In the present work, heterojunction diode detectors will be prepared using germanium wafers as a substrate material and 200 nm tin sulfide thickness will be evaporated by using thermal evaporation method as thin film on the substrate. Nd:YAG laser (λ=532 nm) with different energy densities (5.66 J/cm2 and 11.32 J/cm2) is used to diffuse the SnS inside the surface of the germanium samples with 10 laser shots in different environments (vacuum and distilled water). I-V characteristics in the dark illumination, C-V characteristics, transmission measurements, spectral responsivity and quantum efficiency were investigated at 300K. The C-V measurements have shown that the heterojunction were of abrupt type and the maximum value of build-in potential is equal to 1.78V in water environment .The results showed that the detectors have two peaks at 900 nm and 1250 nm and the maximum spectral responsivity can be obtained at λ=1250 nm in water environment. Also the quantum efficiency has two peaks at 900nm and 1250 nm and it is increase the increase in laser energy density and this increase is to be clear in the water environment more than the vacuum environment.
This paper calculated the Duration Magnitude (MD) equation using data from the Iraqi Meteorological Organization and seismology (IMOS). It is an empirically determined equation and expressed as:
The epicentral distance and local geological conditions affect the duration of the coda. The data is obtained from 7 seismic stations in the network. The new proposed duration magnitude equation results from applying linear regression analysis to the data of a seismic signal duration with correlation coefficient R2=0.76; and a standard deviation value of 0.049. Station corrections indicated by Sc are also specified for the seismic stations that range from -0.024 to + 0.02.
(1)
Acrylic polymer/cement nanocomposites in dark and light colors have been developed for coating floors and swimming pools. This work aims to emphasize the effect of cement filling on the mechanical parameters, thermal stability, and wettability of acrylic polymer. The preparation was carried out using the casting method from acrylic polymer coating solution, which was added to cement nanoparticles (65 nm) with weight concentrations of (0, 1, 2, 4, and 8 wt%) to achieve high-quality specifications and good adhesion. Maximum impact strength and Hardness shore A were observed at cement ratios of 2 wt% and 4 wt%, respectively. Changing the filling ratio has a significant effect on the strain of the nanocomposites. The contact angle was i
... Show More
(7)
(7)
(5)
(5)
(38)
(45)
(9)
(6)
(25)
(25)
Herein, the interfacial polymerization method has been used for the synthesis of PPy/NaVO3 composites with different compositions of NaVO3 (10 %, 20 %, 30 %, 40 % and 50 %) as an efficient electrode material for supercapacitors. The successful formation and composition of the as-prepared composites (PV1-PV5) were confirmed by FTIR, XRD, EDX, and SEM analysis. The electrochemical properties were investigated by cyclic voltammetry (CV), galvanometric charge–discharge measurement (GCD), and electrochemical impedance spectroscopy (EIS) in 0.5 M H2SO4 electrolyte. As compared to other, the PV4 composite exhibit excellent specific capacitance of 391 F g−1 at a current density of 0.75 A/g with good cycling stability of ∼59 % after 1000 cycle
... Show More
(7)
(9)
The antibacterial activity of Capparis spinosa L. extracts obtained from Baghdad was evaluated against six clinical bacteria isolates of Helicobacter pylori. The results presented in this work demonstrated that the leaves extract showed a significant effect against bacteria as compared to the root and fruit extracts at 100 mg/ml concentration, with inhibition zone ranging from 12.0 to 30.7 mm in each bacteria strain. The end results of GC-MS analysis indicated that the ethanol extracts of caper have a lot of active chemical compounds, including twenty-five, eighty-two and sixty-eight phytoconstituent compounds, that are distinguished in the extracts of roots, leaves and fruits with C. spinosa L. respectively. I
... Show More
(4)
(2)
(106)
(101)
(10)
(6)