In this paper, an analytical study for the behavior of ionospheric parameters (Maximum Usable Frequency (MUF) and Optimum Traffic Frequency (FOT)) has been preformed between transmitter station (Baghdad) and many different receiver stations which are distributed randomly over Iraqi territory. The ionospheric parameters dataset has been made using ICEPAC communication model for annual time for the years 2009-2011 of the solar cycle 24. A simplified ionospheric model has been suggested which based on the correlated relationship between the geographical locations coordinates (longitudes & latitudes) of receiver stations and the dataset of the MUF and FOT parameters. The results of this study showed that the correlation between the ionospheric parameters and geographical location coordinates can be expressed as linear surface equation. The predicated ionospheric parameters values using the suggested empirical model show a good fitting with theoretical values that calculated using the international models.
The potential application of granules of brick waste (GBW) as a low-cost sorbent for removal of Ni+2ions from aqueous solutions has been studied. The properties of GBW were determined through several tests such as X-Ray diffraction (XRD), Energy dispersive X-ray (EDX), Scanning electron microscopy (SEM), and BET surface area. In batch tests, the influence of several operating parameters including contact time, initial concentration, agitation speed, and the dose of GBW was investigated. The best values of these parameters that provided maximum removal efficiency of nickel (39.4%) were 1.5 hr, 50 mg/L, 250 rpm, and 1.8 g/100mL, respectively. The adsorption data obtained by batch experiments subjected to the Three i
... Show MoreNon-alcoholic fatty liver disease (NAFLD) has become one of the most common chronic liver diseases worldwide, which characterized by steatosis, inflammation, and fibrosis. The aim of this designed study is to evaluate the ability of guggulsterone to prevent high fat diet induced steatohepatitis in mice. Five groups of male mice were selected and treated as the following: group I, mice had free access to standard commercial diet and considered as control group, group II, mice were fed a specially formulated high-fat diet for 12 weeks to induce non-alcoholic liver disease, while groups III, IV and V the mice were administered high fat diet containing guggulsterone at 500, 1000 and 2000 ppm concentration respectively for 12 weeks. Maintaini
... Show MoreThe location of the study area is surging hills in Bongomene area, Gorontalo, Indonesia. In this study, a geological survey and sampling were taken, and then an analysis of the content of benthic foraminifera was performed in each sample. The study aims to discover the species of benthic foraminifera fossils and to determine the paleobathymetry to the studied regions. The results of the analysis contained seven fossils species, namely Ammomassilina alveoliniformis, Stelligerum astrononion, Haynesia germanica, Nonion fabum, Praeglobobulimina ovata, Rhabdammina discreata and Saccorhiza ramosa. Based on the content of benthic foraminifera fossils, paleobathymetry is determined as Middle Shelf to Outer
... Show MoreThis study is to investigate the possibility of using activated carbon prepared from Iraqi date-pits (ADP) which are produced from palm trees (Phoenix dactylifera L.) as low-cost reactive material in the permeable reactive barrier (PRB) for treating lead (Pb<sup>+2</sup>) from the contaminated groundwater, and then compare the results experimentally with other common reactive materials such as commercial activated carbon (CAC), zeolite pellets (ZP). Factors influencing sorption such as contact time, initial pH of the solution, sorbent dosage, agitation speed, and initial lead concentration has been studied. Two isotherm models were used for the description of sorption data (Langmuir and Freundlich). The maximum lead sorp
... Show MoreThe specifications of lubricating oil are fundamentally the final product of materials that have been added for producing the desired properties. In this research, spherical nanoparticles copper oxide (CuO) and titanium oxides (TiO2) are added to SAE 15W40 engine oil to study the thermal conductivity, stability, viscosity of nano-lubricants, which are prepared at different concentrations of 0.1%, 0.2%, 0.5%, and 1% by weight, and also their pour point, and flash point as five quality parameters. The obtained results show that CuO nanoparticles in all cases, give the best functionality and effect on engine oil with respect to TiO2. With 0.1 wt. % concentration, the thermal conductivity of CuO/oil and TiO2/
... Show MoreThe city of Baghdad has recently witnessed an increase in urban land due to the recent economic growth, which negatively affected the environment of the study area through the retraction of the agricultural lands surrounding the city. Therefore, we studied the relationship between increasing urban expansion and changes in the local climate of Baghdad for the period from 2008 to 2018. The information derived from the satellites utilized in this search showed the changes in ground cover during the study period, while the evaporation rate data source from the European Center for Forecasting (ECMWF) confirmed the effects of urban expansion on evaporation rates. Increasing urbanization increased evaporation rates and decreased vegetation degr
... Show MoreTwo new halogenated azo-Schiff ligands were prepared in two steps. The first step included a condensation between 4-amino acetophenone and 2-fluoro-4-bromo aniline to give the corresponding Schiff base. In the second step, the diazonium salt of this Schiff base reacted with 2-naphthol and 4,5-diphenylimidazole to form two new azo-Schiff base derivatives as ligands; (3-((E)-(4-((E)-1-((4-bromo-2-fluorophenyl) imino)ethyl) phenyl) diazenyl) naphthalen-2-ol (HSBAN) (L1) and ((E)-N-(4-bromo-2-fluorophenyl)-1-(4-((E)-(4,5-diphenyl-1H-imidazol-2-yl)diazenyl) phenyl) ethan-1-imine) (HSBAI) (L2), respectively. These new ligands were characterized by mass spectrometry, FT-IR, 1H NMR, UV-Visible spectroscopy and elemental microanalysi
... Show MoreIn this study, six square reinforced concrete flat plates with dimensions of (1500×1500×100) mm were tested under a concentrated load applied on a column located at the center of the slabs. One of these slabs was the control specimen, whereas, in the others, steel angles (steel collars) were used, fixed at the connection region between the slab and the column to investigate the effect of the presence of these collars on punching shear strength. Five thicknesses were used (4, 5, 6, 8, 10mm) with constant legs of angles (75×75) mm of the steel collars to investigate the effects on the punching shear resistance with respect to the control slab. The results of the experimental study show that the punching shear resistance increased b
... Show MoreIn this paper, an eco-epidemiological model with media coverage effect is proposed and studied. A prey-predator model with modified Leslie-Gower and functional response is studied. An -type of disease in prey is considered. The existence, uniqueness and boundedness of the solution of the model are discussed. The local and global stability of this system are carried out. The conditions for the persistence of all species are established. The local bifurcation in the model is studied. Finally, numerical simulations are conducted to illustrate the analytical results.
The process of digital transformation is considered one of the most influential matters in circulation at the present time, as it seeks to integrate computer-based technologies into the public services provided by companies or institutions. To achieve digital transformation, basics and points must be established, while relying on a set of employee skills and involving customers in developing this process. Today, all governments are seeking electronic transformation by converting all public services into digital, where changes in cybersecurity must be taken into account, which constitutes a large part of the priorities of nations and companies. The vulnerability to cyberspace, the development of technologies and devices, and the use
... Show More