This paper is carried out to detect the subsurface structures that have geological
and economical importance by interpreting the available reflection seismic data of
an area estimated to be about (740) km2. The Khashim Al-Ahmer structure is partial
of series structures of (Injana – Khashim Al-Ahmer – Mannsorya) from the (NW to
the SE), it is located within for deep faulted area. The component of the one
elongated dome of asymmetrical of structure which has(SW) limb more steeper than
the (NE) limb.Twenty three seismic sections had been interpreted for two seismic
surveys and the total length of all seismic lines is about (414.7) Km. Interpretation
of seismic data was focused on two reflectors (Fatha and Jeribi) Formations which
belong to Lower and Middle Miocene age. The reflectors were picked and identified
by tying them directly to well Khashim Al-Ahmer-2, the Lower Fars(Fatha
Formation) reflector was picked at TWT ranging from (0.3-1.7) sec while the Jeribi
reflector was picked at TWT ranging from (0.83- 2) sec. The depth map showed that
the depth of the Jeribi Formation ranges between (1100 - 2000) m, and the velocity
maps of studied reflector showed increase of velocity values to the south east and
there is a local closure in the north east of the study area and decrease to the north
west and the velocity values decrease and give closure situated below well KA-
2.The magnitude of velocity values ranges in Jeribi velocity map from (3100 to 3400
m/sec). Seismic attributes techniques (instantaneous phase) is important to detect the
hydrocarbon accumulation on seismic sections. Major faults (reverse and thrust)
were picked along study area on instantaneous phase sections. These faults extend in
NW-SE trend and the displacement of the fault ranges between (400-660) m. The
velocity, time and depth maps were drawn by the aid of GeoFrame and petrel
software.
The estimation of rock petrophysical parameters is an essential matter to characterize any reservoir. This research deals with the evaluation of effective porosity (Pe), shale volume (Vsh) and water saturation (Sw) of reservoirs at Kumait and Dujalia fields, which were analyzed from well log and seismic data. The absolute acoustic impedance (AI) and relative acoustic impedance (RAI) were derived from a model which is based on the inversion of seismic 3-D post-stack data. NahrUmr formation’s sand reservoirs are identified by the RAI section of the study area. Nahr Umr sand-2 unit in Kumait field is the main reservoir; its delineation depends on the available well logs and AI sections information. The results of well logging i
... Show More
(3)
The Buzurgan oil field is one of the most important oil fields border in southern Iraq.
Adjacent to the Fauqi and Abu Ghirab oil fields common with Iran. The 3D seismic data showed the structural and stratigraphic of the Buzurgan oil field, where the results showed that the structure is an anticline fold with two structural domes separated by a saddle, the northern culmination is shallower and less deformation. Thirty-one faults were detected and most of them at the south part of the field which are small while the north faults are larger.
This thesis was aimed to study gas hydrates in terms of their equilibrium conditions in bulk and their effects on sedimentary rocks. The hydrate equilibrium measurements for different gas mixtures containing CH4, CO2 and N2 were determined experimentally using the PVT sapphire cell equipment. We imaged CO2 hydrate distribution in sandstone, and investigated the hydrate morphology and cluster characteristics via μCT. Moreover, the effect of hydrate formation on the P-wave velocities of sandstone was investigated experimentally.
This study deals with interpretation of stratigraphic and structural of Afaq structure area central Iraq in Qadisiyah province, about 25 km north of Diwaniyah, by using 2D seismic data. Synthetic traces are prepared by using available data of the well (WK-1)using a petrol software program to define and picking the reflectors on the seismic section. Structure interpretation includes picking a top of Zubair Formation (Late Cretaceous), while stratigraphic interpretation includes two reflectors Yamama and Gotnia Formation (Upper-Late Jurassic). Structure interpretation of Zubair Formation shows that the area a several minors and a short extend of faults, the fault system extends (NE-SW) direction. The structural interpretation of time and d
... Show More
Seismic inversion technique is applied to 3D seismic data to predict porosity property for carbonate Yamama Formation (Early Cretaceous) in an area located in southern Iraq. A workflow is designed to guide the manual procedure of inversion process. The inversion use a Model Based Inversion technique to convert 3D seismic data into 3D acoustic impedance depending on low frequency model and well data is the first step in the inversion with statistical control for each inversion stage. Then, training the 3D acoustic impedance volume, seismic data and porosity wells data with multi attribute transforms to find the best statistical attribute that is suitable to invert the point direct measurement of porosity from well to 3D porosity distribut
... Show More
(6)
(4)
Electronic properties such as density of state, energy gap, HOMO (the highest occupied molecular orbital) level, LUMO (the lowest unoccupied molecular orbital) level and density of bonds, as well as spectroscopic properties like infrared (IR), Raman scattering, force constant, and reduced masses for coronene C24, reduced graphene oxide (rGO) C24O5and interaction between C24O5and NO2gas molecules were investigated. Density functional theory (DFT) with the exchange hybrid function B3LYP with 6-311G** basis sets through the Gaussian 09 W software program was used to do these calculations. Gaussian view 05 was em
... Show More
(4)
(1)
Land surface temperature (LST) is crucial for determining the region's environmental quality because a significant temperature rise causes disasters, which cause environmental imbalance, reducing biodiversity and hastening desertification. In this study, remote sensing and geographic information systems were used to estimate the change in the LST of Babylon, Iraq, using two satellite images taken 20 years apart (2002, 2022). The temperature was extracted using a specific mathematical model in ArcMap10.8 software. The findings demonstrated a significant variation in temperatures and the concentration in various regions of Babylon between 2002 and 2022 and the relationship between LST and Normalized difference
... Show More
(2)
An interpretive (structural and stratigraphic) study of the two,-dimensional seismic, data of East Nasiriya area (30 km to the south east of Nasiriya oil field within Thi-Qar province, southeastern Iraq) was carried out using Petrel 2017 program. The study area has an importance due to its location between many oil fields, but still without exploration of oil wells. Twenty five seismic lines were used, date back to different types of seismic surveys conducted in the region at different time periods. Also, the seismic velocity surveys of the nearest wells to oil fields, such as Nasiriya-1 and Subba-8, in addition to their sonic and density logs were used. A synthetic seismogram with a good matching with the seismic section was achie
... Show More
(1)
An integrated seismic sequence stratigraphy and facies analysis has been carried out with a view to understanding the depositional environment and stratal stacking pattern of Nandy Field of Niger Delta. Well logs and biostratigraphic information were used to identify the lithologies, stratal stacking patterns, stratigraphic surfaces, system tracts and reservoir potentials of the field. Seismic sequence stratigraphy and seismic reflection patterns were used to identify the seismic facies. Facies-related attributes were employed to identify the continuity and amplitude of seismic events. Three seismic facies packages and three reservoir sands were identified. The environments of deposition of the area consist of marginal marine to continen
... Show More