The Amarah Oil field structure was studied and interpreted by using 2-D seismic data obtained from the Oil Exploration company. The study is concerned with Maysan Group Formation (Kirkuk Group) which is located in southeastern Iraq and belongs to the Tertiary Age. Two reflectors were detected based on synthetic seismograms and well logs (top and bottom Missan Group). Structural maps were derived from seismic reflection interpretations to obtain the location and direction of the sedimentary basin. Two-way time and depth maps were conducted depending on the structural interpretation of the picked reflectors to show several structural features. These included three types of closures, namely two anticlines extended in the directions of S-SW and NE, one nose structure (anticline) in the middle of the study area, and structural faults in the northeastern part of the area, which is consistent with the general fault pattern. The seismic interpretation showed the presence of some stratigraphic features. Stratigraphic trap at the eastern part of the field, along with other phenomena, such as flatspot (mound), lenses, onlap, and toplap, were detected as indications of potential hydrocarbon accumulation in the region.
The reservoir units of Mishrif Formation in Majnoon oil field were studied by using available wireline logs (gamma ray, porosity and resistivity) and facies that derived from core and cutting samples for three wells including Mj-1, Mj-15, and Mj-20. The reservoir properties were determined and interpreted by using IP software. The results showed that unit D have the best reservoir properties due to high effective porosity, low water saturation and very low volume of shale. Furthermore, a large part of this unit was deposited in shoal environment. The other reservoir units are then graded in reservoir properties including units B, A, F & E respectively, except unit C, which is considered as a cap unit, because it consists of rest
... Show MoreOne of the most important problems in the oil production process and when its continuous flow, is emulsified oil (w/o emulsion), which in turn causes many problems, from the production line to the extended pipelines that are then transported to the oil refining process. It was observed that the nanomaterial (SiO2) supported the separation process by adding it to the emulsion sample and showed a high separation rate with the demulsifiers (RB6000) and (sebamax) where the percentage of separation was greater than (90 and 80 )% respectively, and less than that when dealing with (Sodium dodecyl sulfate and Diethylene glycol), the percentage of separation was (60% and 50%) respectively.
The high proportion
... Show MoreThe Yamama Formation belongs to the late Berriasian-Aptian succession, which was deposited during the Lower Cretaceous period within the main shallow marine depositional environment.
Petrographic study and microfacies analysis enabled the recognition of six main microfacies for three association facies. These are the Semi-restricted, Shallow open marine and Shoal environments. The study succession represents deposition of three third order cycles, these cycles where deposited during successive episodes of relative sea level rises and still stand.
The presence of shoal association facies (oolitic packstone microfaces) between the Sulaiy and Yamama formations refer to continue the deposition during the same stage, and may s
... Show MoreThe objective of this paper is determining the petrophysical properties of the Mauddud Formation (Albian-Early Turonian) in Ratawi Oil Field depending on the well logs data by using interactive petrophysical software IP (V4.5). We evaluated parameters of available logs that control the reservoir properties of the formation, including shale volume, effective porosity, and water saturation. Mauddud Formation is divided into five units, which are distinguished by various reservoir characteristics. These units are A, B, C, D, and E. Through analyzing results of the computer processed interpretation (CPI) of available wells, we observed that the main reservoir units are B and D, being distinguished by elevated values of eff
... Show MoreThe current study includes preparing a geometric proposal of the main parameters that must be worked within a seismic reflection survey to prepare a three-dimensional subsurface image. This image represents the Siba oil field located in Basra, southern Iraq. The results were based on two options for selecting these approved elements to create a three-dimensional image of the Mishrif, Zubair and Yamama formations as well as the Jurassic and Permian Khuff and the pre-Khuff reservoir area. The first option is represented in the geometry in option -1 is 12 lines, 6 shots, and 216 chs. The receiver density is 66.67 receivers / km2, so the shot density is the same. Total shots are 21000, which is the same number of receiv
... Show MoreDiagenetic processes and types of pores that control the reservoir properties are studied for Mauddud Formation in selected wells of Badra oil field, central Iraq. The microscopic study of the thin sections shows the effects of micritization, cementation, neomorphism, dissolution, dolomitization, compaction, and fracturing on Mauddud Formation carbonate microfacies. The decrease of porosity is resulted from cementation, compaction, and neomorphism. Different types of calcite cement occlude pore spaces such as drusy cement, syntaxial rim cement, and granular (blocky) cement. The neomorphism of micritic matrix and skeletal grains reduces porosity as indicated by development of microspar or pseudospar. Evidence of decreasing porosity by com
... Show MoreAn interpretive study of two-dimension seismic data of the Huwaiza oilfield was carried out using Petrel 2015 program. Twenty seismic section were used, these seismic sections were carried out at three-time stages: HH survey in 1976, 2HH survey in 1978 and AM in 1980. Mishrif and Nahr Umr reservoirs were selected to study because they are the most important reservoirs in the neighbor fields. The study showed that the structure is an anticline trending North-South, so that the field may belong to Zubair tectonic subzone rather than Tigris subzone, which is northwest-southeast trending. A hypothetical model was drawn up showing the extension of the field in the Iraqi and Iranian territories based on information from both sides, it showed t
... Show MoreThe identification of a bed’s lithology is fundamental to all reservoir characterization because the physical and chemical properties of the rock that holds hydrocarbons and/or water affect the response of every tool used to measure formation properties. The main purpose of this study is to evaluate reservoir properties and lithological identification of Nahr Umr Formation in Luhais well -12 southern Iraq. The available well logs such as (sonic, density, neutron, gamma ray, SP, and resistivity logs) are digitized using the Didger software. The petrophysical parameters such as porosity, water saturation, hydrocarbon saturation, bulk water volume, etc. were computed and interpreted using Techlog software. The lithology prediction of Nahr
... Show MoreZubair Formation is the most productive reservoir in southern Iraq, which is comprised of sandstones, interbedded with shale sequences and sometimes carbonate rock. It is an important formation in the lower Cretaceous cycle in Iraq. Rumaila oil field is the largest oil field in Iraq and the 6th in the world. Two wells were studied for three depths, one in the southern Rumaila and the other in the north. The study focused on light and heavy minerals in sand fractions and their relationship with hydrocarbon assemblages. For the survey to be complete, the sedimentological study of the cores was also conducted. This research aims to determine the effect of the amount of heavy and light minerals on the generation and production of
... Show MoreThe study intends to well logs interpretation to determine the petrophysical parameters of Euphrates Formations in Ajeel Oil Field. The petrophysical properties have been determined from well logging, Euphrates Formation in terms of reservoirs units, consist of two Petrophysical properties. Total porosity, effect porosity and secondary porosity have been calculated from neutron, density, and sonic logs. secondary porosity is high and it's resulted from diagenesis processes in the formation. From RHOB-NPHI and N/M cross plot, Euphrates Formation composed mainly from Limestone and dolomite with nodules of anhydrite. Dhiban Formation composed mainly of anhydrite, so it's represented the cap rocks for Euphrates Reservoir were recognized base
... Show More