47%) were C. albicans, whereas 25(53%) were non albicans.
At the present study; all C. albicans were biofilm producers with variable strength,
out of 44 BF producers, 18 (40.9%) were low biofilm (LBF) with significant
differences (P<0.05) between HVS and OS, 25 (56.8%) moderate or high biofilm
(HBF) and just one isolat

      The Yamama Formation is characterized by a wide geographic extension of southern Iraq. Microfacies analysis of this formation was studied in six wells distributed in six fields: Fayhaa, Sindbad, Siba, Zubair, Ratawi and West Qurna. This research aims to determine paleoenvironments by diagnosing biofacies and lithofacies. Miscellaneous marine fauna of foraminifera and calcareous algae, mainly green algae (dasycladacean.) and skeletal bioclasts from gastropods, pelecypods, bryozoans, sponge spicules, and echinoderms were found. Petrographic studies and well logs interpretations led to the identification of five main Microfacies ( Mudstone, Wackestone, Packestone, Grainestone and Rudstone and twelve submicrofacies (Foraminiferal-