The study area is part of the city of Samawa in Al Muthanna Governorate in southern Iraq. The study area is located to the west of Samawa city bounded by the north latitudes 31⁰11'-31o42' and east longitudes 44o58'- 45⁰16'and its groundwater resources are developed for supply and irrigation purposes. In order to evaluate the quality of groundwater in the study area, twenty three groundwater samples were collected and analyzed for physical and chemical parameters. Hydrochemical analysis showed that the groundwater of the study area is excessively mineralized and very hard. The increase in flow length of groundwater in the study area caused a change in water quality from bicarbonate to sulfate and chloride. The abundance of the major ions is as follows: SO4> CL>HCO3>NO3and Na>Ca>Mg>K. The dominant type of groundwater is Na+- sulfate. The water of the studied wells is not suitable for human drinking. Depending on TDS and EC values, most samples of the water are moderate saline class for irrigation. Most wells are good to permissible (wells No.4,14,17) and doubtful (well No. 12) for irrigation depending on Na%, while unsuitable for irrigation depending on EC (except well No. 17 which is permissible). Excellent water class (S1)for agriculture was recorded depending on SAR, except for well N0.2 which had an a good class (S2).
Climate change causes water shortage (water scarcity) in addition to the dams built by neighboring countries, which caused a lack of Iraq's water share. Therefore, evaluating the irrigation system requires considering its suitability, adequacy, and efficiency. Irrigation is considered adequate when it maintains water availability within the root zone, and if the amount to be added is determined, irrigation efficiency becomes possible by avoiding water loss. Babil Governorate is considered one of the agricultural governorates in the country that depends on its irrigation from Shatt Al-Hilla. The study area is the Elaj project. Three fields were selected for the project (B1, B2, and B3). These fields are lo
... Show MoreThis study focused on two areas in AL-Najaf city, AL-Ruhbah and Al-Haydariyah regions because of the importance and widespread use of groundwater in these areas. The two areas were compared quantitatively and qualitatively. For the quantitative approach, the GMS software was used in conjunction with the GIS software to simulate the groundwater flow behavior. The solid model for both areas was created, the geological formation was determined, and the hydraulic properties were identified using GMS software. To test the quantity of groundwater in both areas, the wells have been redistributed to a distance of 2000 m between them, and a period of 1000 days was chosen. When a discharge of 10 l/s and operation times of 4, 8, an
... Show MorePurification of fifteen NaCl samples from natural and different area in the middle and south of Iraq are prepared and studied the structural characteristics of samples by powder X-ray diffraction analysis at ð›Œ=1.542Ã…. The present work considered the specific activities of naturally occurring radioactive materials in salt samples, which are measured and analyzed using high resolution HPGe system. Also, the radiological parameters have been considered in this work. The average specific concentration (in Bq.kg-1) of the salt samples is found 16.864.92 for 226Ra, 5.972.05 for 232Th and 9.852.8 for 40K, respectively, which are below the national levels, 40Bq.kg-1, 30Bq.k
... Show MoreThis paper presents studying the performance of three types of polyethersulfone (PES) membrane for the simultaneous removal of Co2+ ions, Cd2+ ions, and Pb2+ ions from binary and ternary aqueous solutions. Co2+ ions, Cd2+ ions, and Pb2+ ions with two different initial concentrations (e.g., 10 and 50 ppm) were selected as examples of heavy metals that contaminate the groundwater as a result of geological and human activities. This study investigated the effect of types of PES membrane and metal ions concentration on the separation process. For the binary aqueous solutions, the permeation flux of the PES2 membranes was higher for the separation process of solutions containing 50 ppm of Cd2+ ions and 10 ppm of Co2+ ions (24.7 L
... Show MoreIn order to reduce hydrostatic pressure in oil wells and produce oil from dead oil wells, laboratory rig was constructed, by injecting LPG through pipe containing mixture of two to one part of East Baghdad crude oil and water. The used pressure of injection was 2.0 bar, which results the hydrostatic pressure reduction around 246 to 222 mbar and flow rate of 34.5 liter/hr fluid (oil-water), at 220 cm injection depth. Effects of other operating parameters were also studied on the behavior of two phase flow and on the production of oil from dead oil wells.
This study aims to evaluate the performance of the sewage treatment plant in Al- Diwaniya, one of cities in the southern part in Iraq. This evaluation could be used to facilitate effluent quality assessment or optimal process control of the plant. The influent reaching the plant is considered a medium to strong in strength with BOD5/COD ratio in the range 0.23 and 0.69 which can be considered an easily degradable sewage by the biological processes performed by the activated sludge unit. The quality of the effluent was found to be higher than the Iraqi standards for disposal to water bodies. The BOD5/COD ratios of the treated sewage varied over a wide range as low of 0.13 to 1.48 indicating operational problems in the plant. Regressio
... Show MoreThis study aims to evaluate the performance of the sewage treatment plant in Al-Diwaniya, one of cities in the southern part in Iraq. This evaluation could be used to facilitate effluent quality assessment or optimal process control of the plant. The influent reaching the plant is considered a medium to strong in strength with BOD5/COD ratio in the range 0.23 and 0.69 which can be considered an easily degradable sewage by the biological processes performed by the activated sludge unit. The quality of the effluent was found to be higher than the Iraqi standards for disposal to water bodies. The BOD5/COD ratios of the treated sewage varied over a wide range as low of 0.13 to 1.48 indicating operational problems in the plant. Regression ana
... Show MoreThe cutting transport problem in the drilling operation is very complex because many parameters impact the process, which is nonlinearity interconnected. It is an important factor affecting time, cost and quality of the deviated and horizontal well. The main objective is to evaluate the influence of main drilling Parameters, rheological properties and cuttings that characterise lifting capacity through calculating the minimum flow rate required and cutting bed height and investigate these factors and how they influenced stuck pipe problems in deviated wells for Garraf oil field. The results obtained from simulations using Well Plan™ Software were showed that increasing viscosity depends on other conditions for an increase or dec
... Show MoreThe research aims to assess the claystone exposed in the Nfayil Formation (Middle Miocene) for Portland cement (P.C.) manufacturing based on mineralogy and geochemistry. The importance of the study is to avoid the miming of the agricultural soils that are mining now for the cement industry. Claystones of Nfayil Formation and the limestone of the Euphrates Formation were used to design the raw mixture as clay to limestone (1:3). The chemical composition (%) of the designed mixture was calculated using the Alligation Alternative Method (A.A.M.) as CaO (65.52), MgO (1.05), SiO2 (21.65), Al2O3 (7.43), Fe2O3 (2.62), Na2O3+K2O (1.52) and SO3 (0.26), which are suitable for P.C. The lime saturation factor (LSF = 92.8), silica saturation fac
... Show MoreThe main aim of this research is to define the mineralogical composition of recent sediments deposited around the Al-Teeb river basin in eastern Missan, trying to determine the provenance or the source of these sediments.
The study area represents the southeastern edge of the Mesopotamian Plain and is part of it. Quaternary deposits cover most of the area. It is clayey with old sea and river deposits and part of aeolian deposits.
These sediments cover 95% of the study area, while the older rocks, which date back to the Tertiary (Late Miocene – Pliocene), exposed in the area east and northeast of the Al-Teeb area, made up hills which back to the undifferentiated Pliocene Mukdadiya and Bai-Hassan f
... Show More