The wide use of lead compounds as an engine anti-knock reflects conversely on all components of the ecosystem. This study aimed to detect the concentration of lead in various types of gasoline and gas oil that are highly consumed by vehicles. Eight fuel samples were collected from different feul stations distributed in different districts of Baghdad city. These included two gas oil (diesel) stations and three stations for each type of gasoline (leaded and unleaded). Lead was extracted by the modified chemical method, and then flame atomic absorption technique was applied to assay its concentrations. The results indicated that lead levels were within permitted limits (150 mg Lead L-1) recommended by the international agencies. The highest lead mean concentration was 105 mg/L, recorded in Latifiya leaded gasoline, whereas the lowest mean was 3.1mg/L in unleaded gasoline imported from the United Arab Emirate. As for gas oil, lead concentration occurred within a mean of 1.85-2.05 mg/L. The influence of some leaded gasoline improvements, octane booster and octane plus, was estimated, which revealed sharp declines in lead mean concentrationsto values of 1.05 and 5.2 mg/L for Latifiya and Rusafa gasoline, respectively. Furthermore, the daily lead emission was estimated for the registered vehicles in Baghdad and revealed a high concentration of 1837.7 µg lead m-3 for private cars. This study proposes avoiding the addition of lead compounds to fuel, in order to reduce its adverse effects on general health, and raising the awareness of society to this problem.
Petrophysical properties evaluation from well log analysis has always been crucial for the identification and assessment of hydrocarbon bearing zones. East Baghdad field is located 10 km east of Baghdad city, where the southern area includes the two southern portions of the field, Khasib formation is the main reservoir of East Baghdad oil field.
In this paper, well log data of nine wells have been environmentally corrected, where the corrected data used to determine lithology, shale volume, porosity, and water saturation. Lithology identified by two methods; neutron-density and M-N matrix plots, while the shale volume estimated by single shale indicator and dual shale indicator, The porosity is calculated from the three common po
... Show MoreThis field experiment, was conducted to investigate a comparison of two methods for harvesting potatoes: mechanical and handy when using moldboard and chisel plow for primary tillage and three different distances for planting tubers in the rows 15, 25, and 35 cm in silt clay loam soil south of Baghdad. The factorial experiment followed a randomized complete block design with three replications using L.S.D. 5 % and 1 %. Mechanical harvest recorded the best valid potato tubers at 88.78 %, marketable yield of 31.74 ton. ha-1, efficiency lifted 95.68 %, tubers damage index 28.41, speeding up the harvesting process and reducing time and effort. Handy harvest gave the least damage to potato tubers, 6.02 %, and unlifted potato tubers, 4.32 %. Howe
... Show MoreCongenital toxoplasmosis (CT) and congenital rubella (CR) infections are well-known causes potentially leading to devastating consequences. This report aims to address the prevalence of each of these infections among suspected infants in a pediatric hospital in Baghdad.
The study sample includes 120 blood samples of suspected infants consulting Al-Alwyia pediatric teaching hospital over one year. This report represents an extension of a previous article published in Al-Kindy College Medical Journal KCMJ about cytomegalovirus infection (CMV). Using the enzyme-linked immunosorbent assay (ELISA) method, the results show that 5.8% and 5% were positive for specific IgM antibodies for rubella and toxoplasmosis respectively. Results also
... Show MoreThe results of the present study showed that twenty-five samples were collected for the age group 35–40 years and four samples for the age group 65–70 years for both genders. The results showed that 48 (48%) of the samples were obtained from the hands, 16 (16%) from the legs, 12 (12%) from the abdominal area, and 10 (10%) from the chest area. The four (4%) samples were obtained from burns in the back and thighs area. The samples taken according to the cause of burns were 40 (40%) due to hot water, hot liquids, or hot steam, followed by 18 (18%) due to the use of hot tools, 15 (15%) due to fires, 12 (12%) due to electric currents, 10 (10%) due to chemicals such as strong acids, alkaline lye, paint thinner, or gasoline, and 5 (5%) due
... Show MoreJournal of Physics: Conference Series PAPER • THE FOLLOWING ARTICLE ISOPEN ACCESS Estimate the Rate of Contamination in Baghdad Soils By Using Numerical Method Luma Naji Mohammed Tawfiq1, Nadia H Al-Noor2 and Taghreed H Al-Noor1 Published under licence by IOP Publishing Ltd Journal of Physics: Conference Series, Volume 1294, Issue 3 Citation Luma Naji Mohammed Tawfiq et al 2019 J. Phys.: Conf. Ser. 1294 032020 DOI 10.1088/1742-6596/1294/3/032020 DownloadArticle PDF References Download PDF 135 Total downloads 88 total citations on Dimensions. Turn on MathJax Share this article Share this content via email Share on Facebook (opens new window) Share on Twitter (opens new window) Share on Mendeley (opens new window) Hide article and author
... Show MoreThe aim of this paper is to evaluate the rate of contamination in soils by using accurate numerical method as a suitable tool to evaluate the concentration of heavy metals in soil. In particular, 2D –interpolation methods are applied in the models of the spread the metals in different direction.The paper illustrates the importance of the numerical method in different applications, especially nvironment contamination. Basically, there are many roles for approximating functions. Thus, the approximating of function namely the analytical expression may be expressed; the most common type being is polynomials, which are the easy implemented and simplest methods of approximation. In this paper the divided difference formula is used and extended
... Show MorePseudomonas aeruginosa and Klebsiella pneumoniae appears good growth when replicate to culture with heavy crude oil. K. pneumoniae was less ability to biodegrade the heavy crude oil (66.22 wt.%) compare with P. aeruginosa 74 wt.%). Also the emulsion percent were about 64.8 % and 62.5 % for K. pneumoniae and P. aeruginosa, respectively. The results showed that the emulsions produced from both the strains decrease the surface tension of the media from 68.43 Mn/m (for control sample) to 44.50 and 43.30 Mn/m for P. aeruginosa and K. pneumoniae, respectively. The optimum temperature and pH for the hydrocarbons biodegradation were 28 ºC and 7, respectively. The incubation period of 28 days of the isolated increased hydrocarbons biodegradation
... Show MoreBackground: Antibiotics are among the most commonly used medicine, in both community and hospital setting, all over the world especially in countries where no strict guideline to regulate their use. In Iraq, only a few studies conducted to describe the antibiotic prescription pattern in general hospitalsand even less in pediatric hospital.
Objective: To describe the patterns for antibiotics used in Elwia pediatric teaching hospital in Baghdad, Iraq
Type of the study: Descriptive cross sectional study.
.Methodology: The study was conducted at AL-Elwia Pediatric Teaching Hospitalduring the year 2016. A random sample from all the prescriptions sheets
... Show More