Geophysical and petrographic evaluation of the earth’s subsurface is of vital concern, especially prior to geotechnical and hydrogeology works. Vertical Electrical Sounding (VES) of Ire-Akari Estate of Apatapiti Community in Akure South was carried out to assess the effects of the petrographic properties of charnockitic rocks on the geotechnical and hydrogeologic systems. The three curve types identified within the study area are AA, KH and HA, with a predominance of KH curve type, which suggests that the predominant geologic sequence comprising the topsoil has a clayey content alternating with laterite. This is underlain by weathered layer and fresh bedrock. Petrographic analyses revealed the presence of plagioclase (Albite-Anorthite), hypersthene, biotite, quartz, hornblende, microcline, pyroxene and dark-coloured minerals, with an average modal composition of 31%, 15%, 11%, 18%, 13%, 1%, 5% and 6%, respectively. A correlation of both results showed that the topsoil is mostly of about 0.4 m to 2 m thick layer of clay, indicative of weathering of feldspars. This is underlain by 0.8 m to 7 m thick layer of lateritic clay which responds as a low resistive layer. However, the mineral composition at location 1 is characterized by rocks that are more resistant to weathering due to the presence of low plagioclase in the rock sample compared to samples from other locations with a higher percentage of plagioclase and hypersthene minerals. This implies that weathering condition at all locations except location 1 could be favorable to hydrogeology if there are interconnected fractures in the parent rock (charnockite). However, since the area is predominantly covered by clayey materials which are established as poor foundational materials, appropriate ground improvement techniques and in-depth geotechnical analyses should be performed to forestall hazards associated with them.
Iron-Epoxy composite samples were prepared by added
different weight percentages (0, 5, 10, 15, and 20 wt %) from Iron
particles in the range of (30-40μm) as a particle size. The contents
were mixed carefully, and placed a circular dies with a diameter of
2.5 cm. Different mechanical tests (Shore D Hardness, Tensile
strength, and Impact strength ) were carried out for all samples. The
samples were immersed in water for ten weeks, and after two weeks
the samples were take-out and drying to conducting all mechanical
tests were repeated for all samples. The hardness values increased
when the Iron particle concentration increased while the Impact
strength is not affected by the increasing of Iron particles
c
Background: Exposure to microwaves radiation from microwave oven may be harmful for users especially for the one who have highest contact with microwave oven. Because the body is electrochemical in nature, any force that disrupts or changes human electrochemical events will affect the physiology of the body by destabilization and interruption of many chemical body substance including growth factors.The insulin-like growth factors (IGFs) are a family of mitogenic proteins that control growth, differentiation, and the maintenance of differentiated function in numerous tissues. It fulfils an important role in growth and development of teeth, mandible, maxillae, and tongue. Platelet derived growth factors (PDGF) are proteins that regulate cell
... Show MoreThin films of CdS:Cu were deposited onto glass substrate temperature 400 °c. The optieal properties have been studied for Cds doped with (1,3, 8) wt% of Cu before and after Gamma irradiation. It was found that the irradiation caused an ( Frenkel defects) where the atom is displaced from its original site leaving vacancy and forming on interstitial atom. It was found the irradiation caused an absorption edge shifting towards long wavelength as a result of the increasing of Cu concentration.
Abstract: This paper presents the results of the structural and optical analysis of CdS thin films prepared by Spray of Pyrolysis (SP) technique. The deposited CdS films were characterized using spectrophotometer and the effect of Sulfide on the structural properties of the films was investigated through the analysis of X-ray diffraction pattern (XRD). The growth of crystal became stronger and more oriented as seen in the X-ray diffraction pattern. The studying of X-ray diffraction showed that; all the films have the hexagonal structure with lattice constants a=b=4.1358 and c=6.7156A°, the crystallite size of the CdS thin films increases and strain (ε) as well as the dislocation density (δ) decreases. Also, the optical properties of the
... Show MoreSixty samples of commercially available contact lens solutions were collected from students at the Pharmacy College/Baghdad University. The types of lenses used varied from medical to cosmetic. They were cultured to diagnose any microbial contamination within the solutions. Both used and unused solutions were subject for culturing. Thirty six (60%) used samples showed bacterial growth, fungal growth was absent. Pseudomonas aeruginosa accounts for the highest number of isolates (25%) followed by E. coli (21%), Staphylococcus epidermidis (6.6%), Pseudomonas fluorescence (5%) and Proteus mirabilis (1.6%) respectively. Only one (1) unused (sealed) sample showed growth of P. fluorescence.
... Show MoreIn the present work, experimental tests was done to explain the effect of insulation and water level on the yield output. Linear basin, single slope solar still used to do this purpose. The test was done from May to August 2017 in Mosul City-Iraq (Latitude: Longitude: Elevation: 200 m, and South-East face). Experimental results showed that the yield output of the still increased by 20.785% and 19.864% in case of using thermal insulation at 4cm and 5cm respectively, also the yield output decrease by 15.134% as the water level increase from 4 to 5cm, with the presence of insulation and 14.147% without it. It has been conclude that the insulation and water level play important role in the process of passive
... Show MoreThermal conductivity of compacted bentonite is one of the most important properties where this type of clay is proposed for use as a buffer material. In this study, Lee's disc method was used to measure the thermal conductivity of compacted bentonite specimens. The experimental results have been analyzed to observe the three major factors affecting the thermal conductivity of bentonite buffer material. While the clay density reaches to a target value, the measurement is taken to evaluate the thermal conductivity. By repeating this procedure, a relationship between clay dry density and thermal conductivity has been established in specimens after adjusting the water contents of the bentonite by placing its specimens in a drying oven for diffe
... Show More