This paper presents the finite strain results from seven oriented samples data on Tertiary sandstone of Muqdadiya Formation and (400) samples of pebbles and conglomerate of Bai –Hassan Formation at the southwestern limb of Al-Tib Anticline in the Southeastern part of Iraq. Measurement and analysis of finite strain are carried out including these rocks at fluvio- lacustrine environment. The present study followed Fry method. The computed strain was, in the form of ellipses, within three prepared perpendicular  planes in a single sample and Center to Center method was used to determine the strain ratio of the these samples. The strain in the studied area is low, this is mainly due to the sampled rocks underwent brittle deformation d

In the region of the north of Iraq using the method of analyzing thin section microfacies to 38 of rockyslices which were gathered from a place near Aqra city. These slides are divided into seven microfacies depending on lithologcal component and fossils.

1) Dolostone facies.

2)Recrystallized bioclastic wackestone facies.

3) Bioclastic packstone microfacies

4)Sucrosic dolomite facies.

 5) Bioclastic grainstone in microfacies.

 According to water energy, these facies were divided to three zone:

1. a) Low energy environment.
2. b) Transitional zone.
3. c) High energy environment.

The identification of a bed’s lithology is fundamental to all reservoir characterization because the physical and chemical properties of the rock that holds hydrocarbons and/or water affect the response of every tool used to measure formation properties. The main purpose of this study is to evaluate reservoir properties and lithological identification of Nahr Umr Formation in Luhais well -12 southern Iraq. The available well logs such as (sonic, density, neutron, gamma ray, SP, and resistivity logs) are digitized using the Didger software. The petrophysical parameters such as porosity, water saturation, hydrocarbon saturation, bulk water volume, etc. were computed and interpreted using Techlog software. The lithology prediction of Nahr

Mishrif Formation regards one of the most important reservoirs in Iraq. Well logging represents one of the most important tool in the formation evaluation. According to the Petrophysical properties that have been gotten from well logging, Mishrif Formation in terms of reservoirs units, consist of several reservoirs units. Major reservoirs units divided into three reservoir units,MA,MB&MC. Each of these major units divided into minor reservoirs units (MB11,MB12,MC2&MC3).MB major reservoir units represent the best reservoir unit. These reservoirs units separated by cap rocks(mainly tight limestone)(CR1,CR2,CR3,CR4,CR5,CR6,and CR7).CPI were demonstrated for all wells.Hydrocarbon saturation vs.

Injana Formation is the most extended geological formation in Salahaddin Governorate/ Iraq. About 10% of the studied area is covered by the outcrops of the formation as a recharge area. The formation is a subsurface within the unsaturated zone in 5% of the total studied area, while it exists within the saturated zone in about 85%; it is a major confined groundwater aquifer. Therefore, the hydrogeological system of the layers needs to be re-evaluated to describe the successions of aquifers and confining layers and their relation with each other.

The lithology, depths, water table, saturated thickness, hydraulic characteristics of the aquifers, and the lateral and vertical variations of these characteristics were adopted to classif

Reservoir unit classifications can be used in reservoir characterization of carbonate reservoirs where there is variability in the distribution of petrophysical properties. This requires the integration of geological and petrophysical data at different scales. In this study, cores and thin sections from Yamama Formation (Lower Cretaceous) at Gharaf oilfield, southern Iraq, were studiedto identify reservoir units.

     Ninereservoir units (units Y1 to Y9) were identified based on petrophysical evaluation by using interactive Petrophysics program (IP) software and depositional environments and related microfacies.The unit Y2 have the highest reservoir quality, which consists of grain-supported facies(packstone a

     Yamama Formation is the most important and widespread Lower Cretaceous Formation in Iraq. Yamama Formation in the Luhais well-12 and Rifaee well-1 are composed of dolomitized in some places and foraminifera and algae bearing limestone, 19 genera and species of foraminifera, 10 genera and species of algae. Two biozones were distinguished Pseudochrysalidina arabica Range zone and Pseudocyclammina lituus Range zone. The age of the formation was determined as Berriasian – Valanginian according to these biozones of Foraminifera. In this study, bryozoa, Gastropoda and Pelecypoda are recorded but less than Foraminifera.