Abstract

Stainless steel (AISI 304) has good electrical and thermal conductivities, good corrosion resistance at ambient temperature, apart from these it is cheap and abundantly available; but has good mechanical properties such as hardness. To improve the  hardness and corrosion resistance of stainless steel its surface can be modified by developing nanocomposite coatings applied on its surface. The main objective of this paper is to study effect of electroco-deposition method on microhardness and corrosion resistance of stainless steel, and to analyze effect of nanoparticles (Al₂O₃, ZrO₂ , and SiC)  on properties of composite coatings. I

There are no single materials which can withstand all the extreme operating conditions in modern technology.  Protection of the metals from hostile environments has therefore become a technical and economic necessity.  

In this work, for enhancing their wear-resistance, boride layers were deposited on the surface of low carbon steel by a pack cementation method at 850 °C for (2, 4, and 6) h using vacuum furnace. The boronizing process was achieved using different concentration of boron source (20, 25, and 30) % wt. into coating mixture to optimize the best conditions which ensure the higher properties with lower time. The coating was characteristic by X ray diffraction (XRD), and it is confirmed t

Granular carbon can be used after conventional filtration of suspended matter or, as a combination of filtration - adsorption medium. The choice of equipment depends on the severity of the organic removal problem, the availability of existing equipment, and the desired improvement of adsorption condition.
Design calculations on dechlorination by granular - carbon filters considering the effects of flow rate, pH , contact time, head loss and bed expansion in backwashing , particle size, and physical characteristics were considered assuming the absence of bacteria or any organic interface .

     As a result of changes in the chemical properties of the Shatt al-Arab River, especially in the last decade, as well as the lack of rainfall and the effect of seawater intrusion into the Shatt al-Arab, this study was conducted to investigate the possible changes in the water pipelines like corrosive and scaling which Shatt al-Arab River is the source of water supply for domestic use. Domestic water samples were collected from 10 various locations in Basrah to study the water's tendency to be corrosive or form scales along the pipelines. The Langelier Index, Ryznar Index, Larson-Skold Index, and Saturation Index were used to determine the corrosivity potential of water based on physical and chemical parameters. Most domestic wate

This work involves the preparation of the ligand [KL] :-                    Â­Â­Â­Â­Â­Â­

K[4-(N-(5-methylisoxazol-3-yl) sulfamyl) phenylcarbamodithioate] from the reaction of sulfamethoxazole  with Carbon disulfide  in the presence of  potassium hydroxide under reflux (4 hours) using methanol as asolvent. The prepared ligand was characterized using FT-IR, UV-Vis, ¹H,¹³C–NMR spectroscopy, molar conductivity and melting point,  Complexes for the above ligand [KL] with some bivalent transition and non-transition metals (Mn ⁺², Co⁺²  , Ni⁺²  ,

A new Schiff base, 2-N( 4- N,N – dimethyl benzyliden )5 – (p- methoxy phenyl) – 1,3,4- thiodiazol ,and their metal complexes Cu (Π) ,Ni (Π),         Fe (III) , Pd (Π) , Pt (IV) , Zn(Π) ,V(IV) and Co (Π) , were synthesized. The prepared complexes were identified and their structural geometries were suggested by using flam atomic absorption technique , FT-IR and Uv-Vis spectroscopy, in addition to magnetic susceptibility and conductivity measurements. The study of the nature of the complexes formed in ethanol solution , following the mole ratio method , gave results which were compared successfully with those obtained from the isolated solid state studied. Structur

Permeability determination in Carbonate reservoir is a complex problem, due to their capability to be tight and heterogeneous, also core samples are usually only available for few wells therefore predicting permeability with low cost and reliable accuracy is an important issue, for this reason permeability predictive models become very desirable.

   This paper will try to develop the permeability predictive model for one of  Iraqi carbonate reservoir from core and well log data using the principle of Hydraulic Flow Units (HFUs). HFU is a function of Flow Zone Indicator (FZI) which is a good parameter to determine (HFUs).

   Histogram analysis, probability analysis and Log-Log plot of Reservoir Qua

The Diwan of Imam Al-Shafi’i acquires great importance, as Al-Shafi’i is an authority in the language, and when I saw that no one had preceded me in exploring its depths, I took my tool and turned my face towards it intending to study the triple verb in it. I stop at these verbs and the student pauses for their morphological forms, looking at the significance of the triple verb more with one letter, two letters, and three letters, and I found that they are many, and such research cannot contain them all, so the choice came to choose the triple verb more with one letter, and the significance of the increase in it, as the increase in The building necessitates an increase in the meaning, and from here the study was limited to the triple

Support Vector Machine (SVM) is supervised machine learning technique which has become a popular technique for e-mail classifiers because its performance improves the accuracy of classification. The proposed method combines gain ratio (GR) which is feature selection method with one-class training SVM to increase the efficiency of the detection process and decrease the cost. The results show high accuracy up to 100% and less error rate with less number of feature to 5 features.